answersLogoWhite

0

Lincoln Mark VIII

The Lincoln Mark VIII was a full-size personal luxury car manufactured by Ford Motor Company from 1993 to 1998. The car featured a 4-speed automatic transmission, 140-mph speedometer, automatic climate control, leather seating surfaces and electronic message center.

1,216 Questions

Price to repair head gasket on a 1993 Lincoln mark VIII?

Hello!!! ok plese take a seat, ready! ... for a regular vehicle here in Fresno,California the averege price runs about 4 cylinder car $350, 6 cylinder car $650 , REGULAR V8 car $650 to $750 usdlrs., NOW for a V8 32valves twin cam sports car that your fingers can't reach a single nut the price is around $1000 t0 $1200 usdlrs. but you can always get a garage mechanic for around $850usdlrs. so I rather to do itmy self Im not a mechanic but I like to work on my own cars an let me tell you it is a pain in the a%# work on this kind of muscle cars but is worth it. you ending expending around $350 dlrs for head gaskets,engine oil,antyfreeze,new water pump,valve covers gaskets,ohh the most important .....bandaid. Hope it helped. thanks ! From Fresno ,CA. CENTRAL VALLEY

Getting an exhaust smell in the car of 1994 Lincoln mark viii?

Don't know exactly what you mean, if the rotten egg smell probably cat. convertors fuel smell probably ox. sensors. Does it still idle and run smooth?

What do you use trunks for in a telephone network?

To connect telephone company central offices (COs), To provide a path between switches, To connect PBXs

How do you remove the driver seat on 1998 mark viii?

Unplug the electrical connections and remove the 4 bolts.

What is the differences of 1993 and 1995 Lincoln MK VIII?

Same body, engine/trans. Just a few cosmetic differences i.e. the exhaust tips. I own a 93 Mark Vlll . I am a Ford tech.

Car does not move when in drive unless you press gas pedal?

Sounds like low idle which may be a vacuum leak, dirty TB (throttle body), or dirty IAC (idle air control) valve.

Lifter noise on Lincoln mark viii?

You didn't mention whether you hear it all the time or just on startup? If on startup, the timing chain has a tendancy of making noise especially when cold. Usually the lifters don't make noise in these cars unless the oil is really dirty or oil level really low.

Why would alarm go off for no reason?

well, your clock goes off usually if you set it. i have mine go off or not go off when i want it to. it is very strange but sometimes you might get ghosts if you believe them. or ut alarm clock is not working right.

How do you remove ingnition key switch to replace on a 1994 mark viii?

to remove simply move the steering column cover then move the key forward under the cylinder there will be a silver button push in and pull out the cylinder with key at the same time

No heat comes out vents in my 1998 Lincoln mark viii only cool air?

Sounds like the Blend Door Actuator arm is broken, common problem with the 97-98 Marks, around a $2,000 job with a $6.00 part, the dash has to be taken out unless you have a mechanic that can change it without taking out the dash.

How do you remove the headlight covers on a 1993 Lincoln mark viii in order to clean them?

You can't, but if you are talking about getting the cloudyness off, then polishing compound and then wax. You may have to do it a couple times, all according to how cloudy your lights are. If your talking about the inside of your lights I'm afraid they will have to be replaced. Try the compound first to see how that works, just take your time.

Where is the rear air suspension compressor for a 1995 Lincoln mark VIII located?

Mine is a 93 markVIII.My compresser runs both front and rear together.Its located in front of car passenger side..hope this helps

Why is your cruise control on your Lincoln mark VIII not working you have no blown fuses?

Likely it's messed up in the muti purpose stalk so that would have to be changed.

Why doesn't the audio work with an aftermarket stereo in a 1994 Lincoln mark 8?

Needs a wiring harness, can't just put in an aftermarket stereo without re wiring the speakers etc.

How do you reset suspension on a Lincoln Mk VIII?

In the trunk there is a trap door on the drivers side with the on off button.

What does circle slowly till cal mean for Lincoln mark viii?

The compass is in need of calibration. If you recently took a long trip you may have traveled into another calibration area for the compass. What you need to do is go to an open area like a large parking lot and slowly, very slowly, drive in a circle until the compass recalibrates itself. If it does not do so after two or three circles then drive slowly in a figure 8 pattern one or two times...

Wiper motor located on a Lincoln mark 8 93?

Open the hood and all the way in the back attached to the bulkhead in the middle you will find the wiper motor.

What can be causing a 1998 Saturn's Security System alarm and sometimes the panic alert to go off for no apparent reason?

If it is original equipment, contact the dealer. If it is add on, someone with electrical expertiece can cut the wire or pull the fuse.

Windows will not roll down in a 97 Lincoln Mark VIII?

If both sides don't work, I'd check the master on the drivers' side, then the one on the passenger side if they still don't work then the fuse box would be checked. Not likely that both motors would go out at the same time unless that is the way you bought it and the owner didn't fix one then the other one went out.

Is there a Lincoln mark VIII SRS?

There are two models of the Lincoln Mark VIII. The base or standard MARK VIII and the Mark VIII LSC. The LSC was introduced halfway through the 1995 model year, and continued to the end of the Mark VIII production. SRS refers to the SUPPLIMENTAL RESTRAINT SYSTEM (air bags). This is why you may see the letters SRS on the panel above the glove box area and on the steering wheel horn pad.

97 Mark VIII door panel removal and Where are all the bolts I only found 2 Diagram would help?

Answer

Here's how you do it on a '97.

  • Remove the cover for the side mirror screws, in the front pillar. Just pull it gently straight out.
  • Remove the "cup" around the inside door handle by prying carefully with a screwdriver. Take care of the vinyl.
  • Locate and remove an 8mm hex bolt in the access hole just under the window control panel lower edge.
  • Pry two-toned door light on lower back side, carefully to protect the vinyl. Remove long Phillips screw located inside. At this point the panel is free.
  • Lift the panel up until it clears the window sill and door lock button. Carefully separate from the door until you can reach behind. BEWARE: there are several electrical connectors to disconnect.
  • Holding the panel so it doesn't drop and damage the cables, disconnect the wires going to the tweeter. You'll need a flat screwdriver to pry up the retained tab. Then disconnect each of the other cables that are connected to the now loose door panel. You may require someone to help you with this.

Installation is done by reversing the procedure. Be sure the top edge of the panel drops completely into the window sill; watch that the lock button goes in its hole. There is a horizontal mark on the front edge of the door that must coincide with the rubber-coated section of the panel when installed correctly.