0
Wheel Alignment and Balancing
Wheel alignment is the adjustment of the wheels’ angles so that they would be parallel to each other and perpendicular to the road. Wheel balancing, on the other hand, is the checking of a heavy spot on the wheels.
1,166 Questions
Why is your A frame rubbing against the rotors?
check for a worn lower ball joint. use a floor jack under problem and lift from lower a rm grip the tire in the 12 and 6 o clock position and try to see if wheel moves and rocks if it does have some one look to see what part is worn check ball joint then check for loose wheel bearing if all seems tight someone could have slid into a curb and bent lower a arm also check to see if brake rotors were just changed,it could be a different size offset on rotor. sometime the ball joint stud actually oblongs the hole the ball joint go in and causes the spindle assy to wander around. this should be taken seriously and fixed right away,its no fun losing a wheel and hub assembly when your on the highway
Why would the front driver side wheel on a 1994 Chevy Caprice lean out?
That's what an alignment is for. Take it in to a good front end shop that does nothing else! Don't go to a dealer or a tire shop. They won't really be doing what's in your best interest, they just want to sell parts. A good front end shop will know how to make the repairs without spending a lot of your money, and they usually end up doing a better job.
Could also be a Ball Joint gone bad.
How much does a tire change cost for a 1993 Cadillac Deville?
Tire change? Depends on the tires. If its just to change a flat, depends on where you live. 10.00 to 15.00 max. If you mean a complete set of tires, It depends on what kind or brand you want.
Can a 31 inch tire go on a 30 inch rim?
No. The 'inch' figure for tires is related to the diameter of the interior 'hole' in the tire while the figure for wheels is linked to the outside diameter of the wheel. Trying to fit a 31 inch tire on a 30 inch rim would result in a 1/2 inch gap all the way around between the tire and wheel.
Cheers
It could be your wheel. Put it on a balancer and just hand turn it. You can see the bent area if it is too wide to see with your naked eye.
How do you know tires need alignment?
It is in the way you wheel wear. If you go to tyre centre they will be able to tell you if you need an alignment as they can see the way you tyres are wearing.
Where can I find an online checkbook balancer?
You can use surprise software, dinkytown wich also provides tools for your business, and clearcheck which also gives you your spending habits reports.
How do you break a stud with the rounded lug on it?
You split the nut with a sharp chisel. Don't worry about the stud You will have to replace both anyway, just be careful with the wheel and your fingers.
What size are the rims on a 99 chevy silverado c1500 and will 15 inch rims fit on it?
They are 16" and 15" will not fit
Do you need a wheel alignment when struts are replaced?
NO
That depends on how the struts attach to the knuckle or control arm. On some front wheel drives an alignment is required.
Need operating manual for a FMC 4100 SC wheel balancer?
http://www.snaponequipment.com/common/op-manuals/jb/past-products/4100_om.pdf
What is an average price for 20 inch rims?
The average price for 20 inch rims will depend on your location, the style, and if they are being shipped. They run anywhere from $100 up to $4000 per rim not including tire.
How much does it cost to replace a fly wheel on a ford 350?
IT DEPENDS ON WETHER IT IS A GAS MOTOR OR A DIESEL , OR IF YOU WANT STOCK OR AFTER MARKET.
Is it safe to Drive while steering wheel vibrates?
Not surprisingly, it depends, if the steering wheel vibrates all the time, no. IT could be a whole bunch of things. If it just vibrates at a certain speed range, roughly 50 to 70 mph, it is probably the tracking on your tires (or at least that's worth checking as it is a cheap procedure).
Either way, if it makes you feel unsafe whilst driving the car, then don't drive it.
How do you adjust the wheel alignment on a Honda Pilot?
I'm here in Honda garage since four hours (not 10-15min), two times they did road test and still my pilot pulling to right side. I don't care about time but i want them to remove the problem.
Honda is good, but need professional technicians.
Honda should respect their costumer timing.
For the answer, simply if you have two pipes and you want to center them you have to correct offset & angular misalignment in both vertical and horizontal views.
A trundle wheel is a small wheel or caster such as is found on the bottom of the legs of some beds and other furniture, and on the base of heavy appliances like refrigerators.
How do you know when your tires need to be replaced?
Most original equipment tires have wear indicator bars that will appear when your tread depth reaches a predetermined limit, usually 1/16 inch. It can be monitored with a tool called a tread depth indicator, or a penny placed head down into the tread, when the tread reaches the top of Lincolns head they are ready to be replaced. Look for unusual wear patterns like cupping, flat spots, and more wear on one side more than another as these indicate an suspension or balance issue that must be corrected.
Are there 15 inch rims available for 2000 silverado?
No. brake calipers are too large and will rub on the inside of the rim. however there may be some conversions to smaller rotors and calipers but not likely at all.
