0
Ford Escort GT
The Escort GT is a compact car manufactured by the US-based carmaker Ford Motor Company. The Escort GT features a TRX handling package, rear and front spoilers, fog lights and metric-sized alloy wheels.
426 Questions
How do you set timing for 99 ford escort?
you can't, it's all controlled electronically in the computer
Can you put a 302 motor in a ford escort gt?
yes. i put one in a 90 accord and a tempo tranny mounted up
How do you put gear oil in escort gt 5 speed?
this uses ford transmission fluid NOT gear oil in the manual transmission. Filler is on the top of the Transmission and is NOT meant to be changed for the life of the Car. I currently have several of these and even at 350,000 have not changed the fluid.
What makes a Ford Escort automatic transmission stopped working after a filter change?
the O ringseal is not in right, the pump is sucking air
Formal words are words that are NOT slang, words you would use to show respect to someone older than you e.g. school principal, teacher, prime minister etc. etc.
here are some words i found:
-surely
-greetings
-definitely
-certainly
-probably
-farewell
-maybe
words like that.
hope that helps!
Where do you put transmission oil in standard car?
where do you put transmission oil in a standard car?
Does your timing have anything to do with your crankshaft?
Yes, if your timing is off, then the spark plugs will not fire in the crank shafts correct positions, causing lose of power and sometime sever engine damage if the timing is off by alot.
Purchase a Haynes or Chilton's repair manual at any auto parts store. Here you will find all the valve and torque specs.
How do you replace the serpentine belt on a 1991 ford escort?
check the following: idealer wheel is a 15 mm spanner and is spring loaded. from the floor push back and remove the belt from the lower pully. you need some work removing the water tack and power steering oil tank. this ifo is based on LX 96
Will a 93 Taurus sho 3 liter engine bolt into a 95 Probe GT with little modifiction?
I am working on this right now and when I know for sure I will post another answer, but here is what I do know. It is not a bolt in swap and there is fabrication required, I dont know your definition of little modification, but I dont think it is as much as most people believe, Every thing I found on the net says that it is not easy not cheap, and a waste of time, I plan on proving them wrong. Here is where I am at so far, I am using a 5 speed out of a first gen probe because it is smaller lower geared and has a hydraulic clutch unlike the sho trans with a cable, the flywheels are exactly the same between 3.0 probe and the sho 3.0 a probe 3.0 clutch will work fine and the first and second gen probes are not that much different so the axles will be less of a headache with the probe tranny. I have both the motors out and have meausred the overallwidth of the motor and trans and how much room I have to work with and it is tight but not impossible I may have to do some clearancing on the frame towards the firewall for the accesories. since the sho motor has more power and torque I am fabricating a cradle to hold the motor mounts on the passenger side and reinforcing the core support underneath the radiator. I will be test fitting the combo pretty soon.
What is the cylinder head torque for a 1600 kent formula ford?
65-70 ft/lbs - see sequence below.
do it in 3 stages: 25 ft/lbs, then to 50. Wait 15 mins then do final tightening : 65-70 ft/lbs. Work your way from the middle bolts toward the outside in a opposing cross hatch pattern - see below for the sequence. This applies to unbolting the head (in reverse: ie work from 10 down to 1):
9 3 1 5 7
8 6 2 4 10
What is the spark plug gap for a 2002 Ford Escort SE?
Check the Vehicle Emissions Control Information ( VECI ) decal located in
the front of the engine compartment ( it will show what type of spark plugs
to use and the spark plug gap )
Can you replace the fuel pump on 1989 escort through the back seat?
no you cant. to replace the fuel pump for this model you have to remove the fuel tank. to remove the tank you have to pick up the car.
What is cost to repair clutch on 1995 Ford Escort GT?
500-800 pending where u go and what clutch u get put in make sure u get a new pressure plate, clutch disk, release bearing, pilot bearing, and flywheel resurfaced
Pre 1997/9 models of Ford Vehicles were self-adjusting via the clutch-foot-pedal. The pedal engages a ratchet system called the QUADRANT & PAWL and is part of the pedal. The mechanism is very similar on older Ford models of: Escort, Fiesta, Sierra, Granada, Transit & others. Newer vehicles may have a Hydraulic Clutch from 1997/9 onwards, and these work differently from the cable & pully mechanism. Clutch-fluid can be bled to improve the ability to operate the clutch, however this is not necessarily a method of adjusting the clutch.
If your reading this article because you have a broken clutch-pedal then please read on.
If when pressing the foot-pedal it feels like cable is broken, or pedal is loose, ...This is symptomatic of failure of the QUADRANT & PAWL 'ratchet' mechanism due to wear of teeth on the ratchet.
In some cases the pedal fails to pull the clutch out far enough to change gear, and may make a 'springing noise'. This is due to slippage on some worn ratchet-teeth, but the mechanism has not reached full failure. There are 2 ways to remedy the fault.
1. Change the Quadrant & Pawl, using only genuine Ford parts. #Beware of inferior mouldings that are not up to standard e.g. too soft, and do not trust 'pattern-parts' on eBay etc.
2. SHORTEN THE CABLE.
- Disconnect SPRING ON THE FOOT-PEDAL to release ratchet mechanism.
- Clamp cable slack (engine end).
Where is the crank sensor located in a 2002 Santa Fe with a 2.4L engine?
it is behand the plate on the bottom pulley The crank sensor is located behind the timing and balance shaft belts. depending on condition/age of belts, you may want to consider replacing them both. Note: if you plan on doing this repair yourself you'll need to research how to properly align the oil pump pulley.
How do you get a steering wheel off without a puller?
The simple answer is you don't. Most advance auto parts or some other large auto parts chain stores have loaner tools. Stop in one and ask they may have a puller.
Is the 1987 Prelude 2.0SI fuel pump outside the tank like the 1986?
the fuel pump on an 87 prelude is in-line. under the drivers side right in front of the rear tire. you must first remove two covers and disconnect the pump to get it out. a lift is highly suggested.
How do you take the instrument panel off of a 1992 ford escort lx?
Disconnect the negative bat. terminal. Remove the instrument cluster. Remove the hood release cable. Remove the retaining screws and detatch the left and right lower dash panels. Remove the glove compartment and ashtray. Remove the heater control assembly. Remove the center console. Remove the steering column U bracket and lower the column and support it. Remove the defroster grille and the defroster ducts at each end of the instrument panel. Remove the upper and lower panel bolts at each end. Remove the panel frame from the floor bolts in the center. Remove the mounting bolts that attatch the instrument panel to the cowl at the base of the windshield. Pull the instrument panel back and disconnect all electrical fittings. Remove it from the door opening.
Are there grease fittings on a 1999 ford escort wagon?
There are not any grease fittings on a 1999 Ford Escort Wagon. The vehicle uses sealed bearings instead of grease fittings.
Where is the engine coolant temperature sensor on a 1989 ford escort gt?
the sensor is located on the thermostat housing
