Ford Aspire

If you have a v-6 engine the starter is located on the left side bottom of the engine and it is a job to change out. You will have to remove the cross member, the left side engine mount and jack the engine up as high as you can to remove and replace the starter... GOOD LUCK...

The fuel pump is in the fuel tank as on all modern vehicles, and you'll have to remove the fuel tank to access it.

i believe the relay is on the drivers side behind the headlightby the inside of the fender in front of the fuse box there should be a bunch of wires there. at least that's where mine was on my 95 aspire. you can turn your headlights on and pull the fuse for your headlights and puit it back in and it should still click and just keep doing that until u find it. but im sure its right in front of the fuse box under your hood(right behind the driver headlight) i was working on mine today.

It is one of the three relays under the dashboard, adjacent to the brake or clutch pedal. That is where it is located on the 1994 Aspire.

I believe it is one of the three relays under the dash, and adjacent to the clutch pedal or brake pedal if you have an automatic transmission. Assuming it's the same as a 94 ford aspire.

It may be in gear but you have a broken CV joint. Check the boot on the joint to see if it's torn or cut. If it is then jack up the front end and hold the big part of the joint right by the wheel and turn the small shaft if they turn seperatly then the joint is broken and your car will not move.

I don't know of anyone that fixes them per se, but you can go to a bone yard and try to find a good one that way. It's a lot cheaper than trying to buy a new one. But make sure that the bone yard you use has a return policy, that way if the one that you get from them is bad you can get another one.

One can purchase Ford Aspire Spider gears directly through the Ford dealership. These parts can also be purchased at auto part stores.

With engine oil filter change , the ( 1996 Ford Aspire ) takes ( 3.6 quarts )

Well good grief! There are more than 1,000 bolts on the thing. Which ones are you talking about?

Yes

no

Trouble code P0170 means:Fuel trim malfunction (Bank 1)

Differential

60,000 miles

Open the drivers door and on the latch pillar you will see an information

sticker . One of the things it shows is the original size of tires on the

vehicle from the factory

The 1995 Ford Aspire is equipped with a 1.3-liter inline-4 engine, designated as the B3 engine. This engine features a DOHC design, a multi-point fuel injection system, and produces approximately 63 horsepower. Key components of the engine diagram include the cylinder head, intake and exhaust manifolds, timing belt, and various sensors for fuel and air management. The engine is mounted transversely in the front of the vehicle, contributing to its compact design and fuel efficiency.

According to one of Fords websites :

For a 1996 Ford Aspire , 1.3 liter / 81 cubic inch four cylinder engine :

Motorcraft AGS32C ( SP-436 ) spark plugs

* copper / gapped at .044 inch

what are my carrer aspirations how do i want to involve and changed

Standing in the front of engine, it will be on the left rear side of the engine.

Back by the fire wall.

First, Take off the front tire. then remove the brake caliper, remove the brake disc, undo the bolts connecting the strut to the lower control arm, undo the bolts under the hood and remove. use spring compressors to get new one on and do the rest in reverse order.

yes

it goes to the loo to have a wee