0
Ford Windstar
The Windstar was a minivan manufactured by the American automaker Ford Motor Company. This front wheel drive (FWD) minivan was manufactured in two generation models from 1994 to 2003.
2,843 Questions
Where could one purchase a sliding door wardrobe?
A sliding door wardrobe can be bought or purchased from various sources. Amazon and eBay are examples of stores that one can obtain this item. Most shops that sell furniture also stock this kind of wardrobe.
replace the radiator cap. I fought this for 2 days . after changing theromostats twice and bleeding air from the system, I finally changed the radiator cap and solved the problem.
Why do the blend door actuator motors break on Ford Windstars?
Something falling into the ductwork could have jammed the blend door - causing the very very small plastic gears inside the actuator to break off some teeth.
Another reason could be these units are just under-engineered for a long life and break easily with normal usage.
See "Related Questions" for in-depth discussion on replacing actuator motor
Where is the intake manifold runner control valve on a 1996 3.8 ford windstar?
attached to the lower intake manifold on the belt side usually little plastic bushings are broken on those
Why 79 ford bronco starts fine but runs rough at acceleration?
i blew out all of the junk out of the carburetor on mine and i timed it to about 10-12 degrees and now it purrs at idle and on accelleration if that does not work u might have a vacuum leak somewhere
you must purge th system you have a air lock allow the vecile to run with the rad cap off till it get warm the shut it down till it cools add collant you may have to do this a few times........rosdale joe The way I did it was to fill up my radiator, then turn the car on. When its getting to the normal temperature is when it starts to pour water to the reservoir.... at this point you turn your heater on on high and the neddle to the hot possition... this should bleed the cooling system. Also check the preasure on you radiator cap.... the [problem on my car was the radiator cap.
How to step-by-step replace a head gasket on a 1998 Ford Windstar?
I just finished doing that on my van and its also a 95. I removed the fans, then the A/C pump and the Power Steering pump, afterwards I removed the intake manifold. after that remove both exhaust manifolds and then you should have a clear room to take the heads off
You'll need to remove everything in the way, pull the rocker cover, remove the head then take the head to a machine shop to have it milled. Almost every time the head gasket blows, it's because the head is warped from engine overheating. Do NOT try to put it back together without having the head tested/milled by a qualified machine shop. You can't determine if it's flat just by looking at it. Only a machine shop can do that for you.
Where do you find out about Ford Windstar recalls?
eRecalled might be able to help. They provide a free service to anyone that keeps them informed of product recall information.
2 more sources:
- Autozone - register and select / save your particular vehicle. Then under "Repair Information" is a link for a roundup of recalls for that vehicle.
You'll also find a tremendously outstanding free repair manual. - Internet AutoGuide - found this link in another answer - not the easiest to find the recall info, but it's definitely there - See "Related Links" below
See "Related Links" below for more sources
2009 Brake Leak Recall information - also see "Related Links"
How much does it cost to replace front struts on 2000 ford windstar?
This could be an expensive repair coming in around $300-400.
It's also a repair that an above-average backyard mechanic can do!
See "Related Questions" below for more
How do you reset the anti-theft system on a 1999 Ford Windstar?
how do you reset the anti-theft system on a 1999 ford windstar
What are the fuel pump fuses and relays for a Ford Windstar?
1996-1998 ModelsEngine Compartment - Fuse/Relay "N"
1999-2003 ModelsEngine Compartment fusebox - fuse #5, and relay #207
NOTE: You really need to have a diagram in front of you when looking for these specific fuse/relay locations. The Owners Manual is a good resource.
Autozone's free online Repair Guide is another source of fusebox information and illustrations.
See "Related Questions" below for links to free, downloadable Windstar Owners Manuals
Answer Look on you radiator support their is a block about 4" x 3" with the id# 12b577 on it that is a relay pack it houses 4 relays that are not serviced separate from the unit.. it called the powertrain conrole relay. about 140-200 depending on the model.
Answer what is the problem is the vehicle not starting? try the reset button at the back of ur van behind the jack see if that works first.
AnswerI would guess try replacing fuel pump, But before you do , spend 20.00 bucks on a Haynes manual at your local Auto Zone or Advanced Auto and do a little multi-meter work before buying the wrong part. Everything is electronic so you never know. I had an older Ford Tempo once and the fuel pump did the same thing then eventually went out and had to replace. Hope this helps!!Added by CamaroLuver: Kudos on the mutimeter advice! Better than going out and buying a bunch of parts, and doing the guess work. It COULD be the fuel pump then again could not. Just because you replaced the relay doesn't mean it's working right. Touch the fuel pump relay when you don't hear your pump come on, have a friend turn your car on (not crank) and see if you feel the relay click over. If not then you aren't getting power to your relay. Then it's a different problem entirely. Wiring, a ground, possibly computer problem, do alot of testing before you go out and buy parts. Also test if you have spark before you rule out to be a fuel delivery problem (which I'm guessing it is) I learned that the hard way. Had the exact same symptoms, bought a new relay, went through 3 pumps before we realized it wasn't either one, got a new ignition coil and switch, ECM, fuel injectors. Turned out to be some bad wiring and a fusible link. Electrical problems are the greatest!!! :-p *sarcasm*
Why does a 1998 ford windstar take off in 2nd gear?
This could be a problem with the transmission forcing it to go into 'limp mode'.
Anyway you look at it, you're going to need to find a reputable repair shop to run some diagnostics to pinpoint the source of the problem
How do you replace the electric window motors in a 1995 Ford Windstar?
You can get them from the dealer as OEM, NAPA, Etc can order.
If you are familiar with body work on a car, it is a d-i-y but the local body shop would be the best one to go to. Have to take the inside door panel off, maybe pop a clip or two, change out the electrical unit. We have done 3 different windows on different Ford Aerostars. Pretty much all the same. Takes about 30 minutes tops if all goes right.
Depending on if you have the "pats" system. The chip in the key, you may have to reset the system. Try and use all the ignition keys you have. When you try and start the vehicle, look to see if the security light flashes fast. If it does, then the security system does not read the code. Disconnect the negative terminal on the battery for about fifteen moinutes. place the igition key on and try and start again. If that doesn't work you may have to go to the local dealeer and have the keys reprogramed to the vehicle. Good Luck.
Contract your Ford dealer for the recall information for our specific vehicle.
When I had the same problem it was a fuse that kept shorting out. And I had to unplug the wire going to the bottom of the brake cylinder because of a brake fluid leak that was shorting out the wire.
Hmmm. This sounds like a problem in the instrument cluster module. The module gets a signal from the transmission sensor that gives it a count it uses to calculate miles driven and current vehicle speed. This signal also goes to the computer that calculates the mileage. There is also a fuel flow sensor that tells the computer the current rate of flow of the fuel. The chances of both of these sensors going bad at the exact same time is probably slim. The fuel computer error is simply because one or more of the values it needs to calculate MPG is missing or corrupt. Since you also have no speedometer function look first at the transaxle speed sensor.
Having said that, it could be any of the following:
Bad fuse in the circuit that powers the sensor or it has come unplugged at the transaxle.
Bad sensor.
Bad instrument cluster module.
Note: There is no speedometer cable any more. Everything is done by electronic sensors and computers.
Of course it could be oil leaking just like the other fellow said. Carl
Where is the speed sensor location on a 1998 ford Windstar?
If the speed sensor is for an Anti-lock braking issue, you will normally find 1 at each wheel (accessible when the wheel is removed). Another location would be on the transmission. How about where on the transmission? Like on the bottom behind the exhaust pipe!
You probably have a faulty temp blend door actuator in the front. It is located directly behind the radio on the front of the AC/heater case.
Is it ok to ride a Yamaha blaster without the back half of the exhaust pipe?
it will run, but the removal of exhaust components can result in a decrease in the system back pressure. That can cause a problem with proformance, and may lead to problems with the motor. It is a matter of making sure the amount of air going into the motor and out are right. If you are going to take it off, check to see if the air in is okay to the air out. it probably won't cause a problem, but thought you know that they can happen. hope it helps. duboff
How can you tell if your fuel pump is bad?
When u turn key on , you should hear a humming for a few seconds. this is the fuel pump priming (sending fuel up the line). If you don't hear it, fuel pump is not working.
High Engine rpm While Changing Gears?
Automatic trans I take it, sounds like you may need to rebuild or replace soon. The gears could be warn and are starting to slip
Which is number 1 spark plug on 2002 ford windstar?
On a 2002 Ford Windstar , 3.8 liter V6 engine :
firewall
1-----2-----3
4-----5-----6
front of vehicle > driver
Why won't my 2001 ford windstar passenger door slide open when i push the door opener?
It could be that the door lock actuator isn't working.
If you hear the door opening mechanism cycle when you push the button, I would be very suspect of the actuator.
See "Related Questions" below for more
Where is the heater intake tube on a 2003 Ford Windstar Coooling System?
The air intake for interior, aka 'cabin' heating & cooling, is located in the engine compartment. This air intake has a filter on it.
Look for a 10" long by 1.5" tall cover in the plastic cover / trim / housing, just underneath or engine-side of the passenger wiperblade.
Remove the cover and the filter is located just inside.
What can cause the interior lights to not work when the door open on a Ford Windstar?
- There is a spot, all the way down, on the dimmer 'scroll-wheel' type dial that will disable the interior lights
- When I had one of those common problems with the false 'door ajar' situations, my 2001 SEL deactivated the interior lights. Once I resolved the false signals coming from the liftgate, the interior lights automatically started behaving normally all by themselves.
See "Related Questions" below for more
