0
Honda Accord LX
The Accord LX was launched in 1978 as a 3-door coupe and was later re-designed as a 4-door hatchback and 4-door sedan. The latest model is available as a 4-door sedan powered by a 2.4 liter engine.
4,658 Questions
Why does a 1999 Taurus blow hot air when set on vent even though the outside temp is cool?
Keep this principle in mind: Heat, flows INTO cold... When you hold an ice cube in your hand, your hand gets cold because the heat from your hand is flowing INTO the cold ice cube, NOT because the cold is flowing into your hand.
On this particular vehicle (like many modern vehicles), hot water from the engine flows through the heater core at all times, even when you have the A/C on or when you have nothing on (A/C, heat or vent). The system uses a door that closes down over the air opening to the heater core to keep you from feeling warm/hot air when it is not desired. The reason(s) you feel that the vent air is warm even when the outside temperature is somewhat cool is/could be caused by the following:
First, although as mentioned above, the heater core is restricted from receiving air when you are not commanding heat by the control panel, the heater core ultimately ends up as warm as the engine temperature. This is generally somewhere around 200 degrees F. Because all the air coming out of your vent(s) must pass over the door that restricts air over the heater core, and because the heater core gets so hot, some of that heat is picked up by air passing over the hot door even though it is closed.
Second, the door that restricts airflow from passing over the heater core has a seal around it. After a period of time this rubber (or usually felt) seal deteriorates, allowing some air to actually pass over the heater core. Since the core is hot all the time, some of the air gets heat loaded, producing warmed air.
Third, the door is operated by (in the case of your vehicle) an electric motor which responds gradually/proportionately to the setting you select on the temperature dial. If the motor gets out of calibration (can happen from time to time), if the control head has a 'glitch' and sends an incorrect signal (chronically, usually), or if the electric motor (called an actuator and contains its own little electronic 'brain') becomes faulty, the door may not be closing completely. This symptom can also be caused by a problem with the door itself, where the door gets stuck due to warping of the plastic case, a foreign object preventing it from closing (usually a pen or toy dropped into a vent or defrost opening), or a broken or cracked door hinge.
Last, the vent intake opening, where the 'fresh' air comes into the car on the 'vent' setting, is located just below the windshield on the passenger side. This opening receives its air directly off of the sun-baked, engine-heated hood and because of this the air is never as cool as outside air even on a cooler night.
I hope this answers your question. Many domestic vehicle manufacturers have begun installing heater control valves on their vehicles once again as they nearly all used to have. Note that the fix for most everything I have mentioned here requires removal of the dash of the vehicle or replacement of the control head and therefore is in many cases not worth the investment if it is not an extreme problem (for example, unless the system is stuck on full heat in the middle of summer. Additionally, remember that, if you so desire, manual shutoff valves can be placed in the heater hose lines (please consult a qualified mechanic as water from a vehicle can and will scald and burn you!), allowing you to manually shut off the flow of water into the heater core, thus reducing some of the heat (Readers note that certain foreign vehicles REQUIRE water flow through the heater core at all times for engine cooling and are not candidates for this procedure!).
Sincerely, SDIgroup SDIgroup2001@yahoo.com
AnswerThere may be a little engine coolant flowing through the heater core. Perhaps the heater valve does not completely shut off. AnswerThe first answer above is absolutely excellent, IF you're still getting heat on the Vent setting when the temperature dial is set to cool. If you're getting heat on the Vent setting only when the temperature dial is set to hot, this is normal, since the term "Vent", as referred to by the dial on the climate control panel, refers to the air OUTPUT vents running along the dashboard--the ones with the louvres you can move up and down--not to the air intake vent. It took me a while to figure this one out too. If you want the Vent position to deliver air from the outside (whatever its temperature) without its getting heated by the heater core, make sure the temperature dial is set to cool.What is the drag coefficient of the 2009 Honda Accord?
The 2009 Honda Accord has a drag coefficient of .31 Cd.
Where can you find an exploded view of the engine of a 1992 Honda Accord?
Amazon.com So far Honda charges for information like that.
How do you replace the wiper link on a '96 Honda Accord?
get a Chilton book for the car at Auto zone or somewhere similar. That's what I did and its not that hard of a project. You have to get the arm at the dealer. Approx. $200.12 for the arm.
Go to a salvage yard and buy one. You'll only pay around $25.00. They have to take it off of an Accord so you can ask them how to put it back on. Some yards will even let you go out and watch it being pulled so you can see how it's done.
What manufacturer of super charger, Roots or Centrifical
How do you replace an upper ball joint on a 1994 Honda accord ex?
You have to take the control arm and ball joint to a shop and have them pressed together, otherwise it is easier to buy the new control arm with the ball joint already in it.
What is the firing order for a 1995 Honda accord ex especially concerning the distributor?
The firing order for a 1995 Honda Accord EX is 1, 4, 2, 3, 5, 6. Cylinder number 1 is nearest to the pulley.
Are there two oxygen sensors on a Honda Accord?
There can be from 1 to 4 depending on the year and engine size which you fail to list.
Where is fuse box on a 2002 Honda Accord?
Under the hood, left hand side, same side as the bottery towards the windshield. cant miss it
What is the timing marks on 84 Honda accord 1.8 stick there is no marks on the balancer..?
The hole for the timing marks is located on the front of the engine, right below the distributor. You'll have to remove the hood to get a good angle for the timing light (I don't know why they designed it that way).
Does the 2013 Honda Accord 4 cylinder have a timing chain or timing belt?
The 4 cylinder has a cam chain that is designed to last the life of the engine.
The V6 has a belt that must be replaced every 110,000 miles.
How do you fix 95 Chevy Astro van pressure switch and clutch not getting power on ac?
The pressure switch will not allow the clutch on the compressor to engage if it has too low of a pressure, or too high of a pressure. The normal reason for the clutch to not engage is that the system is low on Freon, and that normally means you have a leak in the system that is costly to NOT repair. To Test: Unplug the switch and turn on the AC, probe each side of the switch with a Volt Meter or a test light for power, if you have power then that is not the problem. If you do not have power begin at the fuses and work outwards to find the problem (advanced). Switch replacement is simple, unplug the wires, unscrew the switch (there is a Schrader valve to stop leaks) and put a new switch on. If that does not solve the problem, you are low on Freon you need the system checked before you throw good money after bad in refilling the system constantly.
What causes a 1997 Honda Accord to cut out while driving or stopped at a sign?
I'm not a mechanic, but it sounds like the main relay could be the culprit. It is mostly affected by the heat so it is likely to happen more in hot weather. Hope this helps.
What are the timing marks on the balancer belt on a 1992 Honda Accord?
I just changed a timing belt in a buddys 1990 accord and you need to set the marks on the pulleys to same direction as your crank pulley mark is.
How to reset the oil life idicator on the 2005 Isuzu ascender?
If you do NOT have the DIC package installed, you only need to turn the car to ON and slowly pump the accelerator five times. The oil life indicator will blink for a bit and go off for another 3-7.5k miles.
How do you replace the front turn signal bulb in the bumper on a 1988 Honda Accord LX?
Is it just the bulb? Or the whole thing?
There is a Philips-head screw holding the corner marker in place. It is easily seen from above when the hood is opened. Remove the screw. Gently pry between the body (use towel to prevent scratching) and the corner marker housing assembly. The assembly will need to move directly forward. Other than the screw just removed, there is one metal pin and 3 plastic pins holding it in place. The metal one has a tendancy to stick with time.
If the assembly doesn't come out, it's because of this metal pin. The pin is located at the very front very bottom of the assembly. To reach it, slide a screwdriver just behind where the corner light and headlight assemblies meet. The pin fits into a white socket that will look like a white ring - slide the screwdriver blade in front of the white ring to pry the pin loose.
Bulbs are replaced by turning the bulb holder 1/4 turn and pulling out of the back of the housing. For ease of bulb replacement, you can unplug the bulb holders, as well.
This procedure also works for the 1994 Honda Accord (and possibly for the 1995 1996 and 1997 Accords).
This is how I did it...
Remove the plastic plate just under the front turn signal... Lay on your back and scoot directly under neath looking up through some styro foam and you will see a screw that is encased in a plastic sheath... This prevents the screw from falling out... unscrew it and wha la... the turn signal comes right out.
Where are the engine sensors on a 1992 Honda Accord located?
There are numerous sensors (two water temp fan switches, temp sender, oil pressure, etc). What sensor are you asking about?
What could be some of the reasons for sudden poor gas mileage on a 88 Honda Accord with efi?
Clogged fuel filter or a leak in the fuel line. EFI fuel pump may be malfunctioning. Using a very poor grade of fuel can also affect performance and gas mileage. There are some brands of gasoline that I wouldn't put into my tank even if the gas was free of charge!
How do you change a rack and pinion on a 1994 Mercury Villager?
The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
How do you replace the headlight bulb located on a 1992 Honda Accord?
If you mean bulb, then - 1. Start on the battery (passenger) side of the car even if that light bulb is okay. It will teach you how to do the other side (driver
How do you get the air bag off a Nissan 200sx s14a without the proper tool?
I read this on the Nissan Forums and I tired it -and it worked! Open driver door
Get in
Shut door
Turn ignition to the on position The one that will go all the way, but not to start car)
Open door
Reach down with your right hand if your a rightty
Press the door ajar sensor button thing (7) times
Shut door
Start your car.....
You gotta do it a few times to get it right. The faster you do it the more chances it has to reset. If you do it too slow it will seem like it does not work. Make sure you take out the key forst before you start the process.
What happens if the D light is flashing on a 2004 Honda CR-V?
Mine went nut. After I filled up the coolant reservoir, the D light stopped flashing. Good luck!!
Is a spindle for a 99 Honda Accord the same for a 96 Honda Accord?
The 1996 is a fifth-generation Accord and the 1999 is a sixth generation Accord. The spindles are not interchangeable. Know that the passenger-side and driver-side spindles are different.
