0
Jeep
Jeep, a subsidiary of Chrysler Group, Limited Liability Company. Jeep specializes in manufacturing and selling sport utility vehicles and is the oldest SUV-producing brand. Jeep was founded in 1941.
2,017 Questions
Some Ford rims have the same bolt pattern and similar offset as some Jeeps.
A specific yes or nor answer would require a specific make, model, and year for both vehicles in question.
Most rim manufactures and retail sellers, and most Jeep and Ford owner forums have lists of rim sizes and bolt patterns that you can use to answer your own question.
When did Karl Probst invent the jeep?
Karl Probst is credited with designing the prototype for the military jeep in 1940. His work was part of a project initiated by the U.S. Army to develop a lightweight, versatile vehicle for World War II. The first prototype, known as the Bantam BRC 40, was completed in 1940, leading to the mass production of the jeep by various manufacturers.
What is the correct factory tire size for a 1987 Jeep Wrangler?
The correct factory tire size for a 1987 Jeep Wrangler is 215/75R15.
I assume it is to give you feedback that the vehicle locked, in case you are too far away from it to hear the locks themselves.
Jeep keyless remote battery instructions?
Pretty simple, open the remote...most likely just snaps apart, replace with same part number battery
What part do you need to replace if the steering on a 1985 Jeep CJ7 is really loose?
well first you need to know that it can be more then one item. so a little inspection is in order. have someone, engine running brake on, move the steering wheel back and forth a2 to 3 inches while you look at the steering linkage. areas that are weak are: drag link end (tie rod end that attaches to the pitman arm on the gear box) if it moves side to side and or pops up and down change it.
the frame. yup the frame can be cracked. look close at the gear box mounting brackets. are they moving around? if yes, remove bolts, clean and reinstall with lock tight.
check the frame rails where they attach to front cross member and the bumper bolts. what your looking for is movement. any is bad. if all that is good there is a "slip joint" on the shaft that connects to the gear box. see if there is any play there. (a trick, if play is present remove clip holding rubber cover in place, pull joint apart and you will notice 2 small "slip bushings" very carefully remove the spring clip and turn the slip bushings (square bushings) 180 degrees and reinstall with clean grease.
and last-- take your jeep to a good alignment shop and have the suspension and steering inspected.
Where is the brake fluid box on 1994 jeep renegade so to check level?
Master cylinder reservoir should be located on the firewall at the driver's side under hood
the bell crank lever is a apparatus used to verify the law of moments.
Where does the speedometer cable connect on the transmission of a 1976 jeep dj-5 rhd?
into the tranny itself..mine 727 torqueflite..you should be able to see it easily..remember you will probably get fluid coming out while removing. i am replacing mine soon, it has been broken for some time now..shows 48,000 on my dj...probably close, but it s a drag guessing your mph around town.
arizonaa4@yahoo.com
How many quarts of oil do you need for a 4 liter jeep?
Jeep Wrangler takes 6 qts.
Jeep Cherokee takes 6 qts.
The oil pans are fairly large on these vehicles. Additionally for those who need the proper viscosity information, it is as follows (directly from the maintenance manual):
Above 30 degrees F ..... SAE 20W-40 or 20W-50
Above 0 degrees F: SAE 10W-30 or 10W-40
Below 60 degrees F: SAE 5W-30
The rims from jeep cheroke fits in regal?
No the bolt pattern for the jeep is 4 1/2" and the regal 4 3/4"
What is the proper backspacing for 15 x 8 rims with 32 x 1150 tires on a stock 1992 Jeep YJ?
Are you willing to install fender flares? If not stick with at least a 5.5" back spacing or they will stick out and redecorate the side of your JEEP with rock chips.
What is the gear ratio on a 2.5 liter 4 cylinder 1992 Jeep?
There are four ways to find a ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
What does P0432 check engine code mean on a 1998 Dodge Intrepid?
Trouble code P0432 means:Main catalyst efficiency below threshold
Where do the vacuum lines go to from the tcs switch?
If I understand your question right, you should have 4 vacuum lines connected to it. The top one connects to the carb by the bowl area; the next one connects to the rear of the carb; the next one comes from the vacuum advance on the distributor and connects to the middle vacuum port on the TCS; the last one connects to the trans line and to the front of the intake manifold. You use a "T" in the line for this one. If you had a GM factory repair manual you'll find a drawing showing how the lines go. Check, YearOne, OPGI, the Parts Place, USA parts, Kanter auto parts, etc.
Where is neutral safety switch on 1998 jeep?
On the passengers side of the trans about even with the front of the door fan shaped switch held on by two bolts.
I suggest taking it apart and cleaning it before you think about replacing.
The switch is nearly $300
To remove, flatten out the retaining washer side, remove large nut, remove smaller ( 14mm ) bolt on the adjustment side.
cleaning is easy, 6 screws in back, pull apart, clean out all that old grease, pay special attention to the two contacts on the sweeper arm, they should move in and out easily as they have springs underneath and are the man contacts, apply new di-electric grease and reassemble.
reassemble and align before tightening, easiest way is to put trans selector in R and move switch until reverse lights come on.
Where is the 1999 jeep wrangler throttle sensor located?
The throttle position sensor is on the throttle body opposite of where the cables attach.
