0
Mercury Villager
The Villager was a minivan manufactured by Ford Motor Company from 1993 to 2002, and was a rebadged version of the Nissan Quest. Designed by Moray Callum, the Villager featured a five-speed automatic transmission and a front engine, front-wheel drive layout.
1,605 Questions
O2 sensor problems with Mercury Villager?
If the o2 sensor is bad, replace it. If the sensors are activating the check engine light, then the codes should be checked. The catalytic converter could be blocked or the engine may not be running properly.
How do you fix seat belt retractor in 1995 mercury villager minivan?
These parts are only fixed by replacement.
A clicking sound when you try to start the car is a dead battery. It may be that the alternator is not charging it properly.
This is an involved procedure compared to the left shaft, but basically the same. The noise could be that the shaft was not fully seated in the transaxle. Or the washer was not put back in place at the outer stub. Did you use a new nut to attach the outer stub? The only other possibility is faulty new shaft bearings.
Why does the vehicle shut down on acceleration?
A vehicle can shut down on acceleration because of faulty or clogged injectors, a clogged catalytic converter, and a failing fuel pump. Other possibilities are a bad fuel sending unit, and a dirty fuel filter. The alternator is another thing that should be checked.
Where is the neutral safety switch on a 1994 Mercury Villager located?
It might be the transmission range selector
Location of front motor mount on 2000 mercury villager?
2000 Villager motor mount is located on the cross member dead center front of the vehicle. 2 bolts attached to the cross member pull out towards the alternator as well as the bolt through the mount itself. 17mm if I remember correctly.
How do you replace the air filter on a 1995 Villager?
There is no cabin air filter on a 1995 Villager.
Where under the dash is the flasher located on a 1987 Saab Turbo?
900 or 9000?
On the 900 (left-hand drive), the turn signal flasher is located just to the left of the steering wheel.
My wife drives a 1994 mercury villager with the same problem stalling while driving,hard to start,and fuel odor The first and easiest thing to do is pull the vacum hose off of the fuel pressure regulator this is the top one usally red from factory runs from top of the reg to the intake manifold if their is fuel in the hose you know that's it. Note No one carries this part in stock, and pretty difficult to get the back screw out. also the bottom return line is difficult to work with. Ford 169.95 Autozone 99.00 Napa 85.00 Advance Auto 65.00 RockAuto.com 55.00 ALL THE ABOVE HAD TO ORDER IT WHERE I LIVE. I did do myself it took about 3 hours,after I got the part that is,plan on replacing the vacum hose and return hose as well. Anyway fixed the problem: Wife is happy,kid's are safe,and I am broke.
How do you get to the connector for an O2 sensor after catalytic converter on a 97 Villager?
Excellent question. I don't have the answer, but perhaps someone else will. Had same difficulty. Wound up cutting the pig tail & splicing!
What controls blower on 2000 mercury villager Estate?
The blower is controlled by the blower switch, blower resistor, and relevant power relay.
When a timing belt on a 1999 mercury villager brakes will it hurt the valves?
In spite of what you might have heard, the engine in the Villager is NOT an interference engine, and the valves will not be damaged if the belt breaks.
The above answer is not correct when it comes to the 1999 model. The 3.0 L V6 in the 1993 to 1998 Villager is not an interference engine but, the 3.3 L V6 found in your 1999 Mercury Villager is definately an interference engine. If the belt breaks on the 3.3 L you will have engine damage. Replace the belt every 105,000 miles
I do not believe you are correct. These engines differ only in bore, the stroke is the same. I have it directly from the man who was engineering liaison with Nissan on the Villager platform. Ford specified that this engine could not be interference. My own testing implies that this is not an interference engine.
After some more research I am unsure and you may be right. It seems Ford may have redesigned the 3.3 L Nissan engine in the 1999 Villager so it would not be an interference engine. But Gates website lists it as an interference engine in it's newest application guide. So my recommendation is to not take any chances and just replace it every 105,000 miles.
How do you fix a speedometer on a 2000 Mercury Villager?
You would fix it by replacing the instrument cluster. The speedometer itself may not be faulty, it is more likely to be a problem with the speed sensor.
Where is the oil pump on a 2002 mercury villager?
Basically, it is behind the crankshaft pulley on the outside of the engine. To help visualize its' position, locate the oil filter mount. That is part of the oil pump. The timing belt, crank pulley, oil pan, and power steering pump must all be removed to gain access. Did you say you were thinking of replacing the timing belt anyway? Go for the water pump and belt tensioner too while you're at it.
Do you have to pull the fuel tank to replace the fuel pump on a 2001 alero?
Unfortunately, yes, you do. I had to do this with my '01. The fuel pump is a very expensive plastic assembly located inside the fuel tank.
Where is the Air intake sensor on your 1997 Nissan Pathfinder located how do you change it?
air intake sensor or air flow meter which measures the mass flow rate of intake air is located on the air cleaner assembly where the black intake hose connects to the box
Where is idle control valve in 96 Mercury villager?
The IAC valve is located on the top/rear of the air intake plenum beside the throttle cable. You will need to look under the cowl to see it.
What does a mechanic charge for a catalytic converter for a mercury villager?
The Villager has two converters. The whole front converter/pipe assembly sells for around $300 or so, (NON-California), the rear converter for around $150, also NON-California. Generic converters can be installed as well by welding them into the existing pipes, this should cost no more than $150 each. California models require different converters certified for that state, and may also have additional converters attached to the exhaust manifolds. These can be VERY expensive, up to $1000 each.
Where is vapor canister on 1995 mercury villager?
The EVAP canister is located near the brake master cylinder. It is about 5 inches in diameter and has three hoses attached to it.
Where is the air bleed valve for the heating system on a 99 Mercury Villager?
This vehicle does not have a bleed valve, it is not needed.
How do you know if oil pump is bad on a 2001 mercury villager?
Oil pumps don't normally wear out. If the oil pump is so worn that it cannot supply sufficient oil pressure, it's safe to assume the whole engine is worn out. Low oil pressure is usually the result of wear in the crankshaft, connecting rod, and cam bearings, not a worn oil pump. You wouldn't really notice any symptoms anyway, except low oil pressure and volume.
What is wrong when the front left brake caliper is sticking on a 1997 Mercury Villager?
Possible problem with the caliper, its slides, or collapsed hose. Check for ABS codes. Check that the ABS modulator is not holding pressure to the brake. Check for clogged line or junction. Also there is a check valve on the master cylinder which can hold pressure to both the front left and right rear brake. It is called a "dumping unit" in the diagram, but I have not found a use for it, or a proper explanation for why it is there.
What it is Mercury Villager 1998 spark plug gap?
Both the Owner Guide and fordparts.com show ( .034 inch ) spark plug gap for a 1998
Mercury Villager 3.0 liter V6 engine
