answersLogoWhite

0

Ford Bronco XLT

The Bronco XLT is one of the three models available for the 1996 Ford Bronco; the other two were XL and Eddie Bauer. The Bronco XLT features anti-lock brake system, a full-size spare tire and a driver airbag.

2,925 Questions

Where is the flasher unit on frontera 1993?

In the drivers footwell attached to the side of the car. It will be a 4 or 3 connector version.

Hope this helps.

Paul.

Weres the temperature sensor on a 1989 ford bronco 5.8 liter?

I have a 1995 bronco and the sensor is located to the right of the distributor. It has only one wire running to it. Mine is a 5.8 as well. I'd imagine the location is the same on the '89 model.

What does e40d do?

Basically the E4OD transmission is an electronic 4 speed transmission with overdrive.

Do you have to pull the motor in a 1994 S-10 to get the oil pan off?

You have to remove the main bolts from both side motor mounts and lift motor up high enough to clear .

How do you shut off a car if the key ignition won't turn off?

You can disconect the battery, which i wouldn't recommend. This means the engine is still spinning, and might still be drawing fuel, but it wont be using the fuel. This will either break something outright, or eventualy lock the engine, where you will be unable to turn it over. I would recommend that you put the car in Neutral, hold the brakes, and simply let the engine idle away the gas. Or you can do something to interrupt the flow of gas, IE put a really big clamp on the fuel line so that it runs out of fuel and stops spinning. NEVER YANK THE FUEL LINE OUT! you will get sprayed with gas as the pressure equalizes, and you will look really dumb at the ER when they ask how you messed up your eyes. Then get it to a mechanic as soon as possible, because that is going to be a really big electrical problem.

Where is the IAT sensor on a 1988 Silverado 57 EFI and where are the ECU wires to hook your module on?

The IAT sensor is probably on the throttle body and you hook you module to the dianostics connector just under the driver side of the dash.

How do you remove a pollution pump from a 89 caprice?

unbolt and remove pump.plug/remove hoses as necessary to eliminate exhaust noise.remove drive belt.e sure to plug vacuum hoses.