0
Honda Accord
The Honda Accord series is a family of medium-sized cars produced by Honda from 1976 to the present. It was launched as a 1600cc engine-powered mid-sized hatchback sedan, with design similar to an upgraded modern Honda Civic.
5,977 Questions
What is the fuse location and number for the horn on a 1999 Honda Accord 4-cyl coupe?
Mine is a 1999 Accord V6 coupe and I don't think there's a horn fuse. There is a horn relay under the hood in the back left in a black plastic box. On mine there are 3 identical relays (2 for headlights and 1 for the horn). If the 4-cylinder has the same arrangement as the V6 you could switch the relays to see if that was the problem.
What does it mean when the maintenance light button turns on in a 2002 Honda Accord?
Usually it is pre programmed for oil changes and routine maintenance.
Can you put 20 inch rims on a Honda accord?
You can put any size rim on any size car if you would like, however, is it practical!? It will depend on the year of the car. Newer Accords have large fender wells allowing for larger diameter rims. Bigger the rim, thinner the tire....visa versa. Look at the road conditions of where you live. If you have potholes everywhere..you'll destroy big rims with small tires. Bigger size wheels may cause tire rub when turning, especially when backing up. Ride comfort will most likely decrease as well your transmission may have future problems caused by the additional rotating mass(weight of wheels) it must endure. Go with 18's max on early and mid 90's models and you could comfortably fit a 205/35-20inch tire wheel combo on newer models, '97 on up.
How do you remove a door panel on a 1997 Honda Accord?
FISRT START WITH THE DOOR HANDLE ( THERE SHOULD BE A METAL ROD WHICH OPENS THE SOOR AND A THE PLUG BEHIND THE HANDLE IF YOU GOT POWER WINDOWS) THE TAKE OFF THE PLASTIC PIECE COVERING THE OUTSIDE MIRROR(LETS SAY YOUR DOING THE DIVER SIDE IT WILL BE LOCATED ON THE TOP RIGHT OF THE DOOR IT JUST PULLS OFF) THEN FIND A SPOT WHERE YOU CAN FIT YOUR FINGERS ON THE BACK PART OF THE DOOR PANEL AND PULL. THE AREA YOU ARE PULLING SHOULD POP UP THEN RUN YOU FINGERS FURTHER DOWN UNTIL YOU GET ALL AROUND THE DOOR PANEL. JOSE
Where could gas smell be coming from in my 1993 honda accord?
It is obvious you have a gas leak. Use your nose to locate the general area of the leak. Once you narrow it down then you just have to search and find what is leaking.
How do you replace the front signal bulb in the bumper on a Honda Accord?
If its for the 90s models its just a screw in the inner side of the light housing on the bumper.
See sources and related links below for bulb information.
What is the EGR valve on a Honda Accord?
The EGR Valve is an emission regulation valve or Exhaust Gas Recirculation valve is the full name. What it does is recycle the exhaust output back through the engine. It is designed to reduce emissions into the atmosphere. The effect it has on your car? A negative one, this valve (when operational) decreases performance and over time increases carbon deposits within the engine itself (which is obviously not good for it) I have blocked the EGR valve in my Honda permanently by welding it shut (you can also buy blocking kits) The performance of my car increased immediately, however you do have to put up with a permanent Engine check light.
How often to change coolant on a Honda Accord?
Every 50,000 miles or 5 years.
Read your owners manual maintenance schedule.
Why would a Lexus power window go up but come down about half way and wont stay up?
THAT MEANS THAT THE WINDOW IS NOT INITALIZED AND TO DO THAT YOU NEED HOLD THE WINDOW SWITCH ALL THE WAY UP AND HOLD IT THERE FOR A FEW SECONDS THEN PUT THE WINDOW DOWN AND HOLD THE SWITCH DOWN FOR A COUPLE SECONDS AND THEN IT SHOULD BE OK
How many horsepower does the engine in the 2002 Honda Accord have?
The 2002 Honda Accord's engine produces 135 hp @ 5400 rpm.
What does it mean if the D4 transmission light is flashing on a Honda Accord?
ck this out!
that is correct, it is the tcu........if you go to the dealer or even to napa. you will end up paying from 800-1300.00. if you email me i will give some info that will blow your minde and save you at least 500.00 bucks.....its no joke. ive done it my self for my 90, 92, 93 accords. if you are mechanical inclin, this will be a simple fix. my email is: darrensrepair1@comcast.net
Your TCU needs replacing.
Answer #2, this one correct:
Your TCU does NOT need to be replaced. The TCU is telling you a problem that the transmission is having. This question about the flashing D4 light has already been answered multiple times here on WikiAnswers. Please do a search for this question and read the other answers.
2003 Honda Accord tire bolt pattern?
1990-1997 Honda Accord ALL - 4 x 114.3
1998-2002 Honda Accord 4Cyl - 4x114.3
1998-2002 Honda Accord 6Cyl - 5x114.3
2003-2010 Honda Accord ALL - 5x114.3
Where is the OBD port on 1996 Accent?
The 1996 Hyuandi Accent OBD 2 port is on lower edge of dash next to kick panel
The bulb is probably burned out. Try replacing the bulb for starters.
Srs light is on 95 accord need help?
There is a problem with the Supplemental Restraint System (SRS) otherwise know as the (Air Bags). This is not a DIY repair. Take it to a professional. Serious injury can occur when working with the SRS.
There is a problem with the Supplemental Restraint System (SRS) otherwise know as the (Air Bags). This is not a DIY repair. Take it to a professional. Serious injury can occur when working with the SRS.
Check to see if the stop lights are working--most use common circuit to control shift lock. If lights are not working check stop light fuse and switch.
Try turning the key to "1st" position (unlock) without starting vehicle, then shift to neutral to start. Might work as a temporary "fix"
How do you remove the plastic rivets on a Honda accord?
If you are asking about the exterior plastic rivets used to attach the inner fender liner or the bumper, for example, just take a flat head screwdriver and use it to gently pry out the interior piece of the rivet. Once the interior piece has been removed, then you can remove the outer piece without breaking it. If you do end up breaking some, they aren't too expensive to replace at places like clipsandfastners.com or thefastnerwarehouse.com. Just measure the diameter of the outer circumference of the faster, the diameter of the whole it came from, and the length of the stem to make sure you get the right replacement parts.
Good luck.
How do you fix vapor lock on 1987 Honda Accord?
Unscrew the gas cap and you'll see the gas filler flap. Put out your cigar and shove the flap open with a stick or something - you could just shove it with your finger but then your hand would smell like gas the rest of the day. Count to two, release the flap, screw the gas cap back on and you're done.
What are the sizes of windshield wiper blades on a 1996 Honda Accord?
The 1996 Honda Accord takes a 24" drivers side, 20" passenger side and a 14" or 15" rear wiper (wagon). See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
