A person who was/is raised or settled in New York City. "New Yorker" does not refer to anyone who lives in the state of New York, but anyone who originated or settled in New York City.
My Definition: As a New Yorker myself, I would say a New York native would be a person who experienced a change in New York, knows their way around the area, and knows the better way of transporting around the city.
How do you charge the air shocks in a 1993 Chrysler New Yorker?
You don't if you have automatic stablizing. It's done automatically with the compressor located behind the rear passenger tire. If it isn't doing what it is supposed to, then it needs to be repaired or replaced. You can charge them manually, but it will not last.
No, plasma is not combustible. Plasma is not something that can be combustible without additional chemicals, as it is relatively cool.
Drive belt schematic 1993 new yorker salon?
Got mine at an auto parts store. Just ask them for a print out
How do you set the memory for the power seats on a 1993 New Yorker?
On the drivers door panel should be 3 push buttons. Once you have the seat and exterior mirrors in the desired position, press the "S" and then "1". The same can be done for a second driver, simply by pressing the "S" then "2". On the first 93 New Yorker we owned, you could even program a third position by pressing the "S" and then the 1 & 2 together at the same time. Our current New Yorker does not allow the third preset.
How do you fix the ABS system in a 1993 Chrysler New Yorker?
You more than likely have a defective unit. i own a '93 new yorker and my abs lights were lit on my dash, a few days later my brakes completely failed. ABS HYDRAULIC CONTROL UNIT CAN EXPERIENCE EXCESSIVE BRAKE ACTUATOR PISTON SEAL WEAR CAUSING PUMP-MOTOR DETERIORATION.
there is an open recall on this part, i got it replaced for free (a several thousand dollar job) less the cost of a diagnostic computer fee. here's a link with more info: http://www.motortrend.com/cars/1991/chrysler/new_yorker/recalls/index.html http://www.internetautoguide.com/auto-recalls/09-int/1993/chrysler/new-yorker/index.html
although the model year is '91 for the link ik believe they were still using the same abs assembly in 93. hope this helps.
What type of freon does a Chrysler New Yorker 6 cy 3.3L engine take?
What year? There are two types for cars R12 for cars up to 1993 It no longer made and if anyone has any they can charge you $100 to $150 per pound The other is R134a for cars after 1993 An older car MUST be retrofitted to R134a for $100 to $500 depending on what needs to be replaced
freonthere is only one type of freon. It's freon it will work in any vehicle
Totally incorrect! There are several different kinds of "FREON" freon is actually a trade name of Dupont for R22... Not an overall refrigerant. Anyone who has the certification to work on refrigeration equipment of any size will tell you it needs to be replaced with R134a. R12 is a refrigerant that destroys the ozone and has been banned by the EPA. FYI if anyone is caught putting R12 in for you they and you can be stuck with pretty hefty fines as well.
Where is the oxygen sensor on a 1992 Chrysler fifth avenue new yorker?
It is screwed into the exhaust manifold on the rear of the engine.
Where is the rollover fuel shut off switch located a on 1995 Chrysler new yorker?
It doesn't have one. Chrysler uses relays to control the fuel system.
Where is the thermostat on a 1989 Chrysler new yorker?
It is under the housing where the upper radiator hose attaches to the engine.
Where is ac heater blower located in 1990 chrysler new yorker?
In the HVAC housing behind the glove box.
Where is the tension bolt on a 1992 Chrysler new yorker alternator?
Assuming you have a serpentine belt on that 3.3L engine, the tension on the alternator would be controlled by the idler (tension) pulley. The alternator is
stationary.
The interior lights will stay on for about 30 seconds after the door is closed to allow those inside to see what they're doing. If the lights stay on after that, you may have a damaged door switch on one of the doors. You may also have the lights turned on manually, which is accomplished by rotating the headlight knob past the first stop. (Rotating the headlight knob dims or brightens the dash lighting. At maximum dash brightness there is a small "stop" in the knob rotation; rotating past this point will retain maximum dash brightness
What do the number 12 and 33 fault codes mean for 1993 Chrysler new yorker?
12-battery disconnect, direct battery input to pcm was disconnected within last 50 key-on cycles
33-a/c clutch relay circuit, an open or shorted condition detected in the a/c clutch relay circuit
How do you change the clock time on a 1991 New Yorker?
hit set button then the sel button and turn the tuner knob
Remove the valve cover and look for a loose or broken part.
What is the gas mileage for a 1995 Chrysler New Yorker?
I get about 22.9 to 23.6 around town. Haven't gone on enough long trips for awhile to get the road mileage but as I remember it was in the high 20's. Around 28 to 29.
Crankcase breather hose.
How do you know if you need to replace the blower if the heater in a '88 New Yorker gives out?
If it is noisy or it is getting voltage with a ground and isn't working, it needs replaced.
Where is the crankshaft position sensor on a 1995 Chrysler Concorde?
It is on the passenger side of the transmission bell housing, just behind the engine.
Where is the check valve on 1991 Chrysler new yorker salon found?
Fuel pump check valve is on the pump in the tank.
vacuum check valve is in the line going through the firewall.
Where is the starter on a 1990 Chrysler new yorker?
follow the red or positive cable from the battery
It is behind the engine mount on the front of the engine on the six cylinder.