0
Isuzu Trooper
The Isuzu Trooper was a midsize SUV manufactured from 1981 to 2005. The Trooper had three generations: 1981-1991, 1992-1997 and 1998-2005. The first generation was basic and underpowered on- and off-road vehicle, while the succeeding generations were more refined and were available in two or four-wheel drive.
952 Questions
How do you bring a motor to top dead center with overhead cams?
pull #1 or front spark plug.
take cap off distributor.
on my 90 #1 is at about 4-5 o-clock
have some one put a finger over spark plug hole and tap the key till the compression blows from the cylinder.
you will probable pass it so turn your motor to line up on tdc.
the piston is on top on #1 and #4 just check the rotor to make sure your on #1
i dont know how they work, but i do know that why they would stop engaging is a few reasons,
1.not enough pressure from the slave
2.not enough lube for it to move ie. gears are frozen
3.water was gotten in and frozen the gears.
these are just a few of the problems the auto-locking hubs can have. would say put it on some jacks and see if it will enguage. as that is what i had to do to find out that mine didnt work. you can replace them with asini manual locking ones or warn manual locking or the superwinch ones. personally i like the superwinch, but many people will tell you asini is the only way to go, but good luck finding ones that are in decent shape to use and trust.
Where to find second hand engine for 1992 BMW 735i?
Bavarian Auto Recycling, Inc Rancho Cordova, CA 800.269.6580
Isuzu 320 V6 cam gear timing marks?
The cam gear timing marks for a Isuzu 320 V6 are located on the cam sprocket and the timing chain itself. The marks must be aligned with each other to ensure proper initial timing.
Can a catalytic converter cause the check engine light to go on in a 2001 Isuzu trooper?
Don't know about cat conv, but my EGR Valve just failed, I'm told a common problem on 3.5L 'Honda' engines; my light will be on until I can afford to replace the valve.
ECM
Does the valves clash when a timing belt breaks in a 1992 Isuzu trooper?
What you're talking about is an impact head, my 86 4 cylinder has one and I bent 3 valves. Didnt cost that much for parts and the head service charge was average for this area (70001) Don't know if the 93 is like that but I assume it is.
You should be able to tow it with no problems in neutral, considering it is a manual transmission. I would not think you need to do anything. But just to be on the safe side, I would recommend you contact an Isuzu dealer or look in your owner's manual to be sure.
No they are too small a company. After working at a Gm, Suzuki, Isuzu dealership I would recomend a Suzuki
What is the Head torque sequence Isuzu 1989 trooper 2.6?
First torque to 58 ft lb
Second torque to 72 ft lb
1-10 in order. Front side on Left side 7,3,2,6,10
Right side 8,4,1,5,9
This is facing the engine.
How to remove torque converter bolts off a 2000 izusu trooper?
There is a small access panel underneath that you must remove first in order to access the torque converter bolts. The panel is very small so a socket and wrench should be used. Bolts should be 17MM. Good luck!
I would assume it is made by Isuzu. Look on the door jamb at the placard. There will be listed the manufacture.
the power an winter mode switch gets corrosion an dirty.mostly from spilled drinks coffee cigerette ashes.causes a electrical short within the switch.just replace it with a new one
Where is the PCV valve located in a 1994 Isuzu trooper?
You can find the PCV valve, on the outside of the air cleaner housing. The PCV valve will be attached to the back of the housing.
Where is the crankshaft sensor on a 1994 Isuzu Trooper?
Crankshaft sensor on a 1994 Trooper is located behind the passenger side motor mount near the bottom of the engine. If you look behind the front passenger wheel and behind the suspension support, your can see the sensor and wire. It is a tight fit to remove it.
There are a couple of reasons why a 1986 Isuzu will not idle. One reason could be the oxygen sensor and another reason could be in the fuel system.
How do you find the timing belt mark on a 1995 Isuzu Trooper?
The belt itself is rubber and wouldn't have a mark. The mark is usually at the top of the engine and one on the upper belt gear that when they are facing one another means your on the money.
How do you remove or replace the side front light bulb on a Isuzu Trooper?
There is one Phillips head screw on the top of the asseembly, close to the headlight. Remove the screw, and there will be a ball and socket connection holding the assembly in place. Gently pull the top of the assembly toward the front of the truck. Then use a long screwdriver to gently pry the bottom toward the front of the truck. Keep alternating between the top and bottom, prying it a little at a time. Eventually, the unit will pop out.
Where is the fuel filter located on a 2001 Isuzu Trooper?
The fuel filter is located near the right rear wheel bolted to the chasis.
