Unanswered | Answered

Tractors and Farm Equipment

Parent Category: Miscellaneous Vehicles
Tractors are machines designed for hauling and are primarily used in construction or agriculture. They are classified as farm equipment together with ploughs, harrows, combines, mowers, balers, and pickup trucks.
(112-cm) Snow Blower has the capacity to handle big snow removal  jobs. .... X300 Series Tractors with foot lift and shipped with a  38-in.
All manufacturers are foreign to at least one country. Freightliner, Western Star, and Sterling are all owned by Daimler-Benz. Volvo A.B. is a Swedish company with a North American market, and they also own Mack Trucks. Peterbilt and Kenworth are owned by PACCAR, Inc, and also have production in...
Buy a gear puller, if you are trying to remove the gear because you need to pull the head, leave the gear on and pull the entire cam. Cat sells the tools, most of them are proprietary although Google search OTC tools and other dealer level tool manufacturers. Snap-On, Mac or Matco may have these...
thermostat will be located where upper radiator hose goes to  engine.there will be 2 or 3 bolts holding that housing to  engine.remove those bolts and housing and thats where thermostat  should be.PS; thermostat has probably been removed previoulsy to  fix engine heating problem,but that woud...
According to one manual, it doesn't seem that hard. Basically, toremove the blade: . Put the mower up on blocks . Make sure it is turned off . Turn the bolt that fastens the blade to the mowercounterclockwise. To put a blade back on (you either sharpened/balanced the old oneor are replacing it): ...
The Ford 1910 is a smaller tractor of the Ten series, built between 1983 and 1986 by Shibaura of Japan for Ford. It has a 1.7 L 3-cylinder diesel engine at 32 horsepower.
The first tractor to technically have the John Deere name on it was called the Dain. For the rest of the story see the related link...
If it started before but is not starting now, this is a spark or fuel supply problem, especially if the battery has enough power to turn it over. Check your fuel line, fuel filter, and for fuel in the tank. Check also the plug wire, and remove and clean the plug for good measure. The air cleaner...
You should never by pass any safety sensors on your lawn mower. BUT :for testing your brake sensor you can try taking the wires off the switch that is hooked ether at the back of the peddle or on the linkage and join them together .That should bypass it until you get a new switch.
Different states have different weight allowances for state highways, but Federal (interstate) and most US Highways are the same... 12000 to 12500 or to max tire rating on the steer axle, 34000 on tandem drive axles and 3400 on tandem trailer groups, keeping in mind that if your gross weight...
John Deere was an American blacksmith who made his name when he developed a very successfully horse drawn plough made from steel and the business developed from there
  V10 Left side exhaust manifold studs rusted away causing exhaust leak, 2002, 25,000 miles in motorhome.
TATA 407 . TATA 407 trucks is one of the best model for transporatation in small scale industries. Now a days TATA introduces a newly version of 407 as 407 turbo which more economic and smooth.
He can plow his field, and get his crops.
crop tractors are made my john deere and a few other companies and they are made for crops so when you are spraying over the crops you don't hit them.
5505 lbs operating weight with open station
A bus weighs uw 10,820kg.
  According to the Ford shop manual, the breaker point gap, for the 3 cylinder , should be set at 0.024-0.26. Firing order is 1,2,3. AG5 Autolite plugs recommended with gap set to 0.023-0.027.
It has a Gross Vehicle Weight Rating of 14,001 to 16,000 lbs.
Typical commercial US dump trucks are double-axle dually setups carrying about 10 cubic yards of material, which is about 10 short tons for typical materials like gravel or soil. A big, heavy-duty triple-axle model might reach 15 tons. A single-axle model based on a passenger truck might only hold...
The answer is ... it depends on a couple of things. Was it ordered with a GPS? Does your company use Qualcom? If yes to either of these then yes.There is also a plan within the Department of Transportation, congress and the trucking manufacturers in the United States to install "Black Boxes" such as...
That'll be dependent on a number of factors, including your local state laws, frame length, type of dump body, tare weight of the vehicle, etc. Under North Carolina's complicated bridge laws, a tri axle can typically haul 13-15 tons. Some states allow for higher weight tolerances.
For a Class 8 tractor trailer, between 30,000 - 36,000 lbs. This is for a standard five axle unit. Specialised units with multiple axle lowboy and beam trailers, collars, stingers, etc. can get much heavier.
  The 7-pin connector on the newer Bobcat cannot be made to operate anything but an attachment that is designed to be used by with that system.
A typical tandem axle tractor has 6 brake chambers.
  usually white smoke is caused by coolant getting into ignition chamber   can be caused by a leaking head gasket, a cracked head or compressor needs rebuilding
  You can legally drive an agricultural tractor unaccompanied at the age of 16 years old, only to and from a tractor driving test. At the age of 17 years, if the tractor has two seats then a qualified driver must accompany you, if the tractor only has one seat then you can drive unsupervised. In...
You have broken a CVD or try locking your differentials. I doubt it is the differentials you Amy want to clean it and reoil it to see what happens another weakness i have found is the small bevel gears inside the differentials have a tendancy to lose a tooth or two this also causes the diff to lock...
At the front of the dump body, there is a large cylinder in several sections which collapse into the largest section while the bed is down. When the driver is ready to raise the bed, they will normally unlatch the tailgate first (this may be done either manually, or from controls in the cab). Then...
Contact London Transport and ask them.
You'd need to identify your country of origin. In the US, if you  were talking about truck classification based on Gross Vehicle  Weight Rating, there are eight classes - 1 - 8, and no Class 61.  Classification systems may vary elsewhere.
The owners manual says 2 qt. or 1.9Liter
Crank the knob that is the depth stop all the way out, lock the deck in the lowered position, remove the belt noting the twist, pull the two spring-loaded "U" pins at the front to release the front, pull the hairpin cotter pins on the rear hangers and release them. Raise the hangers and slide deck...
Deere makes its riders, Snapper makes the current walk behinds. Great Dane makes a portion of the QuikTrak stand-on commercial mowers, but Deere makes the rest of those and the rest of the commercial mowers.
A John Deere 5325 has a recommended engine oil capacity of 11 quarts.
  It's got to be about $40.00 at least, maybe alot more. I used to pay $11 just hauling a single axle trailer behind a pick-up.
If it's just the rear axle which has dual tyres, then the answer would be six. If both axles have dual tyres, then eight.
Just different dialects, is all. Dump truck is more common in North America - specifically, the United States, whereas 'tipper' tends to be the more prevalent term in Commonwealth countries, Europe, etc. A dump truck in America is a tipper elsewhere, and vice versa, although the term dump truck is a...
depends on the size of the tractor
Typically, 13 feet, 6 inches (411.48 centimetres). West of the Mississippi River, trailer heights of 14 feet (426.72) centimetres are permitted.
A serial number is basically a record of production of whatever is serial numbered. This number is mostly used to date equipment for parts, repairs, etc. This number can be researched and some information can sometimes be found out, such as where the equipment was shipped and the original equipment...
That particular filter is a dealer item only. (approximately $25) There are no known crossover numbers at this time. Massey Ferguson Part Number: 4265229M1
Answers does not have the ability to show wiring diagrams.
no. just use a socket to remove after removing electrical connects between the glow plugs. this is assuming you have a 1702 kubota diesel. almost like removing a spark plug out of a gas engine.one glow pump is hard to get out. may have to remove a ejector feed line for clearance.hope this helps.
Using typical 4'x4' pallets, you can fit two rows of 13 pallets in a 53' box van, and can stack them however high your payload permits you to within 110 inches (the typical inside height of such a trailer).Typical retail trade distribution and logistics is supported by the use of 40" x 48" pallets....
That depends on weather its on the mains power supply or notMains supply is things like Alternator-Starter motor solenoid anything which as power to it when ign switch is switched offAs other power is when ign switch or light switch is turned on ,,as a dead short in second power will blow a fuse ...
If the round about question is how much does a trailer cost then what type of trailer...flatbed, refrigerated, dry van, car hauler, ect. Cost ranges between $30,000 and $100,000. Specialized trailers can be substantially more.
  Approximately 10 yards; but it depends on the weight of the topsoil, whether it is moist or dry.
how do you remove a damage steering hydrolic hose on a john deer 4300, no room to work
Can't be answered without knowing who made it, what caliber/gauge, if its a pistol, rifle or shotgun. Even then, the records may not exist/be published.
around 3 or 3 1/2 ton
Jack the unit up and place jack stands under the frame. Drain your flluid. Remove rear wheels and hubs. The rear axles are actually 2 shafts slipped together. There is a plastic boot with a band at the top and bottom that must be removed. Use wire cutters to cut the bands. Once this is done to both...
Some companies put the tare weights on the side of their vehicles. Otherwise, could get a scale ticket, from which you'd deduct the weight of the fuel and payload. Or you'd have to contact the manufacturer's of the tractor and trailer (or a dealership may be able to provide you with this information...
To the left of the gear shift lever, large plug on top of transmission. Fill here,
Before you even get into a commercial vehicle, you must have the appropriate learner's permit (if you're upgrading from a Class C license to a Class A license, it would denoted usually as "CPA"). Without that, you can more or less forget about it. Once that is done, you would either need to find a...
They are called chauffeur. Pronunciation [shoh-fer, shoh-fur] [Show-fur]
I'm assuming you are talking about the flexible hose that controls the bucket swivel. Mine exploded on me the other day. I ended up grabbing a bucket for all of the hydraulic oil that may have been left in the line and simply loosened off the nuts. For the one end of the hose that connects to the...
the linkage to the diff lock pedal could be siezed/stiff that's if it even has a diff lock also the spider gears in the diff unit could be damaged causing the diff to lock up
John Deere's first wife Demarius Deere died sometime in 1865. The exact date is unknown.
This question is much too vague to be answered. Dodge manufacturers and has manufactured several different models of trucks, ranging from Class 1 trucks all the way up to Class 8 heavy duty trucks (prior to the acquisition of Chrysler by Daimler A.G., who also own Freightliner). You could be...
Whats the size of normal bus or coaches?  The Normal size of a charter bus is 49 Passenger - these buses are very common and widely used - www.vipbuses.com There are also 24 passenger mini buses for smaller groups as well as 56 passenger coaches for larger groups. The 56 passenger coach will be...
role of farm machines in agriculture
A John Deere model M tractor serial number plate is riveted onto the engine block on the left side of the tractor.
You may be able to obtain a free John Deere 1032 Snow Blower Mnaual  on the John Deere website. Your dealer would also be able to get  you the manual, but it might not be free.
The fuse box on a John Deere 4430 diesel tractor can be found  beneath the drivers seat. The drivers seat should tilt forward  revealing the fuse box.
John Deere was the inventor of the Steel plow. This plow was self cleaning and didn't wear as fast as the iron plow or wooden plow that farmers were using during that time. The Steel plow was also much lighter in weight to the iron plow. In the midwest there was plenty of rich fertile black soil...
check the back axle oil level first as if it is low the dual power can slipthen check the free play on the clutch pedal you should have between 1cm an 2cm of free play in the pedal before you feel pressure on the pedalif there is no free play then adjust the linkage under the cab until you have the...
According to Echo which is a Japanese company the John Deere 55v is a CS500VL I have one of each an echo and a John Deere and they are identical except for color
No, they are not replaceable..when they break, you need to thro the machine out Just put it out by the street, mark it as TRASH, and it will be gone soon enough
A 'conventional' tractor is what is known to the rest of the world as either a 'bonneted' or sometimes 'Arctic' tractor. It simply means that the hood and engine compartment protrude in front of the cab, as opposed to a cab-over-engine tractor, where the engine compartment sits underneath the cab. ...
80,000 lbs. gross weight... same axle weights as anywhere else... 34,000 for a set of tandems, 40,000 for a ten foot spread, which is probably what the trailer it's being transported on would use, given California's bizarre 40' bridge limitation, versus the rest of the country's 41' bridge. Be...
Using synthetic oil in a heavy-duty engine doesn't extend the drain interval. It cuts down on engine wear (especially the bearings, but the cylinder liners last longer too) and gives better fuel economy, so you should use it.
Anywhere from 100,000 to 200,000, give or take.
The curb weight of a 1996 Ford L8000 with an automatic transmission  and a 8.3 liter engine is 10,000 pounds. Ford produced its L-Series  trucks from 1970-1998.
  No matter haow many sites are searched I cant seem to find the answer. sry.
All of the logos past and present are on the Deere & Company website. See the related link for more information...
Fuller Transmission shift diagrams. There are several places on or offline where you can obtain and Eaton fuller 15 speed gear shifting diagram. It depends what method you prefer. such as from your Truck dealer or a Truck Transmission Re-builder or someone who offers fuller transmission parts and...
They show up on eBay now and then. Otherwise, I have not been able to find a digital copy [PDF, etc.] anywhere.
  Milburn Drysdale, played by Raymond Bailey.
Mine weighs 20,900 lbs. Both tanks completely filled with fuel. Equipped with 14.8 l DD15 engine. Model year is 2009 (Equipped with DPF tech no SCR) This weight includes my weight abt 180 lbs along with chains and other gear, tools etc. There is no modification to the truck ie no APU installed, No...