The easiest way to replace the stud without taking out the hub, is to shave a part of the stud head so it fits in the cramped area, and first cut off the old stud for easy removal. But the right way is to remove the hub with either a machine press or axle remover, which you can borrow from an autoparts store. Just be very careful not to bang the the hub much which can damage the inernal bearings.
What oil filter do you use for a 2008 Honda accord?
Go to any Auto Parts store and they will tell you the correct size. I recommend Purolator, Wix, or Bosch filters. All are quality filters. I personally use Purolator in my 2004 Accord.
What is wrong when a 2002 ford escape won't stay started when you press on the brakes?
Or Check To See If your Idle Air Control Valve Is Sticking shut.
This happened to mine a few years ago. As mentioned above, I replaced the IAC Valve and it was immediately fine. The part is about $65 and is extremely easy to replace. Anyone can do it. Two bolts and an electrical plug... that's it.
...
Can YOU use lucas transmission fix in 1999 HONDA accord?
i have a 97 acura integra with slight hesitation when shifting and i was wondering the same thing. from what i have found on the internet i think it would be okay to use...
When is it necessary to replace a timing belt on 1996 Honda Accord with 65000 miles?
80,000 miles or 10 years, whichever comes first. Also replace the water pump at the same time. This is an interference engine. Severe engine damage will occur, if the belt breaks. And it will break without warning.
How do you change rear deck speakers in a 1995 accord?
Through the trunk you'll find 3 screws on each speaker that are holding on the speaker covers. Unscrew those, then from inside your car the speaker covers will lift right off. Also while your in the trunk your going to want to unplug your existing speakers. After you've done those two things, from the inside of your car, lift off the speaker covers, unscrew your existing speakers and lift them out. The 95 Accord comes from the factory with 6 1/2 in. speakers so this means that the speaker bracket or adaptor holding in the speaker is only that big. 6x9s dont fit in the factory bracket, you'll have to take that one off and buy an adaptor that will fit a larger size.
How do you remove and install exterior door handle on a 2001 Honda accord ex?
You will have to take off the door panel and unscrew two bolts from the inside. You might be able to do it with the window all the way up.You'll have to loosen the lower window guide. remember how it's set up before you loosen stuff and make sure you have a diagram of how all the different internal parts in the door go. You can get this from the dealer parts dept. usually.
If you look under dash on drivers side there should be a rubber plug in the fire wall pop out plug drill hole into rubber plug the size of your power wire. run power wire through hole. Remove kick panels and lower door trim tuck power wire under carpet replace trim. Just repeat process on 2nd door pop up back seat run under carpet in to trunk. Also it is best to go ahead and run a 0 gage power wire from front to trunk so you will not have to repeat process later. Just connect you power wire to a distribution block. This will give you up to 4 power wire connection points for add ons later.
it could be your thermo stat
What 2000 through 2002 used car is the most reliable?
ford f250 2001 most reliable vehicle i have ever had
My check engine light came on in a 2001 Honda Accord EX?
Usually a problem in the emission control system. Have vehicle scanned to determine the problem
Where is the transmission dipstick located on a 1987 Honda Accord?
ok, this might be a little complicated to describe, but bear with me... ok. open the hood, and look for the oil dipstick. if you know where that is then were can get started.. now have you ever changed the oil in a lawn mower? if you have you then you know what the dipstick looks like. Well, the tranny dipstick looks just like that... from the left of the oil dipstick and left from the edge of the engine, look down under some hoses and there it will be, down a bit and if your car is running then you will probably burn your hand on the hot parts....pretty much it is north east a little bit of the passenger side headlight. , i had trouble finding mine too so i know what you mean...
When you do find it be sure to chek the fluid with the engine OFF! These are noe of the few cars that you check with the engine not running.
Where is the transmission fluid dipstick located on a 1993 Honda accord?
If your car is 5-speed, there is no dip stick. The fill plug is the check on them. Unsure where there's one on an automatic.
Try a 1988 323
Where is the front oxygen sensor located on a 2001 Honda accord?
After the exhaust manifold but before the catalytic converter on the exhaust tube.
How do you remove the sterio in a 94 Mazda b3000?
1. Remove the instrument cluster trim panel 2. Insert a radio removal tool available at most auto parts stores, or equivalent, into the radio face plate, push the tool inabout one inch to release the retaining clips on each side 3. Using the special tool, pull the radio partially out of the instrumant panel, then disconnect the pwer, speaker and antenna wires from the radio 4. Pull the radio assembly out of the instrument panel 5. Installation is the reverse of the removal steps. - Haynes Manual #36071, 1993-2005 Ford Ranger Pick-ups and 1994-2005 Mazda B-Series Pick-ups.
Does a 2001 Honda civic have a timing belt or timing chain?
timing belt and you need to replace it every 60,000 miles
Where is the water pump located at on a 2000 Honda Accord?
The water pump is driven by the cam belt. The lower radiator hose connects to the water pump.
Does a 2004 Honda Element 4 cylinder have a timing belt or chain?
I have the same question and searching for it
How do you open a door on a Honda Accord 1990 if the door want open with the handle.?
if you pull on the handle but the door doesn't open: you have to order the clip that is attached from the handle to the door. it's only 5 bucks(maybe less) at the dealership. then you pull the door panel off and replace the rod with clip. it is probably your clip that is worn, not the rod. i replaced the rod because i bent mine.