Electrical Engineering

When metal passes in front of the switch the magnet inside either makes or breaks an electrical connection depending on if it is a normally open or normally closed type switch. When the metal is removed the switch moves back to its normal position. These are particularly useful in applications where it might be exposed to water since the switch is completely enclosed. Connected to a relay the switch can activate or stop a hydraulic valve when a part has reached its proper position.

Comparator is usually a substance which compares two quantities; one quantity is the processed one and the other is a standard value to which the processed value has to be compared. Hysteresis is a property in which the change in the magnetization lags behind change in the magnetic field. Now, Hysteresis comparator can be described as a comparator which compares a processed quantity with a quantity whose value is standard for hysteresis property., the difference being given as the output

The input impedance of a current shunt feedback amplifier is the open loop impedance of the amplifier divided by 1+(A*beta)

Releasing Freon into the atmosphere is a Federal crime. Leave it alone as there is no need to release the R-12. Just remove the A/C belt if it only drives the A/C. If it drives other components, just remove the fuse. If you insist, then take the car to an A/C shop or your dealer and have them remove the Freon with the proper recovery equipment. You may even be able to sell it to them due to the extremely high price of Freon.

Milller's Theorem is used to simplify a circuit for circuit analysis. Instead of one impedance, which connectes two non-grounded nodes, Miller's Theorem allows this impedance to be broken down into two parallel impedances. One impedance can be seen as Z/(1-A) and the other impedance can be simplified to Z/(1-(1/A)). In this case, Z was the value of the original impedance, and A is the gain of the amplifier being analyzed.

Yes, cash flow can be positive while net income is negative.

It's likely a bad cable off the #2 seat motor. See this link: http://www.volvo-forums.com/t18304-850-seat-back-cable-repair.htm

it is not a good idea. the alternator is selected to meet the needs of the electrical system. Check to see what the maxium amp load is. It may cause a fault light to show up. the computers are set up for specific amps. Check to see if similar Volvo models of the year use a 70 amp alternator. hope it helps. duboff

Rolfo says: I have done this with acceptable results, although I will agree that it is not recommended. If you must use a different amperage go for more amps, not less.

if you want just another factory motor dropped in it that would caused $1950-$2300

tune up. new plugs wires and distribitor cap. and maybe new fuel filter and air filter

In an atmosphere of World War II hysteria, President Roosevelt, encouraged by officials at all levels of the federal government, authorized the internment of tens of thousands of American citizens of Japanese ancestry and resident aliens from Japan. Roosevelt

i would think it should put out from 12 to 15 volts.you will need to check output also with lights on an if it drops in voltage you probably have a bad alternator,most auto parts stores can test the system for you.

i had a 1983 ford ranger 4x4 4spd, best truck i ever owned. from past experience I've found if you have the will there's a way. I've seen 8 cylinder v-8's incorporated into the same truck.

if they are the the same transmission you can, but if you are going from a 4L60e to a 700r you need to modify your tourqe converter Locke up connector. if you look in Summit or Jegs catalogs, they carry adaptors ect,

You can't run a 6V 75A (450W) light off a 12V 2.5A (30W) battery for any significant length of time. That battery is grossly undersized. I think that's supposed to be "0.75A" instead of "75A." I found a 75-watt light bulb on the internet, but 75 amps? You could weld with that much power. And I like the answer right below this one best: just wire two of these bulbs in series. The answer is simple by using the formular called OHM's LAW (V=IxR) The 6V,3/4 amp bulb has (approx) 8 ohms resistance which 'drops' the 6 volts across it. At the same current (thru the SERIES circuit) you need anothe 8 ohm resistance. Unfortunately, the bulb dissipates 4.5 WATTS of power, the same as your 'extra' resistor will have to handle. (Rather WARM!) The easiest trick to do would be to put two 6v bulbs together in series, this will put your 'extra' resistor (the second bulb's filament) inside of a protected glass shell. The second bulb will not waste any more power than the resistor, and will give you twice the light.

a diagram that tells how two variables are related

To discharge static electricity, it is a good idea to touch a metal object, like a car, when you are trying to fuel a vessel. Also refrain from smoking or using a cell phone.

A rig might be a slang term for a large truck that hauls a trailer. A rig might also be the act of manipulating a vote so that it turns out a certain person is the winner. A rig is also a type of fishing set up to catch fish with a net.

A solenoid valve is a valve controlled by an electrical coil. A spring keeps the valve closed. When power is turned on to the coil, a plunger is pulled, opening the valve.

The fundamental purpose of an inductor is to

store electrical energy in a magnetic field.

Surge absorber is not accepted terminology. More information is needed.

You can do an internet search for the term and you will get an answer.

Depends on their experience and what the facility is willing to pay them. North Carolina has both public and private hospitals, and the pay rates vary. Your level of experience would affect your pay rate... the military background wouldn't get you paid any more, however.

You cannot have 380 V between 'phases'. You can, on the other hand, have 380 V 'between lines'! '380 V between lines' refers to the voltage measured between any pair of line conductors in a three-phase system.

house lights

its convert to ac current to dc current