0
Nissan Quest
The Nissan Quest is a minivan produced by Nissan since 1993. It was a successor to the Nissan Axxess and Nissan Vanette. The fourth-generation Nissan Quest features a continuously variable transmission and a 3.5L VQ series engine with 260hp.
792 Questions
I don't know the weather conditions where your car lives, but if it's cold enough you could be having trouble with fuel line icing. Small amounts of water can freeze in the fuel line, then fuel can't get through. That's only a problem if you live in parts of the country that freeze. If that's a possibility for your vehicle (freezing) get a can of fuel line deicer and run it through every time you fill up for a month or two. Water doesn't necessarily come from the gas station. As often as not, it comes from condensation INSIDE YOUR TANK.
How do you change front blower resistor for 2001 Nissan Quest?
below the dash on passenger side at the very right you'll see the blowing motor, just behind of it you'll see a two hex head screws, remove it and you'll have a PCB, just disconnect it and replace it. Advise: use 5/16" box scre driver.
Where is the low pressure AC port on a Nissan Quest?
on the front lefthand side if you are facing the engine standing at the bumper. It will be the silver hose with a black screwon top.
How do you align or aim the headlights on a Nissan Altima?
On models 1996 onwards (this might also apply to earlier models), there are vertical and horizontal alignment screws on the front part of the engine compartment. The position of these alignment screws, and the associated water level indicators that you can use to align the headlights are illustrated in the Nissan Altima Owner's Manual, which can be downloaded for free from Nissan's website at: http://www.nissan-techinfo.com/nissan/deptog.asp?dept%5Fid=40
How do you replace the air filter on a 1999 Nissan Quest?
black box on the driver's side of the engine compartment, behind the battery, has four latches you must unhook, then pry the filter box open and replace filter. There are several plastic tongue and groove slots you need to align when closing the box.
What is the front leg room in the 2012 Nissan Quest?
The 2012 Nissan Quest has 43.8 in. of front leg room.
What is the maximum payload of the 2007 Nissan Quest?
The maximum payload of the 2007 Nissan Quest is 1204 lbs..
How to replace rear driver side sliding door lock on a 2005 Nissan Quest?
how to replace a blown bulb behine my 99 quest speedometer
How hard is it to replace instrument panel lights on 1995 Nissan Quest?
# Disconnect the negative battery cable. # Apply the parking brake and block the rear wheels. # Turn the ignition switch to the OFF position. # Shift the gearshift lever to the 1position. # Position the steering wheel in the full-down position. # Remove the two instrument cluster bezel screws. # Separate the instrument cluster bezel from the instrument panel enough to gain access to the electrical connectors. Disconnect the following electrical connectors: # Rear window wiper/washer switch # Rear window defogger switch # Hazard warning flasher switch # Power E-AT switch, if equipped # Security indicator lamp, if equipped # Cruise control ON/OFF switch # Headlamp switch # Remove the instrument cluster bezel with the switches attached. # Remove the four instrument cluster screws and separate the instrument cluster from the instrument panel. # Position the cluster to gain access to the gearshift indicator. Remove the gearshift indicator from the cluster. # Disconnect the electrical connectors from the instrument cluster and remove the cluster. # The installation is the reverse of removal.
The titan and armada are created in Canton MS. Toured the factory when my titan was born. VERY nice.
Where is the knock sensor located in Nissan quest 2000 and how to replace it?
I AM GETTING A OBD CODE ERROR FOR MY 2000 NISSAN QUEST , PO141 AND PO325 ??? HOW DO I FIX IT..
Cost of rotors, or any part, depends on the make and model of car.
How do you replace 2004 Nissan Quest battery?
- Please read other answers on general battery replacement tips, since I'm just a weekend mechanic.
- I've read there is a battery memory saving device that goes into the power outlet to retain radio, navigation memory while the battery is being changed. I didn't use one. It might be important if you have navigation or anything else that will lose important memory.
- Spray off the white corrosive powder. Use baking soda to neutralize if necessary.
- Spray screws with WD-40.
- Remember it's a battery. Don't mistakenly connect the 2 terminals with a screwdriver or wrench.
- Negative connection first. Use 10mm wrench, loosen nut and wiggle the cable loose. Use a screwdriver to pry if necessary, it may take some force to get it to budge. Just push it aside.
- Repeat with positive connection. This is a large stiffer wire. Push it down and back underneath the air inlet tube.
- Loosen both nuts on the hold down bar that runs left to right. They are connected to 5" long "J" screws that just hook into a hole near the bottom of the battery. It will be obvious once you lift the battery out. Just let these long screws tilt toward you, or rotate them out of the hole they're hooked into.
- Remove the plastic "skirt" around the battery. It just lifts off but you'll have to maneuver it around some nearby items.
- Take out the battery. It's heavy.
- Look at the holes that the 5" long hooks fit into to, so you can find them later.
- Put in the new battery.
- Replace the plastic skirt around the battery.
- Push the battery all the way to one side and hook the 5" long screw back into its hole. Put it through the hold down bar and place a nut loosely on it.
- Repeat for the other hook screw.
- Tighten down the hold down bar.
- Replace and tighten positive terminal.
- Replace and tighten negative terminal.
- Cover terminals with Vaseline even though I think there's some real battery stuff you can use also.
- Reprogram your radio and seat memory buttons. i hope you were smart enough to write down your favorite channels.
Where is the radiator fan resistor located on a 99 Nissan Quest?
The 1999 Nissan Quest radiator fan resistor is attached to the back of the fan motor. The resistor should be labeled as such.
Why wont your cooling fans run on your 1998 town and country?
Check to see if you are getting power to fan motor with A/C or defroster on - if power fan motor bad If no power check fuse, relay and sensor
The rear blower of your nissan quest is not working?
The most likely reason is a bad circuit in the heat / A/C dash control. There's a way to check it - there are 2 12g wires that plug into the control unit. These complete the ground circuit that goes to the rear A/C fan relay. There should be continuity from the control unit when the rear a/c is switched on.
By jumping the two wires, the rear A/C will work with the controller circuit disconnected, but "off" must be selected or the fan will continue to run with the engine off.
Where can you find a vacuum hose diagram 89 GQ Nissan Patrol 4.2L?
I needed the same thing. I went to sale websites and looked for pics people had taken of their engines until I found what I needed.
What oil is used for high mileage for 2006 Nissan Quest?
SAE 5w30 any major brand of High Mileage oil.
What kind of oil do you use for your 2005 Nissan Quest?
Calls for 5W-30. Also recommends Synthetic Blend.
How do you change spark plugs in a Nissan Quest?
The good: Only three tool sizes needed
The bad: 7 hours and several band aids
I do like our How_to_replace_spark_plugs_on_2004_Nissan_Questbut not sure what they were thinking when they crammed in the engine with no way to easily change the plugs. I have worked on cars my entire life, rebuilt engines, replaced clutches and think of myself as fairly competent. This job humbled me.
With these instructions, plan on 4 hours.
Big picture. We will remove the intake manifold. It has three silver pieces:
1) the lowest part that feeds directly into the valves. We will leave that there.
2) the middle piece which is the part you see most of. We will completely remove that.
3) the back piece that connects the middle to the throttle. We will loosen that but leave it in place.
All directions (right and left) will be while looking toward the back of the How_to_replace_spark_plugs_on_2004_Nissan_Quest... so the driver would now sit on the right side for example.
First, start on the right (looking toward the back of the car) and remove all the black rubber air intake pipes (large pipes).
Next remove all the misc vacuum items from the intake manifold. Should be three or four. Most taking a 10mm socket.
Now with the vacuum stuff out of the way, take out all the 12mm bolts (three) toward the front of the engine holding down the manifold and the two nuts on either side.
Now disconnect the EGR pipe (right side of the manifold. You need to remove the top two bolts and looses the two nuts at the bottom of the pipe because you need to slide it out of the way later.
Now remove the throttle body by taking out the four hex bolts.
Now way to the back part of the engine compartment to get off two 12mm bolts that hold the rear manifold piece in. Back lower part of the rear manifold and are connected to a bracket.
Now a tricky part. Nissan thought it would be a good How_to_replace_spark_plugs_on_2004_Nissan_Questto put a couple wiring harness on the back of the middle manifold. The easiest way is to slide the plastic connectors off the metal brackets. you can't see them but put s screwdriver into the metal bracket back to disengage the plastic lock and slide the connectors upward and off. The plastic locks face towards the drivers side (your right as you work on it) so bring your screwdriver in from that side.
Now the hard part. There are four bolts connecting the middle manifold to the back. Of course you can't see them and the bottom two are near impossible to get to. For the bottom two, I used a 12mm open ended wrench put a piece of rope around the end and had my son pull while I pushed. It may help to lift the manifold up to get the bottom two, while the top two are easily reached when the manifold is down.
Now you should be able to pull the whole middle manifold out. Be sure to cover up the manifold holes to make sure nothing drops down inside.
Replace the spark plugs and reverse the instructions.
Good Luck.
How do you change catalytic converter in 2005 Nissan Quest?
after the rear cat assy is removed.what is the procedure to remove the cat on the firewall side at the manifold?
How do you install turn signal for 1999 Nissan Quest Van?
If you're referring to the turn signal switch (lever) itself DO NOT ATTEMPT THIS YOURSELF
You run the risk of deploying the air bag. Not only very dangerous but expensive.
