0
GMC Sierra
The GMC Sierra is the latest series of full-size pickup trucks from the American car builder General Motors. The GMC Sierra is known for its luxurious interior, unique grille and four-wheel steering system.
2,525 Questions
What makes transmission clunk when it down shift at 30 mph?
Possibly weak u-joints or transmission mounts
What could have caused your 1999 gm z71 sierra 4wd to catch on fire sitting in the driveway?
next time your sitting alone in the truck check once and awhile the heater off your joint!Dont let it canoe!,sure FIRE way to not have a truck in the morning!!
Picture and how to change Chevy 4 wheel drive right front cv shaft?
Get the wheel of and take the axle nut off the centerof the hub at other end of axle take out the 5- 5/8 bolts out of the flang at diff side turn steering to the right and axle will fall out the bottom.
Where is the IAT sensor located on a 1993 GMC sierra?
Remove the air cleaner housing. Look for the IAT sensor with the two wire connector that you unplugged while removing the air cleaner housing. That sensor? Yeah that's the one you're looking for.
Are automotive batteries 6 amp or 2 amp?
a gmc battery can be from 500 to 1000 cracking amps. if you are using a 2 or 6 amp charger the 6 amp will charge faster than the 2 amp.
Where is the water pump located on a 1998 GMC Sierra extended cab pick up?
Open the hood of your truck. Look inside the engine bay. See the fan assembly and the pulley that the belt rides on. The water pump is behind the pulley. Changing water pumps can be somewhat of a task. Professional help will be needed for someone that can't find the waterpump.
Location of knock sensor on a 2005 GMC sierra 2500?
That engine has 2 of them and there both are underneith the intake manifold. You can not see are get to them until you remove the intake.
Where is the coolant temperature sensor on a 2002 gmc sierra?
The 2002 GMC Sierra: temperature sensor is located on the front of the engine. The sensor will be just above the thermostat housing.
How do you remove power steering pump on a 1994 ford scort lx?
with a power steering puller, which can be rented at Advance auto parts or Auto Zone
How do you disconnect the hydraulic line from your transmission?
they make a tool for it but where the line goes in trans there is a white band plastic push in band with screw driver all the way around line and pull it should come off
How much horsepower does the vortec 4.8 liter v-8 engine have?
2001 and up produced 270-285hp with 285-295ft-lbs torque.
How much should it cost to replace the water pump in a 1999 GMC Sierra 1500?
I know it cost me about thirty bucks to buy a new one for my 1990. Not sure bout your 99 but should be similarly priced.
Not a big deal to replace on the 1990 either since all the brackets holding the accessories on do not have to be removed before you can get to the water pump. You will need to check this out before going to get an estimate on the labor so they wont shaft ya! If indeed the brackets are not mounted in front of the water pump, like the 1990, the labor shouldn't be over a hundred bucks from an honest shop. I'd guess about up to $60 more if brackets have to be removed.
Where is the plug to connect an extension cord on a 1996 GMC Sierra?
its usually inside the grill or tucked under by the front bumper
How can you fix the clutch in a 1992 GMC Sierra?
Clutch repair for a 1992 Sierra will depend on the problem. Clutch systems consist of the clutch, pressure plate and a master and slave cylinder. These parts are not repairable, and the part that has failed will have to be replaced.
1997 GMC sierra four wheel drive not engaging?
I have a 1997 GMC 1500 4 Wheel Drive. When engaging 4 wheel drive there is a popping noise (different than and in addition to the normal sound of it engaging) and it does not always engage. Then it will even have a popping noise once engaged. Any ideas? Thank you for your input. Stan
Where is the fuel pump oil pressure switch on a 97 gmc sierra?
fuel pump oil presssure switch is at back of motor just under the dist.On a v8
Esc module location 94 Chevrolet 1500 and wire color for knock sensor?
Looking for the ESC myself....the Knock Sensor wire is blue though.
How do you change the low beam bulb on a gmc sierra 2005?
How do I change the low beam bulb in a gmc sierra 2005?
How do you replace a tail light in a GMC Suburban?
*** Open the rear doors and secure them so you don't get hit by them while you do this *** Look in the sheet metal directly behind the tail light assembly you wish to fix. There should be two rubber plugs; if so, remove them to gain access to the bolts that hold the tail light assembly. I would recommend a magnetic tool, as these bolts can slip and fall into the crevices back there! Rotate the assembly away from the body. If you try to pry the unit off, you will break the mounting tabs located in the forward portion of the tail light assembly. This means you have to grasp the inside part of the assembly that is closest to the middle of the 'burban and rotate them forward towards the front of the vehicle. For example, the rear passenger side tail light assembly would be rotated out in a counterclockwise motion towards the fromt of the vehicle. Unscrew the light bulb holder assembly and remove the bad bulb. Replace it with an exact replacement, and use the dielectric grease! It keeps out the water and prevents the corrosion of the bulb contacts. Hope this helps!
