answersLogoWhite

0

Mitsubishi Mirage

The Mitsubishi Mirage was a car manufactured between 1978 and 2002. It was also marketed as the Mitsubishi Colt or Lancer Fiore. Five generations of this car were manufactured, all of which featured front-engine and front-wheel drive.

561 Questions

What is the wiring diagram of a 1999 Mitsubishi Mirage?

The service manual is available here http://pdftown.com/PDF-Mitsubishi-Mirage-1999-Service-Manual.html It's a free download if you accept the low bandwidth version of the service. Note: The password to unzip the pdf files is on the web page.

----

i need a

How do you replace a crankshaft sensor on a 1996 Legacy Subaru?

its right in the front middle of the engine/ unscrew the bolt and pull it strait up/ if it gets stuck in the hole you will have to use a drill and carefully poke holes in it and brake it apart then pull it out

How can you turn off the service engine soon light of Mitsubishi mirage 2000?

Disconnect your your battery for about 10 minutes. This should flush out the error. But you should know what causes the error in the first place.

Not sure on your exact model, never played with it... but since it's almost certainly OBD2 - you'll need a reader to plug in and it should have a 'clear error codes' button. HOWEVER - You must find out what is causing the light to trip (the same code reader should tell you) or it will just keep tripping. The scanners are about 130 bucks, but you maybe able to rent on from an auto repair place. Or have them scan it for you!

How to time a Mitsubishi mirage engine?

You'll need an inductive timing light. Connect to the battery, and clip the induction lead over the #1 spark plug wire. Start the car. The timing mark on the crankshaft pully will appear stationary when you point the light at it, and should correspond to the timing guage(mounted on the timing belt cover). Look on the emissions tag in the engine compartment to determine the correct setting. You'll need to loosen the nuts that hold the distributor , so you'll be able to rotate it. Watch your fingers, tie back your hair, and avoid loose fitting clothing! What year is your car, and what is the timing recommended on the emissions tag?

How do you remove and replace the PVC valve on a 1997 Mitsubishi Mirage?

The PVC valve is located on the driver side rear part of the valve cover. It is screwed into the cover with a black hose coming from it. You just need a wrench to un screw it. Don't cross thread the new one going back in. Thread in by hand to start.

How do the timing marks align on a 1997 1.2 Fiat Punto 60?

when looking at the cam pully standing at the right side you will see on the lleft of the pully a cut in the head that lines up whit the mark on the pully tha crankshaft marks are on the bellhousing and flywheel set that at tdc=0 Kevin odowd

How many miles can you go with gas light on?

The amount of miles one can go with the gas light on will vary depending on the car. Some cars may have a reserve of three miles worth of gas. Others may only have one mile worth of gas.

How do you check rpm?

Now lets see... It doesn't come with a tachometer clearly...So either you purchase a new one, hook it up to a engine management system,Or know where the rev limiter hits a go from ear for the rest of your life. The car is a beast for the most part. I have over 200K miles on mine,have ran it with little to no oil numerously & it still will hang with most older model jettas civic ects. I have a 1.5l. have been 117mph in it, Full on parallel E-Brake parked,Have gone around a turn fast enough for the back end to start coming around (55-65) Too sketchy at 65. Beached it. Trailed it. 93 octane,regular oil changes,head gaskets(2) on a count of high rpms. I'm sure the little thing will keep on chugging for another 200k.