0
Buick LeSabre
This category covers questions about the Buick LeSabre, a full-sized entry-level luxury sedan manufactured by the Buick division of General Motors. The LeSabre replaced the Buick Special and was in production from 1959-2005. It was later succeeded by the Buick Lucerne.
2,607 Questions
Where is the blower motor control module on a 1996 Buick Riviera?
Under the dash on the passenger side below govebox
What does it mean if the check engine light and anti-lock brake light is on in a 1995 Buick LeSabre?
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
Where is the location of the MAP sensor on a 1990 Buick LeSabre?
After consulting several sources, someone finally called a local Buick dealer who informed me that a 1990 LeSabre does NOT have a map sensor, it was the Mass Air Flow sensor that needs replacing.
your wheel bearings are probobly lacking lubrication (grease),you should have it checked by a qualified technician as the bearings are liable to collapse and cause loss of control. I've had a similar problem with my 93 LeSabre at 146000 miles. The right front wheel had a bad brake hose. The hose softened up and the brake fluid remained in the calipers causing the wheel to become hot enough to cook eggs or at least burn yuour hands. The odd thing with this was the car would not pull to one side as you would expect. Once the hose was replaced the car is fine.
95 buick lasabre idles up and down what cause this to happen Check engine light is also on.?
check all vacuum hoses,a leak will cause erratic idling.also could be the throttle position sensor.plug a scan tool into the car,there should be a code,as to why the check engine lite is on.
after driving the car, pull off the vacuum line on your fuel pressure regulator and if there is gas that comes out the vacuum hose , your problem is a bad fuel pressure regulator!!! :)
Why would the horn of a 1995 Buick LeSabre go off when the car was left in the driveway?
I also have the same issue with my 1995 Buick Lesabre. It started happening when I overcharged the battery and now the horn goes off at 2am, 6am, and all hours. I have had to disconnect it at both horns under the hood.
same exact problem all during the night, i have to take out the 60v fuse in the box behind the engine under the hood every day. is there anyway to take apart the steering wheel horn or anyway to fix this?
Where is the signal flasher on 1987 lesabre?
The turn signal flasher is located in the fuse panel. It is under the dash on the drivers side.
How do you replace the front side turn signal bulb on a 2001 Buick LeSabre?
2001 Buick LeSabre turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Why Engine Light comes on and 1987 Buick Stalls?
You better check the computer code ASAP it may let you down on the road. Mine did.
How do you open the hood of a 1993 buick lesabre if the inside latch won't work?
I had problems with my hood latch on a 1993 Le Sabre. My mechanic showed me how to open the hood. Pull the lever back just enough to pop the latch. Do not pull the lever any further than that or it will not work. Once you get the hang of it you will have no problems. Good luck.
Where do you find the paint code for a 1992 buick lesabre?
Look in the glove box; One of the last characters is PNT (paint) WAxxxx, write all those numbers down and bring them in then you will figure it out.
Can a leaking intake manifold gasket on 94 LeSabre allow oil to leak badly from engine block?
Yes, as well as anti-freeze. The two may also mix together inside your engine.
How to remove the door panel on 1999 Buick LeSabre?
Using a screw driver, remove the screws and the clips that are in the door panel. Gently pull the door panel away from the frame, remove any wire connectors and the door panel should be free.
How do you repair the switch for the bright lights for a 1992 Buick LeSabre?
replace the combination switch on the turn signal stalk
You have four options I can think of off hand.
One get in touch with whoever set the code and ask them for the code then input the code.?
Your second option is to speak to your local buick dealership and ask them about unlocking the radio.
Third option is to get an unlock code from a third party.
Fourth option is to buy another radio.
2002 Buick LaSabre battery location?
It's under the rear seat cushion. Lift up the front edge of cushion and pull forward to remove the seat cushion. Check in the owner's manual.
What causes a grinding noise whenever you turn your car in either direction?
there are several things this could be. Your powersteering pump may be low on fluid or may be shot. Your tie rod ends may be wore, or your control arm, ball joint may be shot.
Why does tail light fuse keep blowing on 98 buick lesabre?
Answer 1 - Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, none of us can identify the specific defect which is causing your problem.
Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, whether direct current [DC], or alternating current [AC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors.
And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or repeatedly "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do; that is to protect the conductors and components of the circuit which it serves.
The proper "fix" for this issue is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few people will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it.
Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an oversized fuse would almost guarantee damage to the wiring and the probability of an electrical system fire.
How do you remove the headlight and parking light switch unit from the dash of a 2000 Buick Lesabre?
The dash faceplate in which the switches are centered pries outward from left edge (about 1 1/2" high, 8" long). Plug and wire are then exposed for disconnecting, and plate can be removed and taken to workbench. Then it's up to you to figure out removal of switches from plate. I watched my dealer remove the plate w/switches and take them to workshop to free them up when stuck ON!
How do you reset the security light on a 1999 Camaro?
plug your key into ignition turn on dont start just leave it in the on position for 15 min bam u got it
2001 Equipped Buick Lesabres have two different cruise control activation switches. The first turn the cruise control ON. The switch sets which speed the throttle will be locked at. This problem can be caused by the primary sources, the system is being operated manually or switch and or cruise control module failure.
Where is the pcv valve located for a 2000 Buick Regal LS 3800 series II motor?
The pcv valve is located under the map sensor in a plastic housing. If you stand on the passenger side of the vehicle and look under the hood, the map sensor is the sensor right in front of you. It should have three wires going to it. If you look closely, the sensor is clipped into a type of cap. If you grab the cap the sensor is clipped into and twist it counterclockwise, it should come off and the pcv valve will be inside. You may need new orings to prevent oil consumption. You may also need a needlenose pliers to remove the sensor from the upper intake manifold. Russtech67 you don't happen to have a pic. of the location? where it shows some details, I tried to find it, but no luck
