Honda CR-V

Honda CR-V parts are very easy to find online. This includes sites like Auto Zone as well as sites for Junk yards that sell all types of car parts and pieces.

The gas tank on the 2013 Honda CR-V holds 15.3 gal..

Fuel filter is clogged - fuel injectors are faulty or clogged - fuel pump is failing. Also: I have seen extreme examples of combusion chamber carbon build-up causing this problem as well.

tienes un coche

cr2012429688

In the Haynes Manual it is identified as "Honda CVT Fluid" - I'm sure there is a commerical equivelant but you'd have to ask you local mechanic or auto parts store.

Its right in front of the radiator fan at the front, around the same size as an AA battery.

The 2005 Honda CR-V takes 4.4 quarts/liters, possibly a little less if you're not changing the oil filter.

after removing the dist. cap, the rotor will pry right off....if you are having ignition trouble from the coil or igniter, there is a HEI conversion that can be found at http://www.cardomain.com/ride/633391/8

it looks very interesting, and i will be trying it this summer when it gets warm.

It is located exiting the lower right front corner of the cabin circulating fan housing. If you suspect it is plugged - remove it and insert a stiff but flexible wire down it to push out any obstructions.

What year? The Honda CR-V has undergone several modifications, updates, and modernizing over the lifespan of this model.

For more specific information see the below link:

tire monitornng pressure system

If you are certain that it is an electrical problem, the next things you might try would be replace the spark plugs, ignition wires, and have the distributor checked out.

Have you considered the fact that the problem may be fuel related rather than electrical? Is the fuel filter clogged and in need of replacement? Or, the fuel pump is failing, or that dirty fuel injectors are inhibiting the flow of gas to the cylinders?

Try this site:

http://www.autotalk.com/how-to/honda-cr-v/honda-cr-v-97-04-keyless-remote-programming-instructions.html

-Jeff

I believe that all OBD-related equipment these days is "universal."

I think you are actually asking what it costs to REPLACE the timing belt. The cost of the belt itself is not the big expense. The labor to partially disassemble the front of the engine and get to it is where the expense comes in. The cost of labor and materials vary too much around the country to make any estimate other than to say it's going to cost you several hundreds of dollars. The best thing to do would be to contact your local Honda dealer and ask.

I have a 99 Cr-v so they might be the same. I took a pair of pliers and squeezed them from the underside of the hood and just push up. The plastic flares out to keep them in place. Real easy. I have a 99 Cr-v so they might be the same. I took a pair of pliers and squeezed them from the underside of the hood and just push up. The plastic flares out to keep them in place. Real easy.

Which bulb?

Mr. Rogers from his neighborhood.

With a broad bladed screwdriver or putty knife - VERY CAREFULLY. The older they are the more likely they are to break.

CR Brands was created in 2006.

From your description it sounds as if your front struts (shock absorbers) are worn out and in need of replacement.

Some people claim to find 5 digit radio codes inside the glove box, inside the drivers door, in the owners manual...but I didn't finds any codes pasted anywhere.

I needed to locate the serial number of my unit and go to my Honda dealer with proof of ownership. It is on a sticker at the bottom of the radio about 2 inches back of the face place of the radio.

To pull out enough to read the serial number:

Remove the glove box screws and set glove box aside. Starting with the screw facing the door on the passenger side of the dash, remove the rest of the screws and pull to release tabs. Remove the small trim piece at the bottom of the center stack (4 screws). With these trim pieces pulled away, the hidden screws in the center stack are revealed. Unscrew these along with the visible screws. Remove the screws in the trim piece above the drivers knees, and pull away. Remove hidden screws from center stack trim and pull away. Uncouple the connecting harness for the cigarette lighter and climate controls. The center stack cover can pull away. Like the other trim pieces, it may require a pull. The radio is connected by Phillips screws approx an inch back from the front, approximately the middle of the unit. There is an access hole to remove the screws on both sides. Pull out to read serial number, a second person with a flash light helps.

Steel or Aluminum.