0
Dodge D100
The D100 was a light truck that belonged to Dodge’s D Series product line. Similar to other D Series models, the D100 was made for the Israeli army and civilian market.
565 Questions
What were the Porsche 996 gt3 production numbers?
http://www.pca.org/tech/tech_qa_question.asp?id={219C2AE6-9E0B-43E6-A4D5-7394B3D6A1D8}
959 units per PCA
What is the firing order of a 1985 dodge ram custom 100 pickup 6 cylinder 225 cu in engine?
1 - 5 - 3 - 6 - 2 - 4
The distributor rotor turns CLOCKWISE
The marked # 1 position on the distributor cap faces AWAY from the engine
The engine cylinders / spark plugs are numbered 1 to 6 , from front to rear
You dont you replace the timing control module
sounds like the vacuum secondaries are not working properly, check this and it may be the solution to your problem. the wrong vacuum port from the carb to the distributor will also cause this
What transmission fluid do I use in a Dodge A833 manual transmission?
Regarding the A833 Manual Overdrive Transmission.....using Automatic Transmission Fluid as per Dodge's specs ( in a 1978 truck)....ate up the syncro rings in the transmission after about 50,000 miles and eventually seized. I believe this was a short-sighted attempt at increasing fuel efficiency ( lowering gearbox friction ). I have used SAE80 gear oil ever since in these gearboxes ( 1978 and 1889 trucks) with no further problems. Auto Transmission Fluid has no business in these gearboxes. That's a quote from the guy that had to rebuild my '78 gearbox.
Why cant you find a windshield wiper switch for a 1975 dodge d100?
Part # 3004 104 or 2864152 or nsn 5930-00-144-4994 you can find some online takes a little time.
What is the retail on a used 1988 Dodge D100 Pickup?
I just bought one today a 1988 marksman 4x4 half ton runs great every thing works 800$
Where is oil pressure switch on a 1988 dodge ram d100?
IF THIS A SMALL BLOCK LA V8 ENGINE, THE OPS IS PROBABLY LOCATED AT THE REAR OF THE BLOCK NEXT TO THE DISTRIBUTOR ASSM.
Where is fuse for wipers on 1978 Dodge truck?
in my '78 D100 Adventurer Texan SE, the wiper fuse is in the fuse box. The fuse box? In the glove compartment...left-hand side.
Estimate the change from a fiffty dollar bill if seven items cost 3.05 are purchased?
To estimate the change from a $50 bill when purchasing seven items at $3.05 each, we can first calculate the total cost of the items. 7 items at $3.05 each is $21.35. Subtracting this from the $50 bill gives an estimated change of $28.65. This is a rough estimate and the actual change may vary depending on taxes or discounts applied.
What are the torque specifications for Toyota 22R cylinder head bolts?
You will need a NEW set of 10 new head bolts ($40-45). They are supposed to be STRETCH bolts, and are therefore NOT to be reused. There is a bolt pattern. Torque three times at 58 foot pounds of torque. 20/22R/RE head bolts are not torque-to-yield (stretch), and are re-usable! Torque is 55-63 foot pounds. Thoroughly clean the bolts on a wire wheel and inspect for pitting, especially in the threads and replace as necessary. It is also recommended to re-torque them after about 1,000 miles. following the torque pattern, one at a time, loosen the bolt the least amount possible, and then turn to torque spec - 55-63, although many of us who do this regularly go to 70. Oh - and don't forget the "11th head bolt" buried in the pool of oil below the distributor gear, but it should only be torqued to about 14 foot pounds.
1979 dodge truck wont go In gear?
If It's 4x4, it may be in Neutral in the Transfer Case, or may need to have trannny checked out.
Where is the diagnostic connector on a 2002 Pontiac Sunfire?
check down under the steering wheel at the bottom of the dash
How do you remove wiper arm from 1993 Chevy silverado?
Lift the wiper blade off the windshield so that it stays at approximately 90 degrees. Down at the base is a little slide with an angled piece sticking up. Pull out on the slide and the wiper arm should lift right off.
What will the wheels from a 1977 dodge 4x4 half ton pickup fit?
They will bolt right up to a 90's ford ranger and work awesomely.
How do you wire a Dodge alternator?
On a dodge alternator the two small wires go to the voltage regulator . It doesn't matter which wire goes where, but the red or blue wire needs 12 volts when the key is on. The green wire goes directly to the regulator from the alternator. The large wire goes to the battery and it is important that you don't undersize this wire. The other wire is a ground wire and can be grounded to the block or not used as the case is grounded by the bolts that hold it on.
Why is dodge d100 360 engine backfiring out of right exhaust?
Your carburetor or timing needs to be set. Let a professional set it. Trust me, its worth the extra $$$.
1976 dodge d100 318 360 wiring order firing order?
The firing order for both 318 and 360 is; right side front to back, 1-3-5-7.
Left side, front to back, 2-4-6-8.
1-8-4-3-6-5-7-2
How do you remove headlight switch on a 1977 dodge D100?
start by taking your dash gauges out, that way you can see what your doing, self explanatory from there
How do you bypass the neutral safety switch on a 1988 dodge d100 truck?
you can disconnect the starter relay and run a wire from the starter wire in the connector to the power wire on it
p.s.
it is easyer to take a curcit tester and probe the connectors with someone truning the ignition switch to fine the starter
the starter wire is brown and im not sure about the power lead from the ignition switch
