0
Ford Bronco II XL
The Bronco II XL is a compact sport utility vehicle (SUV) manufactured by the US-based automaker Ford Motor Company. This vehicle is smaller the Ford Bronco and features an optional four-wheel drive (4WD).
321 Questions
How hard is it to replace a car starter?
Replacing the starter itself is really easy... Just un-bolt it and remove the electrical connections and then do the reverse with the new one.
However it can be very awkward to get at all of the bolts and connections. It will take longer but it might be best to remove all obstructions that are in the way so you have better access to it, rather than struggling which may result in damage to yourself or components.
How do you change a fuel pump relay on a '89 Ford Bronco II xlt?
The relay should be under the fuse box under the hood. You need to take the fuse box out and there is another panel that is upside down under it that holds the relays.
How do i ensure the crankshaft is at bottom dead center?
Align the piston number 1 (in firing order) at its bottom most position.
Is the 84 ford bronco 2 Eddie Bauer edition manual or automatic?
Bronco II Eddie Baur Edition are Automatic Transmission..unless someone has swapped it after-market.
What is the top speed of a 1988 bronco 2.9 liter?
Depends on if it is automatic or manual. Automatic I'm not sure, manual I have seen about 88 MPH, which is far beyond what I recommend anyone driving this vehicle at.
What is the space between the front seats in a 1988 Bronco II?
I have an 88' Bronco II Eddie BauerEdition, 2-WD. I also have the repair book on it as well. Some models came with a floor console, including an armrest that attaches to the top of the console. From time to time you can find oem's on eBay. If your truck, like mine, does not have the holes drilled for the console, you can drill them and still add a console.
How do you remove a gas tank from a 1995 Chevy caprice to remove a fuel pump from the tank?
if you can, try and use as much gas before working on your car. It is better to use a hoist for this job. The car needs to be jacked up, you'll need to drop the tank. There are two bolts that are used with the tank straps. Before you loosen them be sure to support the tank, with ply wood and another jack. once lowered, disconnect all fuelines and wiring. Unbolt the sending unit, pull it out of the tank slowly. replace the pump make sure there is good ventilation. keep a hose near by. Also make sure to check the fuel pump box for a gas screen, you'll need to replace itaswell. while you at it do the fuel filter
--------------------
Do NOT use a trouble light while you do this job. If gasoline hits the hot light bulb it will cause the bulb to burst and it can set the gas aflame. I use either a floursecent bulb style trouble light or a flashlight. Also use wd-40 on the gas tank strap bolts as they will probably be rusty.
How do you fix a starter in a 1989 Chrysler Lebaron 2.5 Turbo and how hard is it to replace?
The starter is hard to get at under the fuel lines and junk on the drivers side of the engine compartment. I had mine done by a mechanic because it was to difficult for me to get at.
What engines will fit a 1992 Toyota Paseo?
Check out toyotanation.com They have a forum dedicated to paseo,tercels,startlets They also have a common engine swap guide there.
What could cause the heater or defrost to NOT blow warm or hot in a 1988 Ford Bronco ll?
Blocked heater core, faulty heater valve, disconnected connection to the heater valve.
The wire from the fuel tank float unit to the gauge could be shorted to ground, or else could be open(disconnected). The float unit, if a brass "tank" type is no longer airtight, allowing fuel into float & causing it to drop to bottom of tank (where it would go if tank were empty). If float is like neoprene, it may now soak up gasoline rather than float in it--causing a heavy, fuel-logged float to again sink.
There is a retaining ring that spins on and off. There is a retaining ring that spins on and off. There is a retaining ring that spins on and off.
What size gas tank does a 1988 Bronco II XL 2.9 have?
The '84-'88 Bronco ll came with a 23 gal. gas tank. The '89-'90 with a 15 gal. tank.
Where is the fuel pump located on a 1993 bronco?
A fuel pump on a 1993 Ford Bronco is located on the top of the gas tank. In order to change the fuel pump you will have to drop (take) the gas tank out. It's best to soak the bolts and nuts for the tank straps in penetrating lube (spray) before you attempt to remove the straps. When you take the tank out its a pain to get it back in it the lip on the tank is a hair to big to fit in the frame rails... (Good Luck)
What could cause oil in your coolant overflow and radiator but no coolant in oil in a 91 Seville?
COULD BE ATF LEAK TRANNY FLUID GETS COOLED BY RADIATOR MAYBE BAD RAD. CAR RUNNING HOT?
91 Seville's use coolant tabs from factory, that can lead people to think they have engine problems. You should have your car a check by a mechanic who can use special tools to check for blown head gaskets or other problems.
What performance engines will fit in a 1995 Geo prism?
A 1995 Geo Prism can accommodate a range of performance engines, primarily due to its shared platform with the Toyota Corolla. Popular options include the 1.8L 4A-GE engine, known for its high-revving capabilities and tuning potential, and the 2.0L 3S-GTE turbocharged engine, which offers significantly more power. Additionally, some enthusiasts may consider swapping in a 2.4L 2AZ-FE engine for more torque and performance. However, modifications to the engine bay, drivetrain, and exhaust may be necessary for these swaps.
Spark plug gap setting on 1980 with 351 Windsor engine?
i have read at another site that it is around .044
How do you remove the gas tank on a 94 Buick Century?
The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
