answersLogoWhite

0

Chevy Corvette

Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.

4,587 Questions

1982 Corvette computer port location?

I believe that the computer data port or known as the ALDL is located behind the ashtray on a 82 Corvette.

Is a 1974 frame the same as a 1975 frame in a Corvette?

No, the 1974 Corvette frame is NOT the same as a 1975 Corvette frame. I have had customers modify it to fit, but you would have to change the rear kick up or adapt a 75 and above rear bumper assembly to make it work.

Where is the location of the secondary fuse box on 1992 corvette?

The Fuse Box is under the passenger side glove Box. Unscrew the hex bolt and look up to the left and you will see it.

Which is the cooling fan relay of the 3 on a 1995 corvette?

Most of the 90s GM cars have the fan relay mounted on the fender near the battery.

Where is the crankshaft position sensor in a 1994 Corvette?

1994 corvette quit accepting more and more throttle then died and wont crank

What is the basic warranty on the 2012 Chevrolet Corvette?

The 2012 Chevrolet Corvette has a 3 yr./ 36000 mi. basic warranty.

Where are the headlight actuater relays located for a 96 corvette?

There is a box located in front of the left front tire,it has two connectors and is by your air pump.Has the word guide on it with two 10mm bolts holding it

Where is high beam switch location on 1971 Corvette?

The 1971 Corvette High Beam headlight switch is located on the floorboard, actuated by the driver's left foot, like most cars of that period. However, Corvette hid it under the carpet, with a reinforced pad molded into the carpet over the switch location. Neat huh?

Is the lS2 v8 motor and the L98 v8 motor the same?

No. The LS2 is lighter, more reliable, and more powerful. Also, the LS2 is newer and more expensive.

These engines are totally different from each other. The L98 is a Gen I, TBI fuel injected 350 displacing at 5.7 liters. The LS2 is a Gen 4 LS engine used in Corvettes and GTOs displacing at 6.0 Liters and 364 cubic inches.

How do you change a distributer in a 1993 Corvette?

Odds are you have an optispark unitl. If so it is under the water pump on the front of the engine. Look up optispark replacement on LT1 or C4 Corvette.

How do you change a clock in 1978 Corvette?

I just did it....do yourself a favor and wear a watch.

Remove the gauge cluster trim...2 screws on either side near top...2 connecting the base to the shifter console (removal of side carpeting is necessary. They point up from the shifter trim console into the cluster trim. One on each side. Size 1/4 I believe.

Pull the guage cluster from the back by removing the 4 screws. Remove the clock without tearing the plastic circuit sheet. Replace clock.

REPLACE ALL OF THE LIGHT BULBS!!! Hey. Your only in there once in a while.

Re-install everything and throw away the leftover screws. I had 2. Your number may vary.

A Haynes manual will help with the details. Good luck!

How do you change battery on a 1986 corvette?

Remove the small body panel by removing the three bolts from the wheel opening directly behind the front wheel, then take an open end wrench and loosen the bolt between the bottom of the small body panel and the molding it joins on the bottom. The wrench will barely go between the body panel and the bottom panel. If you look between them, you will see the bolt head. You only have to loosen this bolt, as it will not come out, then slide the body panel straight out to the side, remove the battery hold down clamp and slide the battery out.

How do you change corvette 283 motor with a generator to an alternator?

The easiest way is to get a late model one-wire alternator, I think circa mid 80's. As by its description, you hook one wire to the battery---and you are charging. It's got the voltage regulator built in. Of course, you will need to figure out how to hook up you alt/ charge light. You'll also need the late model alternator brackets from a junker-or get new chrome ones.

Your next cheaper but more labor intensive is to get the alternator, brackets, voltage regulator, and wiring harness from a late 60's to late 70's gm product. Again, you'll need to figure out how to wire the charge light. If I remember right you'll need a hot wire from the fuse box to excite the alternator to charge. I had a 74 Monte Carlo that blew the instrument panel fuse and it quit charging.

Where is the oil temperature sensor on a 1986 Corvette?

It's above the oil filter and below the ground bolt on the side of the block.

What is the normal operating coolant temp for a 2001 Corvette Z06?

Typically it is right around 200 to 210, and alot of that depends on where you are in the states and how you drive your Corvette. You can get alot of good ideas as to what others temps are running at in all different states over at Smokinvette.com.

Where is the fuel filter location on a 1985 corvette?

The 1985 Chevrolet Corvette fuel filter can be found next to the fuel tank. The fuel filter will be near the front of the fuel tank.

How do you remove the lock plate from a 1977 Corvette steering column with tilt and telescopic?

You don't need the $114 Lock Plate compression tool from some of the specialty tool suppliers. The $13 tool from Advance Auto Parts works just fine. Be sure to get the one that says for vehicles without airbags. The main bolt screws into the steering shaft and performs the function of the star screw - locking the telescoping shaft in place.

Where is the 1975 corvette horn relay location?

look up under the inst cluster by the steering column should find turn signal flasher and horn relay next to each other turn flasher should have purple and pink/white wires and horn relay dark green , red, and black wires