0
Dodge Durango
The Dodge Durango was a full size SUV (sport utility vehicle) manufactured by Chrysler for the Dodge brand. Produced in the company’s assembly plant in Newark, Delaware, this 8-passenger vehicle was initially powered by a 5.9 liter Magnum V8 engine.
3,297 Questions
2006 dodge durango camshaft position sensor location?
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
Can a 1999 5.2 Dodge engine fit in a 2000 Dodge durango equiped with a 4.7 L engine?
Not easily. The 5.2 and 4.7 use different transmissions.
Can you plow with a Dodge Durango?
The dealer that I work at has a snow plow on a 2000 Dodge Durango. It isn't the best vehicle as a snow plow but it works.
What is the towing capacity of a 2001 Dodge Durango 5.4 Liter?
They didn't have a 5.4 liter.
Towing Capacity
4.7 liter V-8 6,050#
5.7 liter V-8 7,600#
Where is the fuse box located on a 1999 dodge durango?
There are two fuse boxes one under the hook on the right hand side towards the back. the other is located in between the drivers side door an d dash board look closes and pull the cover off. These fuse control things inside the durango like radio, lights etc.
How do you replace the water pump on a 1991 Mazda B2200?
This replacement of the water pump requires you to remove the timing belt to access and replace the water pump.In short the timing belt runs the water pump.And in order to do this requires removing the air charge pipes,both upper and lower timing cover,the fan clutch assembly,and fan shroud for room.You also have to drain the coolant and ensure the number 1 is in alignment with the raised arrow at the camshaft and the the notch at the crankshaft is lined up perfect with the mark on the crankshaft gear.This is not a novice job and even ifa manual can help I would suggest going to a shop if you are not mechanically inclined to do it.There are some steps I left off but,with a short version this should help you better understand the time,knowledge of taking on this task which is not easy even though this engine is pretty simple overall.
Where is the radiator drainage petcock on a 1994 Chevrolet Blazer?
The drain plug is located on the driver side, bottom corner of the radiator, facing the engine. Use a pair of biscripts or plyers to GENTLY remove it. Here is a strange tip that works if you are flushing your radiator: Use Palmolive automatic dishwashing detergent instead of flush cleaner. It will neutralize more rust and leave your radiator cleaner. Just remember to run enough water though it that there are not any bubbles left in the radiator or flush water.
Where is the camshaft position sensor located on a 2001 Hyundai Sonata4 cylinder?
under the timing cover
How do you replace the air filter on 2002 ford focus SE?
Under the hood on Drivers side, remove the two clips and take out old filter. I then blew the access dust out and replaced with new filter, carefully lining the filter up so the clips pop back on easily, don't force them back on.
Where is the PCV valve located on a 2005 dodge ram with a 5.7 hemi?
On the intake manifold, passengers side, by the throttle body. It screws in like a little oil cap. There is no hose attached.
Just below the passenger side door, along the outside edge of the bottom of your Miata, you'll find a seam where the sheet metal meets and has been welded together. Upon careful examination along the length of that seam, you'll find at least two small spots where the sheets of metal flair apart wide enough for coat hanger wire to slip inside. These holes are meant to drain the water that can collect in the body of your Miata after a hard rain. They can easily become clogged with dirt. To clear them, straighten out a coat hanger and gently slide one end into the hole about three inches to clear the obstruction. If water is currently sloshing around in the body, it should immediately begin to stream out.
Where do you add refrigerant on a 2000 Chevy Malibu?
The port is located in a real tight spot between the rear left side of the engine and the firewall. You need to unscrew the plastic cap and use a longer hose then the ones that usually come with the gas. Make sure you wear a long sleeve sweater or something because if the car has been running you could get burned by the engine, alternator etc. It is very tight back there and you will probably lose gas as you try to push the fitting on and off. Better left to a shop that knows what they are doing. No I don't work in a shop nor am I a mechanic. I just charged my car and yes I did get burned and cut and all that. Good Luck!
How do you seal a leaking pto gearbox?
Some gearboxes on pto driven attachments may leak around the seal due to pressure buildup during use. A small brass draincock NPT threaded can be substituted for any plug that is horizontal and at or above fill level. The advantage of the drain over a drilled hole with a cotter pin in it is that you can close the hole during periods of non-use, miinimizing contamination opportunities to enginer hours only.
While the pressure may not provide a constant back-effect to infiltration while the drain throttle is open, the design alone provides some protection against constrant infiltration of matter.
First off your 2005 Dodge A/C system does not contain any Freon. It contains R134. Freon has not been used since 1995. Secondly you should not add refrigerant until the leak is repaired. Once it is repaired the system should be recharged by a professional with the proper tools and gauges.
Where is the engine computer located on a 2002 Dodge Durango?
It is under the hood, on the passenger side of the firewall.
How wide is the 2005 Dodge Durango?
The 2005 Dodge Durango is 6 ft. 4 in. (76 in.)1 one-touch power windows wide.
Where is starter reset button located at on 2003 Dodge Durango sxt sport?
A 2003 Dodge Durango does not have a reset button.
How do you remove the headlight cover to change the bulb on a 2001 Dodge Durango?
There is one small hex/torq bit screw, i believe on fender side of the headlight toward the top. just take out that one screw and the headlight should slide out of the rails that they are on.
Where is heater blower located on 2000 durango?
It should be located on the passenger side floorboard well, just below the glove box area
How do you do a tuneup on a 1999 Dodge Durango?
Change the sparkplugs,plug wires, distributor cap, rotor,pcv valve and possibly the air filter if it is bad.
Where is the fuse for keyless entry on 2003 dodge durango?
you have to take of the dashboard and it is either to your left or your right but probably left but i don't work on dodges i work on cheavy so if it is not there you are going to have to contact a dodge car dealership, .......... i have alot of experience but i am only 13 so if you don't trust me i would call but trust me my dad is a engineier
How do you replace the water pump on a 1993 Ford Probe?
It's rather involved. You'll have to remove the timing belt. Experienced Probe owners recommend replacing the water pump and the timing belt and timing belt tensioner at the same time, to save the hassle of doing the same work twice.
On the 2.0 DOHC engine, I changed my water pump without taking the timing belt off. It's easier with better tools, but can be done. The time belt front plastic cover needs to be taken off and the idler pulley for the timing belt need to be taken off so it's out of the way, and the airpump needs to be out out the way. Worked for me.
For 93 GT w/ 2.5 V6 Remove both side motor mounts on the fender wells and remove the bolt from the crossmember motor mount, jack up the engine, remove timing belt covers(to do this you must take off both your belts remove the tensioner at the side of the engine, and the water pump pulley;if you remove the pulley first it will eliminate the hassle of the belt tensioner at the bottom of the engine)locate the bolts remove;installation reverse(hint: use alittle gasket sealer to hold gasket in place, but do not over do you need very, very little)
KRUEZ
