0
Mazda RX-7
The RX-7 was a sports car manufactured by the Japanese carmaker Mazda between 1978 and 2002. It featured a twin-rotor, 1146 cc Wankel rotary engine and a front-midship, rear-wheel drive layout.
703 Questions
Where is the horn relay for a 1988 rx7 Mazda?
inside the CPU. the CPU is located under the dash right next to the circuit box. right next to the clutch pedal
As it pertains to the United States, the Mazda Rx-7's are street legal exept for States that have strict laws regarding emissions.
Ive had that problem. It seemed to be my intake system wasn't hooked up correctly (bought it with an after market system which was held with duct tape) Check air flow. See if the gate is opening correctly or it could be the airflow meter sensor. This is just a possibility. Good luck
Does fc3s 1987 rx7 T2 have power steering?
go look under the hood. if it has a pump similar to the A/C pump with hoses leading to your steering gear, then yes. if not, then no. pretty simple.
Keep in mind, this is a sports car, not a sedan, and it is picky about being properly warmed up. Be sure you warm it up fully before shutting it off. Shutting down a partly warmed engine is likely to flood it. You can test this by reading up on de-flooding techniques and when it doesn't want to start, go through the de-flooding technique and see if it fixes the problem.
Have you changed your fuel filter recently? If you can't remember, it is due anyway, so see if that improves things.
I have a 1988 RX7 w/ 68,000 miles. I had the same problem for a couple of years. My next change of spark plugs and air filter resolved it.
this guy gave you a nice cotton wool covered answer,if its hard to start its worn and will need a rebuild ,compression is low,when the oil is cold it is thick and allows a good seals boosting compression easily starting ,once warm oil is thin and wont pull the same trick,hense you leave it and it starts agian,or the thermostat is old engine runing hot and the oil is overheating causing it to be too thin creating early wear making the problem worse, all these loosers with the sports car story above, go the rotary, hope the hydrogen ones are cool luck bro
How does a turbo waste gate work?
A waste gate regulates the amount of exhaust gas that spins the internal turbine of a turbocharger based on a predetermined amount of pressure in the system to keep the turbo from continually building boost that is higher than the system can handle. When closed it allows the exhaust to pass over the turbine creating pressure on the cold side of the turbo. With the waste gate open it allows the gas to bypass the turbine stopping pressure buildup.
What is the average price of a Mazda RX7?
$2000 for a non turbo in great shape
and $4000 for a turbo in great shape
What is the V-belt setup diagram for an 1991 RX7?
Go to this link: http://www.cochran-racing.com/FSM/s5/01_engine.pdf then scroll down a little bit, you'll see the illustrations for the V-belts and how to adjust them.
Your rx7 series 8 has no cover on the fuse box how can you find which is the inicator fuse?
If your fuse box does not have a panel to show you what you are looking for (Why the heck it's like that is so stupid), then google "Fuse panel 88 RX7 diagram". You will find some there.
How can you tell when the egi fuse is bad on a 1988 Mazda rx7?
car will have a hard time starting, or more commonly will not start at all
If you have an 87 Mazda rx7 non turbo how can i make it a turbo without an engine swap?
Go to rx7club.com and create an account. Then use the search option on this topic. It has been covered time and time again. Plenty of info there on this.
Why will Mazda rx-7 not start?
there are WAY too many reasons to answer without any actual specific information here...what does it do, if anything? what happened to cause this?
Where is the differential fill plug on a 1986 Mazda rx7?
The fill plug is on the end of the differential. To access this, you will need to crawl underneath your car, and lok at the middle of the axle. There are two plugs on the differential; a drain and a fill plug. The Fill plug is obviously the plug closer to the roof of the car.
check the cranck angle sensor in the front of engine if not working car never start
How do you unflood a 1994 Mazda rx7?
In order to unlood the RX7 u need to remove the EGI fuse in the fuse holder on the left hand side of the engine bay. then unplug the distributor loom. remove spark plugs. Keep the plug leads away from plug hole (fire risk). crank engine from 15 seconds let stand for 1 min and repeat 2-3 times. replace spark plugs, lead, EGI fuse and plug to dizzy. try to start engine when it fires keep the revs up around 2000 rpm for around 1 min. you may have to repeat the unflooding steps 2-3 times.
Which is the leading spark plug in 91 rx 7?
leading should be the bottom plugs. if you look on the engine there will be a L and a T next to the spark plug holes.L for leading T for trailing.
The Zip Code of Karachi is written below:
74200 is the zip code of Karachi.
Where is the fuse box in a Rx7 1989?
There are two separate fuse boxes in a 1989 RX-7. One is located in the engine compartment, on the driver's side, under a black cover. It contains the main fuses that control engine management, headlights, and other large electrical draws. The second fuse box is under the driver's side dash board, also under a black cover. This contains the smaller fuses for all of the internals of the car, including the turn signals, radio, cigar lighter, and internal lights.
What antifreeze for Mazda rx-7?
50/50 ethylene glycol and distilled water just like pretty much every car.
