0
Chevy Blazer
The Chevy Blazer may refer to any of the sport utility vehicles manufactured by the Detroit-based automaker General Motors Company. Some of the popular Blazer models produced by the company are the TrailBlazer, the S-10 Blazer and the K5 Blazer.
5,824 Questions
Where is the fuse for the 4x4 on Chevy blazer?
The fuse for the 4x4 is located on the side of the dash on the drivers side. just open the door and you will see a nother door going into the dash. just open it and you'll find it. If u cant find it look in the users guid for the digram and it will show you witch fuse to change.
Dont have manual Need fuse panel layout for 2000 Excursion?
Believe it or not, the fuse panel layout can be found in the operator's manual, towards the back. It has a diagram for the location as well as a table that includes each fuse's function as well as it's fuse type and amperage.
--------------------------------------------------------------------------------------------------------------
Click on the link below
Click on Owner Guides
The Owner Guide ( which includes the fuse panel diagram ) can be viewed online
What does a transmission modulator due on a 86 Chevy blazer?
Modulates pressure that controls shift points.
What is the best way to remove 2 broken starter bolts broke off at the threads 95 Chevy s10 blazer?
Weld a larger nut to what is left of the broken bolt, let it cool then turn it out.
Where is the transmission dipstick located on a 2000 Chevy s-10 blazer?
It is located on the rear of the left side of the engine towards the firewall next to the AC accumulator (the big aluminum can looking thing). This dip stick should have a red handle and is inside a black tube that comes from underneath the engine. Simply flip the handle up and pull the dip stick out leaving the tube in place.
How do you replace the driver's side mirror on 2000 Ford Windstar?
Not sure if it will be the same for the 2000 Windstar. I changed the whole mirror assembly on my 98 passanger side. There are 3 nuts holding the assembly on the door. You must first remove the inside door panel by removing the cover around the door opener handle. There is a screw behind it once that is removed you can remove the panel by lifting up on the panel. you can then unplug the power window and lock buttons if you like( it does make it easier). then you have access to the nuts holding the mirror assembly one once you remove the little black rubber plugs. Unplug the power mirror cable and then reinstall the new one in the opposite order as the removal. .
New HeadlineOn my 2000 Windstar, there were 4 hex headed screws that I needed to remove with a 9/32" nut driver. Two were in the bottom of the door handle. One was near the bottom rear corner of the door and the other was under a black plastic trapezoid shaped piece (about 3" x 5") near the top front of the door (on the inside of the car, opposite the mirror). I carefully pried the black plastic piece off as it just snaps in place.The door panel could then be removed by lifting up and towards the back of the car. The two power connectors near the middle of the panel unplug by depressing a tab on them and the courtesy light near the bottom rear of the door panel can be removed by twisting counter clockwise.
There are 3 nuts holding on the mirror assembly, two of which are under black plastic/rubber hole-filler grommets. Be careful not to drop the nuts down in the door panel! I used an 11mm socket with a magnet to keep the nuts from dropping.
The power connector for the mirror motor/heater is under some white foam sound proofing. I peeled back a portion of it to expose the power connector. After unplugging the connector, I tied a piece of sturdy string to the old power connector before removing the mirror so that the string "fished" through the door panel as I removed the mirror and cord. I then untied the string from the old connector and tied it onto the new mirror's connector and pulled the cord back through the door panel. I think it would be very difficult otherwise to get the connector back through the door panel.
The remainder of the installation was just a reverse of the removal.
How to open up the glove box of 1996 Cheverlet Blazer?
The handel is up top on the dash like your pulling down.
lol.
Where is the radiator drain petcock on a 2002 Chevrolet blazer?
most GM radiators have a peticock at the lower driver side corner of the radiator. Often hard to see from most angles.
How do you remove a heater core from a 1999 blazer?
Open both front doors and remove everything from the front seat to the firewall, no kidding. If you intend on doing this job, purchase a shop manual for the vehicle, you will need it.
Where is the fuel pump on a 94 Chevy Blazer 5.7L?
It is inside of the fuel tank. You will have to remove the fuel tank to get to it.
How do you replace the brake light bulb on a '95 Geo Prizm?
Open the trunk and remove the plastic plugs that hold the felt in front of the lights. This will allow you access to the bulbs in the tail lights. You'll have to twist the sockets counter clockwise to get them out. Counter clockwise like you're in the trunk.
This is incorrect and too vague.
Probably a problem with the transmission "valve body". Have it checked out with a transmission specialist.
What is the horsepower rating on a 95 Chevy blazer with a 4.3 vortec?
Year Horsepower Torque Fuel SystemCompression Ratio RPO Applications 1992-94 200 hp (150 kW) @ 4500 rpm 260 lb·ft (353 N·m) @ 3600 RPM CPI 9.1:1 L35 1,2,3 1995 190 hp (140 kW) @ 4500 rpm 260 lb·ft (353 N·m) @ 3400 RPM CPI 9.1:1 L35 1 1995 191 hp (142 kW) @ 4500 rpm 260 lb·ft (353 N·m) @ 3400 RPM CPI 9.1:1 L35 3 1995 195 hp (145 kW) @ 4500 rpm 260 lb·ft (353 N·m) @ 3400 RPM CPI 9.1:1 L35 2
Why does my1996 Chevy blazer go forward but will not reverse?
The input sunshell splines have stripped or the hub has broken off. This will give you 1st + 3rd gears only with no reverse, 2nd, or 4th gear.
Where do you put the transmission fluid in a 94 Buick LeSabre?
In the transmission dip stick tube. You need a special filter with a long neck. Can be purchased at any parts store.
if its cold out your gear oil is just very thick which makes it hard to shift once the car gets going it should be fine
Wiper blade size 1997 Chevrolet blazer?
Both sizes are 20"
Front Windshield Wiper Blade (both sides) . . . . . . . . . . Trico 20 inches (50.8 cm)
Backglass Wiper Blade . . . Trico 14 inches (35.6 cm)
See sources and related links below for more information.
