Mazda

In a 2008 Mazda Tribute, the radio battery constant 12v+ wire is orange/light green, the accessory switched 12v+ wire is yellow/black, the ground wire is black, the illumination wire is light blue/red, and the amp trigger wire is light blue. For the front speakers, the left front speaker wire (+) is orange/light green, the left front speaker wire (-) is light blue/white, the right front speaker wire (+) is white/light green, and the right front speaker wire (-) is green/orange. For the rear speakers, the left rear speaker wire (+) is gray/blue, the left rear speaker wire (-) is brown/yellow, the right rear speaker wire (+) is black/violet, and the right rear speaker wire (-) is orange/violet.

Go read the instructions, unless you're too MAN enough to do it.

To disconnect the fog light bulb on a Mazda 6s, first, locate the fog light assembly beneath the front bumper. Turn the fog light bulb socket counterclockwise to release it from the assembly. Carefully pull the bulb out of the socket, ensuring not to damage any components. If necessary, consult your vehicle’s manual for specific instructions related to your model year.

In a 2001 Mazda B, the horn is typically located behind the front grille, near the radiator. It is mounted on the driver's side and can usually be accessed by removing the grille or the front bumper cover. If you're having trouble locating it, refer to the vehicle's service manual for specific diagrams and instructions.

The battery is located in the trunk of the car, above the right rear wheelwell. You may need to pull back some of the carpeting. Once you find it, replace it just like any other car battery.

If the odometer is not working while the speedometer functions in a Mazda B2500, the issue may be related to a faulty gear or drive mechanism within the speedometer assembly. Typically, the speedometer uses a cable or electronic signal from the vehicle's speed sensor, which can still operate even if the odometer's internal gears are malfunctioning. Another possibility could be a problem with the vehicle's instrument cluster itself. A thorough inspection of these components is recommended to identify the exact cause.

The recommended tire pressure for a Mazda 2 typically ranges between 30 to 35 PSI (pounds per square inch) for both front and rear tires. However, it's essential to check the specific tire pressure listed on the driver's side door jamb or in the owner's manual, as it may vary slightly based on the model year and tire specifications. Always ensure tires are inflated to the recommended pressure for optimal performance and safety.

The auto tensioner for the serpentine belt on a 2011 Mazda is typically located near the front of the engine, usually on the passenger side. It is a small, spring-loaded pulley that applies tension to the serpentine belt. To remove the belt, you'll need to use a wrench or ratchet to rotate the tensioner away from the belt, allowing you to slip the belt off the pulleys. Always refer to the specific vehicle service manual for detailed instructions and diagrams.

No, but I don't give you evidence..!!

Cheryl maxfield

Check the EGR Valve located underneath the carburater on the passenger side of vehivle, if it is clogged it will not operate properly as the vacuum tries to open and close it, take it off and clean it with Blster and/or soak it until it frees up . adcar1970@yahoo.com TONY

Roadrunner by Bo Diddly