Hyundai Excel

clutch plate disc and throwout bearing

It can be found at the back of the engine about half way down the block, you will need to jack the car up to get to it, if you need to change it out. hope this helps.

Sensor is a push fit into the flexible pipe between the air filter box and the engine inlet.Just unclip the wiring connector and pull it out.

on the top left of the engine their will be a hose coming from the radiator . it is attached to an adapter with two bolts. take off the adapter (but be careful there is hot rad fluid in it) the thermostat is right under neath it just pull it out and put it in install in reverse

how do we adjust hand brakes

if it is working at all,,,follow the sound,,,,if not.....it should be tucked up under the dash to the right of the steering column

Any would really work. Just go to your nearest auto shop, or pick up the phone and ask.

Quick internet search revealed the answer.

The oil filter is located at the bottom of the engine. Look underneith the front bumper. You will see a hole in the scratch plate undernieth. It is located right in the hole on the bottom of the engine.

How do you remove front door Panel on Hyundai Excel 1999 to Rplace front door SPEAKER'S

If you are looking for the flasher relay, it is in the passenger compartment relay box located just above the fuse box on the driver's side. It is easy to access by popping out the plastic piece that holds the dash light dimmer switch.

intake manifold just beyond the throttle body

The AC Belt connects to the crankshaft pully outer pully the one in front of the crankshaft belt

Try the rear side of the radiator approx. 1/3 down from the top

Depends on where you live climate wise, refer to service manual, or google the manual online.

First if you have steel wheels you can remove or loosen the center nut (cv axle nut) before jacking up the vehicle, starting by jacking up your Hyundai and properly supporting it. Take off the tire, for the side that your replacing, take out the cotter key on the lower ball joint, remove the lower ball joint nut (sometimes the nut won't come off completely until you break the ball joint loose from the knuckle), use a ball joint separator (fork) to break the ball joint free from the knuckle, pull the lower control arm down until it is free from the knuckle,

Call your dealer. You will probably need the radio serial #, but possibly not.

You must separate transmission from engine.

Then the throw out bearing is located on a fork by where tranny attaches to engine.

Remove bearing, pack grease into new one, install in reverse order of removing old bearing.

You might as well change clutch and pressure plate.

Install tranny to engine.

Usually the crankshaft is made of harder metal than the bolt, so you should be able to just replace the bolt. But who knows for certain until you try.

Hi I have an older EXCEL. My relay under the dash (STEERING WHEEL)was bad..it controls the rear lites if the fuse is NOT blown..its a gold color relay..there are 3 on mine..all have the same part number,they r a bit hard to reach, but swap one out..if your relay is bad, the other one with the same part # should work your lites if that relay is bad..the FUSE itself should be on left drivers side floor near clutch pedal..i don't know if your car is the same. Mine is a 1992 EXCEL..good luck

Fuel pump is in the tank

You can get to the fuel pump by removing the rear seat and you will see a bolted down access panel for the fuel pump.

soory the shift solenoid

front filler does the back as well.

45 L .