1:2:4 i.e. i cement, 2 sand and 4 aggregate...
There was a recall on the fuel injectors on the M30's due to leakage. Just take it to a dealer and they will replace the injectors for free. You'll even get a loaner car while they work on yours.
use a flat head screw driver.
Yes you can use Regular Gas. However, it's been my experience that using Premium is best. You get better mpg and just an overall better driving experience.
While you could use 3/8", you may have difficulty applying sufficient torque therefore 1/2" is the best choice for all cars and small trucks. If you are dealing with an extremely large truck you might want to use 3/4".
If you have any mechanical experience, climb under and pull the starter out. It's very easy. however why are you doing this? Chances are you just need a new starter solenoid. Mine went out. It's located by the battery and autozone sells them for around $30.
The question needs more information like what its doing and the year, make and model would help as well..................
each of the 4 speakers has an amplifier built onto it.
Nothing really, Rust happens there is several ways to prevent it. Rust around lug nuts is normal.
No coolant in engine, Blown head gaskect, failed waterpump, cracked head or block. It's not a thermostat stuck closed, you'd have heat.
you can only tell by mileage. The timing belt needs to be replaced every 60k miles. Failure to do so can be a disaster to the engine. While your mechanic does this have him replace the water pump and temperature senser as well as these fail frequently and are easy to do when your "in there". All fan belts should be replaced too of course, since your in there.
The starter in a 1991 Nissan Sentra is located on the driver's side of the engine compartment. It is easily spotted down in the gap between the engine head and the air intake and battery areas... It looks like a fat cylinder at the top of the engine and transmission joining.
take off the black plastic cover an the air filter should just pull out. but i would go with the cold air intake!!!
Tuercas you can go to freetranslation.com or type that into google :D x
I own a M30 from what I understand it has a Steptronic Transmission which means that to shift gears you have to do it yourself with the gas pedal I found that best time to shift gears was around 3500 rpm's at that pt I release the gas and then wait for it to go down to about 1500 rpms or so and then reapply my ft and repeat... like a stick shift on training wheels I assume... If I am wrong will someone please correct me..