0
Eagle Summit
A subcompact car from Mitsubishi Motors, the Eagle Summit was manufactured from 1989 to 1996. It was among the passenger car lines that marketed the network of Jeep dealer sales and services in North America.
136 Questions
Why do the call a tractor trailer truck a Semi?
You call it a semi because it pulls a semi trailer.
A semi is a type of trailer. A semi-trailer, as opposed to a full trailer, means it only has axles at the rear of the trailer and a full trailer has axles at the front and rear of the trailer. We call these in the UK "drags", as in wagon and drag, where the wagon that pulls the drag can carry a load on its own, whereas the semi-trailer truck, or tractor unit cannot carry anything without a trailer.
How do you pull engine codes on a 92 eagle summit wagon lx?
You have to recalibrate the muffler bearing first.
How do you replace a timing belt on a 2.4 Mitsubishi Eagle Summit?
Begin by removing all of the pulleys from the front of the engine. Remove the front engine cover. Remove the timing belt. Reverse the process to install the new timing belt.
What transmission fluid goes in a 1995 eagle summit wagon all wheel drive?
use only type 4 crysler trans fluid!!
Why would a 92 Eagle Summit stall while idling then not start?
key words "today my girlfriend was running some errands. while idling in a parking lot, our car stalled. When she tried to start the car, it would turn-over just fine but wouldn't fire off. then she noticed smoke coming from under the so yeah, now it turns over but won't start. this should mean the computer or mpi relay is shorted out! hope this help. signed the mad scientist
AnswerCheck the ECI fuse in the fuse box under the hood.I figured it out after about 2 weeks. I tried everything, distributor coil, vacuum leaks, the problem ended up being the ignition switch! Random eh? The ignition switch is grounded with the fuel pump. Bad switch, no fuel, no start. I figure I post this to help anyone else out there before you spend about 1200.00 dollars on average to replace the distributor and random shop fees trying to figure it out. I replaced it and hasn't stalled since.
Where is the number 1 cylinder on a 92 Eagle Summit?
The number 1 cylinder is the cylinder to the right when you open the hood.
How much does a truck load of eggs weigh?
That depends on the size of the truck, and how much is being shipped. There really isn't enough information to answer this question.
Where is the location of the barometric pressure sensor on a 1992 Eagle Summit 1.5 l engine?
The BPS is built into the airflow sensor on the air filter housing lid.
Why would your distributor keep going out on a 94 eagle summit?
bad ground wire from block to frame or distributor to frame or back to alternator if so designed.
87pontiac writes
Inside the distributor is the coil and sometimes the the epoxy that coats the the coil cracks and causes all kinds of headaches from starting problems to idling issues to misfire.
Build your air pressure up release your brakes and chock wheels.Back off slack adjuster just until it starts to pull out push rod from brake chamber (POT).Be carefull some auto slack adjusters have a prawl that has to be pulled out to back off brake.It will be right by the bolt that adjusts brakes.When you reach the point where the push rod starts to come out of the brake chamber,the brake is backed off as far as it will go.Make a mark on the end of your S cam and and on the slack adjuster.Adjust the slack adjuster tight to the brake drum.Any more than 120 degrees difference from the mark on the S cam and mark on slack adjuster is a fail.You can't determime the drum wear as the travel will vary depending on the thickness of the brake shoes.But this how inspection mechanics determine drumwear,with out pulling the wheels.If you have say 5/8"of brake shoes and are getting close to 120degrees your drums are probably over limit.If your brake shoes are at low limit of 5/16"your drums will probably be close.Keep in mind that 120 degrees of travel is a fail.Worn S cams,bushings,and slack adjusters can also effect travel.
How do you adjust the remote gas tank door release on a 1993 Summit so that it opens easily?
i am unsure how to make an adjustment to the release, but on mine the latch inside the tank door is bent in slightly, so the release on mine doesnt work. the door appears to be latched, but it easily open by pulling the tank door open.
What is the Ac compressor belt routing for a 1995 eagle summit 2.4 liter engine?
it goes from te a/c to water pump to crankshaft pully
Where is fuel pump on 93 Chrysler Eagle Summit?
fuel pump will be in the fuel tank, there will be an access panel hidden under the carpet so that you do not need to remove the tank from the vehicle. hope this helps
Where is the fuel pump at on a 1994 Eagle Summit?
in the gas tank, u gotta take the gas tank off from under the car that's wat i had to do there is some straps and u take them off and it should come off and it will be in the center of ur gas tank
Assuming all the normal tune-up parts and the engine it self are OK, the most likely cause is the distributor. These cars are famous for the distributors developing excessive play causing the electronic ignition to fault out. This shows after about 90,000 miles or so. Sooner if oil changes are not done. To check for this, remove the cap and check the rotor shaft for side to side play. Next most likely is the throttle body getting very dirty. This causes a bad hesitation off idle, then as it gets worse (more dirty), stalling at idle.
Where is the fuel pump at on a 1993 Plymouth Eagle Summit?
The fuel pump can be accessed by removing the lower part of the back seat. There is a round cover under the seat remove this and it provides access to the pump
this provides access to the fuel sending unit plug in which needs disconnected befor dropping the gas tank to get to the fuelpump .
How much does a tanker truck weigh?
The weight of a tanker truck depends on its size and carrying capacity. On average they weigh 80,000 pounds empty and can weigh as much as 100,000 pounds when full.
A timing belt links the crank shaft to the cam shaft(s) mechanically, to keep the cam(s) turning at the same rate as the crank, at a given, possibly variable ratio. that allows the right valves to be open at the right time during each stroke made by a piston. piston connects to crank, crank to cam, cam to valve. Make sense?
No it doesn't make sense, even though linked together by the timing belt the camshaft and crankshaft to not turn at the same speed, just look at the size of the camshaft pulley and the crankshaft pulley as they are different sizes the speeds are different!
What was the last year Eagle summit was made?
The final year of production for the Eagle Summit was 1996. The first Summit hit the road in the United States in 1989.
Where to put clutch fluid in a 95 eagle summit?
There is a diagram under the hood that shows you where all the fill points are located. The clutch fill is located next to the brake fluid on the driver side firewall.
What does the solenoid look like?
what does the solenoid look like when it is hooked up correctly on a ford e150 econoline van
