Isuzu Trooper

No - it is not an interference engine.

You'd be lucky to get 30mpg tops

4 there are 2 in front of the converters and 2 after the converters

My guess would be wheel balance.

good be your battery terminals. make sure they are clean as a whistle

I had this problem with 1999 Trooper in cold weather. Was up late at night and found the headlamps flashing. Removed the fuse for the security system. Problem went away.

On a V-6 shaped block, bank 1 is passenger side cylinders 1-3-5. Bank 2 is the driver's cylinders 2-4-6. Cylinder 1 is passenger side closest to the radiator. Same with cylinder 2 only on the drivers side. This makes cylinders 5 and 6 furthest back on the firewall. From the driver's seat you are looking out over bank 2.

Put the #1 piston at TDC. Pull the Distributor cap off (2 clips). Mark the position of the rotor relative to the distributor. Remove the timing adjusting nut located to the rear of the engine just behind the distributor. Pull it out (it twists as it comes out). DO NOT move the Veh or turn the engine over, as this will make correct timing that much harder. Instalation is the reverse procedure. Adjust timing with timing light.

Lower Heating Value (LHV) MJ/kg = 43.4 Higher Heating Value (HHV) MJ/kg = 46.5

Absoluty the engine 4xj1 is an the better diesel engines developed for Isuzu Motors in combination with General Motors division Caterpilar, These engine is built in with an very sophistificated electronical diesel inyection hidaulic mix, in the engine are used the electro-hidaulic inyectors developed for caterpillar and one ECM maked bye hitachi electronics under demand exclusively i have all information of this engine and bigg experiencie. If you need detal information please write an e-mail to me and i reply any question totaly free. Candido Carmona caides@caides.net www.caides.net

Carmona investigation en development electronics systems.

Yes, there is a diagram of the oxygen sensor location of a Isuzu Trooper. This diagram can be found in the cars maintenance manual.

I know that on an Isuzu Elf you have to take the dash cluster out and on the back swap a screw from one hole to another to turn the light off

Valves should be adjusted cold (70ºF ) at .016" for both intake and exhaust valves. As usual, make sure cylinder is at TDC when adjusting.

Air can be bland from the diesel fuel system on a Isuzu D-Max 3.0 engine by hooking an air compressor to the fuel line. Loosen the fuel line at the other end of the engine. The air will be removed.

You can buy a charge kit from your local auto parts store and follow directions but if it needs a charge it must have a leak. Have the leak repaired first. This is best done by a garage that does AC work.

i wood take the car to car x

The Isuzu Trooper typically requires around 7 to 9 liters of automatic transmission fluid (ATF), depending on the model year and transmission type. It's important to check the owner's manual for the specific capacity and type of ATF recommended for your particular vehicle. Always ensure to use the correct fluid to maintain optimal performance.

0-20 mobil oil fully synthetic dont put to much ...

Same location where you pour the motor oil

You are going to have to be move specific on the year of the vehicle engine type fuel type. Dont forget to lubricate the tip of the bolts with lock tie. On thing I do when in need of info is I call the dealer parts department and ask them. They have all this OEM specifications on their systems.

eBay and Dreams2things.com has some nice ones!

Alternators should produce around 14 volts. I say around because this can vary with temperature, engine speed and the age of the alternator. If you think yours is kicking out too much it's probably the voltage regulator. If you think its not enough it could be the brushes. The easiest thing to do is to pull it and take it to a parts store; most of them will test your alternator for free.

If like the 2000. it is in the rear on the left side, there is a door there and the jack is inside.

isuzu trooper e.f.i 1991 black smoke and running but no power

It will depend on the application. Check the vehicle owner manual. Should be around 32 psi.