Unanswered | Answered

Chrysler Sebring

Parent Category: Chrysler
The Chrysler Sebring is a range of middle-sized cars manufactured by American carmaker Chrysler between 1995 and 2010. It is one of the few practically priced automobiles available in sedan and convertible body styles.
== Answer ==   They are located in the in the center of the Valve Covers - three in the front cover, three in the rear cover. The front three are easy to remove, simply remove the plastic fuel rail cover. The rear are a little more complicated requiring the removal of the fuel plennum. This job...
I believe the AC belt also runs the Alternator in the earlier sebrings, if that is the case, I would highly recommend that you not operate the car without the belt. What year is the car? The car is a '95 coupe...but I have since learned the AC belt only runs the AC...so you can safely remove it and...
If you've recently had the battery disconnected for any reason,it takes my 2002 Chrysler Sebring LXI about 30 miles of travel toreset. It bucks and jumps until I've gone about 25-30 miles oftravel and then it smooths back out. This had happened everytimeI've had the battery disconnected for repair...
Either purchase an OBDII code reader from the auto parts store or use the three key-turn method. If you turn the key three times without starting, and the last time you leave it in the acc on position, the engine light will flash, giving you the older more general codes. There are other questions...
Unhook the battery for ten minutes.
The Speaker Sizes for a 2008 Chrysler Sebring Convertible are as  follows:    Front Dash: 3 - 1/2"    Front Doors: 6 - 1/2"    Rear Seat 5 - 1/4"   Side Panels
remove the positive cable under the hood instead of removing the cable from the battery, then take off the top cover and bottom after that get a 4 prong screwdriver, at the top take off the 2 screws and last unplug the connectors finally pull off the multifunction switch off.
  == Answer ==     Just tried to find a fan shroud for a 98 Sebring Convertible and found that only fit from 1996 to 2000 models. Possibly the motors were also specific to those model years. Nothing in the jjunkyard event came close. Had to order from the dealer.
  It can shut off because of lack of two things- gas and power. Power being electrical power and gas being gasoline. An engine needs both of these to stay running.
The Fram Filters cross reference guide lists two replacements for AC-Delco tf242. They are Fram FT1122A and Fram FT1122.
  The rheostat in the light stalk is dirty and getting a bad connection causing the dash lights to flicker dim to bright and so on. Try turning the reading and dash lights on and off several times moving the rotary switch from all the way off to all the way on abd back several times. This...
  Use www.mapquest.com to determine the miles you will be traveling. Now divide that figure by the MPG that the vehilce you will be driving gets on the highway. That tells you how many gallons of fuel you will use. Mulitply that by the average price of fuel in your area, and you now know about...
  The procedures are in the owners manual or you can purchase a manual from your local auto parts dealer like Haynes or your auto parts store can give you the procedure from their computer. Its pretty easy. Just raise the hood, see the two silver 8mm cap screws on top of the cross member that...
There isn't a vehicle speed signal wire on a 2007 Sebring. Thetransmission computer uses its input and output sensors to factorvehicle speed. It then transmits that message over thecommunication wires of the vehicle.
On my 2000 sebring convertable they are on the door jamb near the part that the door latches on to where the back of the door comes to rest. They look kind of like a bicycle tire stem and are held in by a single screw. After removing the screw, you detach by pressing a little raised tab that release...
  if you were able to look through the driver side door it would be underneath the side mirror. its a plastic panel that has a grip to allow you to pull the cover off and see the fuses. the diagram is on the back of that plastic cover. for the fuses under the hood there is a diagram in the car...
Check coolant level   Thermostat may not be opening   Heater core may be plugged, restricted or air bound   Does vehicle overheat?   Most common for this failure on the 2.7l engine is low coolant level. The heater core supply lines and temperature sensor sit as high as the top of the...
$2400_______________________________________________________________It depends on which engine you have and in what geographic area your vehicle is located.For a 2.4L engine in the Middle Tennessee Area, the part runs $231 (incl. tax) at Autozone and the labor around $700 at an independent shop to ...
bad crankshaft position sensor can affect this. i had the same problem with mine, shutting down when stopping at a red light and not letting the engine rev past 3500 rpm during full throttle acceleration. car would start immediately after shutting down, if u waited for a DTC then it would not start...
The EGR Vacuum Solenoid on a 2001 Chrysler Lxi Coupe 3.0 V6 should be on the left of the upper manifold. The black cylinder that's on the outside is what you're looking for, it's on the otherside connected to the same plate as that. May have to remove the manifold or just unbolt it. You can buy the...
Key on engine off, press gas pedal to the floor three times, cycle key off and back on.
Far driver side of the firewall under the hood.
The factory alarm is built into the body and engine computers andcan not be removed.
Answer . \nThis is a potentially dangerous repair. Do not attempt this yourself. This should only be done by a qualified tech.
it means take the car to a dealer ship and get rid of it lol... no have a system computer check on your vehicle it can be anything from low oil to a major problem
Key in driver's side door - turn to "unlock" position - stops the alarm
  == Answer ==     Be sure the ignition switch is in the "off" position. Move the steering wheel right & left while removing the key - sometimes the steering wheel lock mechanism engages and needs to be manipulated to allow ignition switch into "off" position. Airbag light is a mystery,...
Possibly the crank sensor or the coil pack is dead. But with a dead crank sensor you also get no spark, no crank. No crank equals no fuel delivery.
A local auto supply store can reset it for you.
  You could start by reading the owners manual if you have one. If not, insert a small diameter rod (a ball point pen tip works fine) into the small buttons on the right side of the clock display labeled H to change the hour and M to change the minute.
It is under the housing where the upper radiator hose attaches tothe engine.
well, if by fluid u mean coolant than yes. If coolant is leaking, there wont be anything to cool the engine temperature. Replace the cap, there very cheap.
  == Answer ==     which drain?? sunroof? wheelwells?   == Answer ==     This is a common problem, with a VERY easy fix...     The reason this is happening is simple.... Chrysler's water drainage for Sebring ragtops is kinda weird. When your top is up, any water that...
The fuel filter is part of the pump module, in the fuel tank.
You need to have the trans computer checked for trouble codes. The car will not shift out of 2nd when the system detects a problem and sets a code.
On my 2001 sebring, my light lever is on the column. After turning on my lights, I gently twist the end portion of the lever out (toward the door) to get the fog lights on
I have the solution for you. For the 2004 Chrysler Sebring Coupe Limited 3.0 (That is the Sebring with the V6 Engine the 6G72) you have to go on eBay and order to pairs of WHEEL ADAPTERS SPACERS 5X114.3 CHRYSLER DODGE FORD 2".  Make sure that they are hub centric The 2004 Chrysler Sebring Coupe...
  So that they can be taken out if any water gets into the trunk, and while in place they stop grouind water getting in.
1998 Chrysler Sebring cooling fan relay switch can be found on theback of the fan. The relay switch is attached to the fan motor withtwo retaining screws.
The primary causes for the lights to flicker inside on a 2002  Chrysler Sebring LXI is a loose bulb or wire. This can occur when  the vehicle has experienced rough road conditions and excessive  vibration.
More likely it is the sending unit. I'd replace that first.
They do not exist. They are integrated into the fuse box under the dash.Most of the time you will find that the control unit that plugs into the rearof the fuse box, has either loosened or unplugged from the actual fuse holders.This will effect the operation of the turn signals and other important...
Answer . \naround 3000 rpm is a safe bet. It would help if you described the engine ( 4cyl / 6 cyl / 8 cyl.. 2700 - 3000 is safe....
The thermostat is under the housing where the lower radiator hoseattaches to the engine.
The Pope's ordinary clothing is a white cassock with attached  pellegrina, a fringed white fascia belt, red papal shoes, and a  white zucchetto. The Pope wears several additional ornaments for  formal occasions such as the triregnum crown.
you must first remove the power steering pump and bracket. you do NOT have to take the pump off the car you can just unbolt it from the braket and lay it off to the side. Just be ready, the two bolts on the back side of the block are pretty hard to get to. But do able. good luck.
To turn on the fog lights you pull the end of the turn signal lever it will pop out about 1/8th inch.
Answer . I changed the thermostat on my '99 Sebring Limited 2.5 l. convertible today (5/4/2005). As someone else stated, it's a tedious job but not impossible. Look underneath the pressure cap/fill pipe. There's a separate casting bolted to the block. It is held in with three bolts having 12...
To fix this on my car I thought I needed a new starter but when I went to take the starter out the bolt holding the positive cable on the starter wasn't very tight so I thought maybe that's it. Well that was the problem so I took back the $160 starter and the fuse never blew again.
That happens when the transmission computer detects a malfunctionand sets a code. You need to have it checked with a scan tool toknow possible causes.
The automatic transmission does not have a drain. You remove thepan to drain.
These are two of the models that are available for this vehicle.  These two are the convertible options that are available.
In order to disable the alarm on the Chrysler Sebring, try putting  the key in the driver's door, the passenger door, or the trunk and  then unlock all the doors. If this does not work, you may have to  take it to a technician.
  == Answer ==   if it's the same as a 98 then all you need to do is find the power cords running to the back of your headlight assembly and turn the attachment left about a 1/4 turm. That will free up the cable allowing you to remove the bulb. Make sure you don't touch the new bulb with...
  Replace the crank sensor located on bell housing of trans.
Key on engine off, press gas pedal to the floor three times, cycle key off and back on.
If the shifter will not move you have a mechanical or electricissued with the shifter. If the shifter does move you may have lowfluid or a failed transmission.
The thermostat is under the housing where the lower radiator hoseattaches to the engine.
After you have completed work on the cooling system and you beginto replace the coolant, open the bleeder a couple turns. As youpour coolant into the reservoir air trapped will escape out thebleeder. As soon as you see coolant come out of the bleeder closethe bleeder valve and continue to add...
A very few were. If it is it will either have a e85 sticker on theinside of the gas door, or a yellow fuel cap.
Vehicles that are around 96's and up have an OBD-II computer link up. This palm held pluggin unit costs around $125 - $150 ish online or at the autopart stores a bit more.The beauty of it is it will diagnose your check engine light problems and tell you what it is so you know what to have replaced....
  == Sparkplug changing safety tips. ==     It depends on which engine your sebring has. The sebring coupes have a Mitsibishi engine that is different than the convertables and sedans. Be careful of loosening any fuel lines that may be under pressure. The pressure is enough to inject fuel...
You need to trace the hot wire to the compressor to see where circuit is crossed.
The pointer could be stuck! or >>If it is a closed oily ball, give a few quick taps,,,or if possible ,pull it out an shake it maybe the pointer will get free!!!I have a Cirrus LX 97 with no compass... I am just guessing, but I know some speakers magnets near the compass make the compasses...
Try looking in your owners mannuel
You hook a battery charger to the red and black jump start posts under the hood.
  == Answer ==     I assume you only need to change the bulbs. Go into the trunk and look up. You should see the wires leading to the mounting point for the third brake light, you candisconnect the connectors and then change the bulbs this way.
Hey Melissa==First remove the neg battery cable then the serpentine belt then the wiring for the altermator then the 2 bolts that hold it on. Make sure you have a schematic for the belt before you take it off. It should be on the fan shroud. If it isn't there, draw a schematic for yourself. Don't...
The fuel level sensor is on the fuel pump, in the fuel tank.
It is on the top rear of the transmission bell housing.
Chrysler/Plymouth vehicles do not use inertia/reset switches.
It is on the radiator side of the engine, above the oil pan, behindthe engine mount bracket.
  == Answer ==   Could ba a blown fuse for blower motor   Could be a bad switch for blower motor    
It's inside the gas tank.... Horrible as that sounds... be happy it's only a 15 gallon tank... Run it until it's almost empty and then drain the rest... You don't have to REMOVE the tank, but you do have to loosen it to remove the pickup unit (that houses the filter).   This assembly runs about ...
  peel back the trunk liner.....should be two or three screws. unscrew and pull the entire light assembly out its a pain in the but!