0
Ford Excursion XLT
The Ford Excursion XLT is another variant of the full-size SUV Ford Excursion. Some of its features are optional Reverse Sensing System, floor console, and dual cup holders for front and rear passengers. This vehicle can accommodate up to nine passengers.
419 Questions
Can you fit a 1982 Chevy 6.2 liter diesel into a 1997 Chevy 1500?
What engine does the '97 currently have in it?
I am currently putting a 6.5 into a 1982 that originally had a 6.2 in it, the engine and and mountings are the same. Don't know if that helps you.
If the 97 had a 6.5 then I would say it will fit but there are a lot of electrical differences between them.
mike g
How do you remove fuel pump from inside the tank on a 2000 ford excursion?
After removal of fuel tank, disconnect all lines & electrical connections, then remove retainer ring to allow access to inside the tank. Once inside, you will find two clips on the side of the fuel pump canister. Squeeze clips at the top to release from the bracket and lift entire canister, along with float out of the tank.
Is a 100000 miles a lot for a 300 rx Lexus?
No if the service has been done these are excellent cars until long after 100K have you not seen the Toyota commercial with the little pickups? some had way over 200K and still working like champs. Lexus are Toyota products and we can expect the same from them. My RX 300 has over 104K and BB was still like 8K I call that value!
How do you reset the keyless entry keypad 1994 Mercury Cougar XR7?
im the one asking the question because i dont know how to do it. how van i contribute to the answer?
What causes a shimmy in the front of your 2003 ford excursion?
I have a 2003 diesel Excursion and had a vibration in the front also. After inspection i found it was the driver side drag link that connects middle way of the vechicle to the pitman arm. this solved my problem and hopfully your's. it was $185.00 at my local ford dealer
What kind of transmission fluid can you put in your Kia spectra5?
Use only Diamond SP III available at any KIA, Hyundai or Mitsubishi dealer. There is a new Castrol Multi for foreign cars, but KIA is not accepting it as equivalent to the above fluid. Your WARRANTY WILL NOT BE HONORED IF YOU USE ANYTHING ELSE. Do not use Dexron or Ford either.
What happens if you put too much transmission fluid in your car?
it foams..can damage...don't...drain and fill to correct level
How do you test glow plugs on a 6.0 liter?
The best way that I have found to test the glow plugs on anything is with a simple ohm meter. If your meter says ol, (open line) they are completely dead but looking up the ohm value or contacting your dealer and comparing numbers from what they say and what your meter says is the best way. You should have a tolerance to be between. If you Are not there, odds are its bad
How do you chamge hood lift support on my 1999 Lexus rx 300?
There are clips at each end of the support that you need to remove, then they come right off. It is good to have a helper to hold the hood while you do this, or at least prop the hood up with a stick or something.
How do you restart a ford excursion after running out of gas?
Simply add fuel to the tank, then cycle the ignition key a few times to forward position without engaging the starter and then it should start fine, assuming that the fuel pump is functioning properly and that the fuel shut off has not been activated. I beleve the fuel shutoff/reset is behind the front passenger kick panel.
Why does the 2005 ford excursion keep losing power?
If all else seems fine, could be restricted converter which will get bad enough to where it won't start at all.
Where is the turn signal flasher on a 2000 Ford Excursion?
it sits behind the center panel closer to the driver side. Approximatly at knee height when sitting in the driver seat. It is coverd by a black plastic cover which needs to be removed to gain access to the the flasher.
Where is the fuel cutout inertia switch for a 2000 Ford E-150?
For a 2000 Ford E-150 :
The fuel pump shut off switch ( inertia switch ) is in the front passenger
footwell behind the kick panel ( the interior trim panel , just in front of the
door by the passengers right foot )
How do you take apart ball joints on a 2000 ford excursion?
Use a ball joint seperator, basically a wedge with a void in the center to allow for the tapered shaft that is in the ball joint. I have had to use two wedges and sometimes 4lb hammers but the seperator is fairly inexpensive and it makes it a lot easier. You can purchase them in different sizes at most auto parts stores.
What size is the gas tank in a Ford Excursion?
A 2005 Ford Excursion has a 44 U.S. gallon tank ( 166.4 liters )
How much does it cost to fill up a large SUV?
I have a 2000 Ford Excursion with a V-10 and it takes $120.00 to fill it at $2.65 a gallon. I Get About 520 Miles to a tank with mostly in town driving.
Installation of glow plug cylinder 3 for 2002 Ford Excursion 7.3L V8 diesel?
Cyl #3 is right side (passenger side) head 2nd one back from front. Right head cyl # is 1,3,5,7 and left is 2,4,6,8. Remove the valve cover and the connector to the glow plug. Using a 10mm deep socket and wrench loosen and remove. Install new one and reassemble. Don't forget to connect the one wire connector to the plug before putting the valve cover back on.
Do you have a diagram showing where cylinder 2 is on my 2001 ford excursion?
5.4 L - V8 engine firewall 4 - 8 3 - 7 2 - 6 1 - 5 front --------------------------------- 6.8 L - V10 engine firewall 5 - 10 4 - 9 3 - 8 2 - 7 1 - 6 front
How much is a new alternator for a ford excursion?
Autozone has hen for 250.
Not sure if that is the diretion you want to go. I have a bad one and am shopping it around for someone to rebuild them instead.
Where is a 2000 Taurus door lock relay?
Ford shop manuals for the 2000 and 2001 Taurus and Mercury Sable are oddly ambiguous about the location of this relay. The door lock relay for a 2000 Taurus (also 2000 Sable) is part number FOAZ-14N089A. The shop manual diagram 501-14-00-4, clearly labels the Door Lock Relay (K130), as well as the Door Unlock Relay (K129) and Driver Door Relay (K131), as being located in the Central Junction Box (CJB). A technician familiar with Ford electrical swears the relays are located in a block next to the GEM (Generic Electronic Module) assembly, which is behind the Central Junction Box (CJB). The CJB for these vehicles is essentially the fuse box located under the dash to the right of the brake pedal (between the brake pedal and hood release). Confusion comes from there being no reference to either Door Relay type inside the fuse box, as depicted in owners manual. However, in the shop manual diagram for CJB fuses, relays, etc., there are a number of relays that are not labled as to their purpose/function. Based on the problem the poster was experiencing, a troubleshooting help is: there are only those 3 relays, the GEM module, and a Door Lock Actuator for each door comprising the entire power door lock function.
NOTE: If any individual door works by pressing the power lock/unlock or keyless entry button (if installed), then the problem is not a relay! It's either a faulty actuator, or wire corrosion of the wires under the carpet leading to the driver's side door electronics. If all doors misbehaving, then the relays are in play for culprits.
I found the door lock relay, on our 2000 Taurus, inside the fuse block under the dash. After removing all the wiring connections, pulling out the fuse block, removing the fuses and relays, and then finally prying apart the fuse box I found the relay. However, to change this relay out, will require to un-solder numerous connections before even attempting to remove the relay. The relay on this board is listed as OMRON XWFR-CA 0960A13A.Where is the fuel pump inertia shutoff switch on a ford excursion?
According to the ( 2004 ) Ford Exursion Owner Guide :
The fuel pump shut off switch ( inertia switch ) is located in the front
passenger foot well , behind the kick panel access panel
What kind of transmission fluid do you put in a 2005 Nissan Sentra 1.8 liter?
It is a special oil {{ Madeic D}}
How much to install serpentine belt?
Free if you do it yourself, guides on the internet will help you out if you take it to a shop you can end up spending probably around 50 dollars Canadian although some places charge a minimum 1 hour labor charge which would be around 100 dollars.
