answersLogoWhite

0

Air Compressors

A machine for generating compressed air, typically for use by air-powered tools or paint sprayers. The compressor takes in air at atmospheric pressure, and increases it to any pressure between 1 psi above atmospheric, and 10,000 psi above atmospheric. Air compressor motors can range from fractions of a horsepower, to multiple thousands of horsepower.

908 Questions

How can air be compressed?

According to the Ideal Gas Law, first stated by Emile Clapeyron as a combination of the existing Boyle's Law and Charle's Law, pressure of a gas (air is a mixture of gases) can be increased by either decreasing the volume, increasing the amount of gas particles in the compartment, or by increasing the temperature. Air compression is done through the first option of forcibly decreasing the volume of the container. While there are many types of gas compressors, the most commonly available method (reciprocating compressor) is to drive air into a compartment then use pistons to shrink the volume of the gas.

How can you reset the Rear Air Suspension on A 1994 Lincoln Town Car after a tire change?

This information can be found in your owner's manual. Don't have one then get one. Dealer or salvage yard.

You should have turn off the "Air Suspension" switch in the trunck before you jacked the car up. But, evidently you didn't, so get in the car (so there is weight on the drivers seat), start the car and run it for a couple minutes. The level contol computer should raise your level back to normal. It dumped air from your air springs when you left the Air Ride switch on - because the vehicle level sensor indicated the back was too high when the car was jacked up.

Or it overinflated the air spring and ruptured it. There is only 1 height sensor for the rear and jacking up one side lowers the other. The height sensor is pretty close to the middle of the axle but may have indicated a low condtion when there was in fact a high condition and caused a leak.

How do you install the AC belt from the engine to the compressor of a '99 Chevy Metro?

The Air Conditioning compressor serpentine belt can be changed by adjusting the small belt tensioner idler wheel. This small idler wheel has a center nut (I think it's 14 mm) you must back off first so the wheel can slide up & down in a slot.There is an adjusting bolt on the bottom of the wheel bracket. When the idler center nut is loose, put a socket on the bolt head (facing upwards) and turn to draw the idler wheel downwards. This will slacken the belt and you will then be able to slip the belt off the pulley. Remove & install the new belt and trun the adjusting bolt back tightening the idler wheel onto the belt until your satisfied with the tension. Tighten the center nut and check this doesn't change your tension. This procedure needs you to remove a plastic splash shield in the fender well. You can do this.. it's a "one beer" job! DangerDude

What valve compressor tool to use for a Geo Metro G10 engine 3 cyl SOHC and where to purchase it?

Make a folcrum or use a "C" clamp: take a 1" piece of copper pipe 4" long, cut 2 slots (1/2" wide 180 degrees from each other)on one end.

What would be the cause for a Buick Rendezvous 2002 air compressor to work but doesn't have air coming out the vents?

Possibly could be the cabin air filters. I don't think that would restrict air flow 100% however. Previous Answer->This problem would be best handled by a repair shop. This could be very costly to replace parts, just because a friend had the same problem, does not mean it will be the same solution. My 2002 CX does the same - little to no air flow out the vents on heat or cool. Mechanic can't find anything wrong, not a cabin air filter problem either. Check all the complaints on CarFax - Buick doesn't admit any wrong or manufacturing problem.

What does air suspension do on navigator?

While driving, the air sup... raises the vehicle up a couple of inches. This is not noticeable while driving but if you stand by (or lean on) the vehicle after parking, you will notice it dropping slowly. Sometimes you can even hear it when it starts to drop. I assume the air sup... makes for a smoother ride......like riding on air.

How do you remove the air conditioning compressor on a 1994 olds cutlass supreme?

first remove the belt via the belt tensioner use a 3/4 wrench to do so disconnect all lines and hoses and unbolt it for engine

Where are the relays for power to the air conditioning compressor located?

Hey Grady==You don't say what kind of car you have but most don't have relays on the compressor. Ihere is a cycling switch on the accumulator that when it is low will keep the compressor from engaging. GoodlukcJoe

Why does a 1999 ford escort air compressor does not switch on?

I would bring it in, and make sure you have enough freon in there. If the levels are too low, you will need to have it recharged before the pump will engage.

How do you remove air compressor from navigator?

You don't mention, but this should do all Navigator years.

Make your life easier:

Remove battery completely.

Remove battery tray.

Must do:

Remove windshield washer reservoir. Two fluid lines, two electrical connectors.

MARK THE LINES! One is for the front window, the other is for the rear. You CAN get them backwards, which is just plain annoying.

Press red collar around air line connection into the air dryer (big black cylinder)

Be nice, it shouldn't be hard, and it's easily broken

Gently but firmly pull out the air line, if it doesn't come out easy, try pushing it in a little first to break the seal.

Undo the 3 bolts holding the entire compressor and bracket in.

Carefully unplug the harness.

Carefully "Work" it out. It won't come straight out, it needs to twist or rotate a bit.

Be careful not to damage your Air Conditioning hoses/lines.

If you're looking for a replacement, go to Arnott Industries in Florida. Their site is easily Googled. Awesome products, less than half the cost of the dealership.

What is the difference air compressor and gas compressor?

1.The compressors used for compressing the other gases and air are independent entities. This means they merely compress the gas or air and supply it for the suitable applications. They have no direct connection with any other type of machine, though lots of machines and equipments depend on the compressed air or gas. The refrigeration and the air conditioning compressors are a part of the complete vapor compression cycle that comprises of additional components like the condenser, expansion valve and the evaporator. If the compressor is removed from this cycle, the refrigeration process will cease to exist.

  • Main function of the compressor: The main function of the other compressors is to merely compress the gas or air. The refrigerant compressor compresses the refrigerant to the pressure corresponding to the saturation pressure higher than the temperature of the naturally available air or water. This enables the cooling of the refrigerant in the condenser by the available atmospheric air or water.

    Further, the refrigerant compressor also circulates the refrigerant through the whole cycle. The refrigerant after leaving the compressor is forced to the condenser, the expansion valve, and the evaporator and then it is sucked by the compressor for compression and recirculation though the whole cycle.

    3) Capacity Determination: The capacity of the refrigerating compressor determines the capacity of the whole refrigerating or air conditioning plant. The capacity of the air or gas compressor doesn't determine the capacity of the other plants. For instance, though the pneumatic tool depends on the compressed air for its operation, it has its own capacity.

    4) Relation to the other equipments: The refrigerating compressor is integral part of the cycle that includes other components of the cycle like condenser, expansion valve, and the evaporator. The working and proper functioning of each of these components depend on the working of other components. If the refrigeration compressor breaks down the whole system will collapse. There is no such dependency in case of the other compressors. If the air or gas compressor breaks down, the standby compressor can be started easily.

How do you change a air compressor on a 2003 Kia Sedona?

I am a pretty accomplished shade tree mechanic. I just finished doing this and it took me about six hours, so it's not an easy task.

1st Remove the air filter tube

2nd Remove the radiator fans (requires removal of radiator hose and engine lift bracket)

3rd Remove the alternator

4th Remove the AC compressor

Put every thing back in reverse

Pull a vacuum on the AC system

Recharge the system with 134A freon

How many air compressors are on a 2003 navigator air suspension?

Only one air compressor is used on a 2003 Licoln Navigator and it is located on the front right hand side of the engine compartment

What does the air compressor for the air ride suspension on a 1992 Lincoln Town Car look like?

That airpump in in or around the carb or fuel injection housing. It is a very costly pump one of the reason no one seems to want to replace it. It is just a small pump about the size of a half dollar. I am not a mech but have had one replaced before On a 91 town car it sets under the air cleaner housing. It along with the windshield fluid container must be removed.

Why does your 95 s10 4.3z surge with air compressor on?

The ac compressor may be on its way out and binding. Disconnect it before it fills the ac system with trash.

Can air compressor be bypassed on 1999 Bonneville with a 3.8 engine?

You mean A/C Compressor? If so, yes you can bypass it. Just buy a drive belt for a 3.8 that came from the factory without A/C.