0
Plymouth Acclaim
The Plymouth Acclaim was a mid-size four-door sedan manufactured by Chrysler Corporation from 1989 to 1995. The car was the upgraded replacement of the E-body Caravelle. It was also offered in high-end LX and mid-range LE trims.
361 Questions
1992 Plymouth Acclaim what Refrigerant is to be used?
My 1991 Plymouth Acclaim manual says mine is R12, but I can't say for the '92
It was built with R12, should be retrofitted to R134a.
What would cause a 1991 Plymouth Acclaim to stall after it has been started for 3 seconds?
Possible weak fuel pump. The fuel pump will pump fuel to the engine, and if the engine's demands are greater than what the fuel pump can deliver, the motor will stall. Let it sit for a few seconds and the pressure builds back up. Turn the key, same cycle happens. The fuel pump needs to keep a certain pressure to the injectors. have a pressure test done to see if you have a fuel pressure problem.
Does the 1991 Plymouth acclaim have an interference engine?
No. A 1991 Plymouth Acclaim does not have an interference engine.
Doed anyone have a 1990 Plymouth Acclaim engine layout schematic?
The manual has a very nice detailed schematic and can still be found in most major auto parts stores.
Where can you find a diagram to show the routing of vacuum lines on a 1991 Plymouth Acclaim?
You can find a manual at oriellys called Chilton Chrysler front wheel drive cars 4-cyl !981-95 repair manual
What would cause a 1991 Plymouth acclaim to stall when you let off the gas?
First i would look at the throttle body butterfly area. if it gets dirty it will cause stalling. First time it took me 30 minutes to remove, clean and reinstall. now it is 15 minutes or less.
How do you replace the water pump on a 1992 Plymouth Acclaim?
This is a big job. I suggest getting a manual on your car from AUTOBOOKSONLINE.COM.
Where is the O2 sensor on a 1990 Plymouth Acclaim?
The sensor is between the cab and engine. its in the back of the engine not the front like many other vechiles.
Where is the daytime running lights module on 1991 Plymouth acclaim?
The '91 manual shows the DRL module to be located on the left front fender inner shield. This may be in the engine compartment side or more likely the tire well, I can't be certain. But look around for a module with a single plug on the bottom whose cable goes thru a hole in inner fender up near the front of the inner fender where the headlamps are located. The plug has 10-pins and uses 7 of them. 3 are from the headlamp circuit, 1 from the distance sensor, 1 to the cluster, and 1 ground. There is no troubleshooting info. I can tell you the connections and color code assignments, so that you can trace the paths
How do you repair water leak into headlight assembly in Plymouth Acclaim?
according to a Chrysler technical bulletin on this issue you need to drill a small hole in the top center of the plastic housing that surrounds the headlight. this will allow moisture out.
How do you replace the headlight assembly located on a 1991 Plymouth Acclaim?
Its held in with 4 star shaped screws... just disconnect the headlight bulbs, remove the screws and install the same way that you took that out with.
Why is my Chevy Trailblazer making a thump noise when the engine is started?
i dont know but would like to know!!!
Where is the fuse for panel lights on a 1990 Plymouth Acclaim?
Fuse panel cavity #8. Fuse is 5 amp and tan in colour. The circuits are as follows; fuel,voltage, oil and temp gauges. Chimes, warning lamp module, seat belt warning lights and mechanical cluster circuit board.
Where is the block heater cord for a 94 acclaim?
From where I can get the block heater cord for 94 Acclaim?
Why does my 94 Plymouth acclaim die then starts again after a few minutes?
I have a red 94 Plymouth acclaim that does the same thing...I am buying a new car. I hate to tell you but its the beginning of the end. Ive put 2 fuel pumps, an ignition switch, 3 altinators, and now I just put a radiator in it too!!!
Where is the crankshaft position sensor in a 1990 Plymouth acclaim located?
It doesn't have a crank sensor. It only has a distributor pick up plate (cam sensor).
Your car smells like coolant and has rough idle?
There could be a leak that is seeping into the seating. Check the engine as well as the radiator to ensure there are no loose connections which could be affecting performance.
What would cause the rear wheel of a 1993 Plymouth Acclaim to wobble?
Is it the entire wheel and tire or just the tire? A bent wheel can be caused by sliding into something or by hitting an object. If a wheel has been bent there is a strong possibility that it has weakened and should be replaced. Weakened wheels can be dangerous.
Where can you find a diagram for a 94 Plymouth Acclaim that shows the route of the serpentine belt?
usually there is a sticker right inside the frame of the car near the hinge of the hood.
Where do you add trans fluid Plymouth acclaim 1991?
Transmission fluid is added into the same spot that the dipstick is in.
Where is the timing mark for Plymouth acclaim 1994 2.5 liter?
where is the timing mark for Plymouth acclaim 1994 2.5 liter?
What would make a Plymouth acclaim temperature gauge goes up and down?
Bad temperature sensor? Thermostat opening and closing ============================================================ Well those are possibilities but usually when the temperature starts fluctuating on the 2.2 or 2.5l engines, it is usually a head gasket starting to fail. When this occurs, air (combustion gasses) end up in the cooling system and make their way to the t-stat housing. Then they cause the temperature sending unit and t-stat to have disagreements, lol. I would start with the basics - t-stat, temperature sending unit. Some report having a clogged heater core causing temp fluctuations too.
That usually means that the belt is slipping on the alternator pulley. You should be able to check the belt tension and if there is a tensioner, you may need to replace the spring. Otherwise, just tighten the belt.
