Just the blend door. only heat comes out?
Modern automobiles use a variety of HVAC designs and the fixes are unique to each system. In general, replacing the blend door will resolve the problem, but access and dealer hardware is problematic. This usually turns out to be an expensive repair to replace a cheap plastic blend door.
HeaterTreater is the world's leader in aftermarket blend door fixes. Information on the broad line of fixes available and upcoming innovations is available on the web site at www.heatertreater.net.
cgallen
How do you remove the spare tire from a 1999 mercury mountaineer?
You can view the 1999 Mercury Mountaineer owners manual online at :
www . motorcraft service . com ( no spaces )
Click on Owner Guides
( starting on page 178 there are instructions with drawings on how to
change a tire )
Where is the torque converter clutch solenoid on a 1988 Chevy G20 conversion van?
drop trans pan/drain fluid,look for a 2 or 3 wire plug that plugs into a tall,kinda t-shaped,and has copper windings around the bottom of it.its held in by two 10mm bolts.unplug and remove it,pop new one in,tighten down,plug it in,reinstall pan and gasket.refill trans with 4 quarts of trans fluid.start engine,check for trans pan leaks, let it run up to operating temp,check trans dipstick level,add fluid if needed to full mark on stick.road test van ,shift thru all gears,then check for leaks and check level again.
Where is fuel filter 97 mountaineer?
On a 1997 Mercury Mountaineer :
I assume the fuel filter would be in the same location as a 1997 Ford Explorer :
( underneath the Mountaineer , below the drivers door , mounted on the frame rail )
Replace rear wheel bearing on 2002 Mercury Mountaineer?
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
How do you reset the anti theft on a 98 Mercury Sable?
1. Using the NGS scan tool and Service Card, select Service Bay Functions.
2. Select PATS.
3. Select Enter Security Access (this will require a 10 minute delay).
4. Select Parameter reset (do NOT perform any other selections at this point).
5. Turn the ignition switch OFF and disconnect the scan tool from the On-Board Diagnostics II (OBD2) connector.
6. Cycle the ignition switch from the OFF to the RUN position 5 times. Each time the key is cycled, leave the key in the RUN position for at least 3 seconds and leave the key in the OFF position for at least 2 seconds.
7. After the 5th cycle of the key to the RUN position, the theft light should perform a normal prove-out and the engine should start.
Where is the IAT sensor on a 1999 Jeep Wrangler?
The iat sensor is the front sensor on the intake manifold it has a gray 2 wire plug that is the 4.0 lt the 2.5 the sensor is the back sensor on the manifold.
you might need freon charged, you can do it yourself with a $20 can setup from autozone. if the system wont hold pressure then you have a leak somewhere
Why is the rear wiper not working on your 1998 mountaineer?
1998 Mercury Mountaineer rear wiper troubleshooting - check in this order: Fuse, switch, spindle/tightness of arm, motor, wiring. See the Sources and Related Links section below for rear wiper blade information.
How do you turn on fog lights in a 1999 mountaineer?
The fog light switch is in the center stack of your dash , just to the right of the
radio , near the bottom of the radio . Just push the button to turn on the fog
lights and push it again to turn off the fog lights
How often should I replace the fuses in the fuse box that is under the hood?
I'm still driving my 1995 Ford Explorer and have never had a problem where a
fuse blew and required replacement
Can a rear end collision cause transmission problems on a 2004 Mercury Mountaineer?
If it is 4-wheel or all-wheel drive, and the energy from the impact was transferred into your drive shaft, then that can screw up your transmission, which is connected to your drive shaft. Look for signs of impact on your rear axle. Take lots of pictures, don't settle with the insurance company until you have gotten multiple assessments. Its a pain, but will be worth covering your bases.
What kind of oil does a 2002 mercury mountaineer take?
According to the 2002 Mercury Mountaineer owner Guide :
With engine oil filter change :
The 4.0 liter V6 engine takes ( 5.0 U.S. quarts of 5W-30 engine oil )
The 4.6 liter V8 engine takes ( 6.0 U.S. quarts of 5W-20 engine oil )
How do you turn on fog lights for 2002 Mercury Mountaineer?
On a 2002 Mercury Mountaineer :
Put your low beam head lights on and pull the headlight selector switch towards you
How much is the capacity of oil for a 1999 5.0 mercury mountaineer?
5 quarts ( 4.7 liters ) WITH FILTER CHANGE - according to the owners manual
Where is the IAT sensor on a 98 Chevy S10?
the iat sensor is located by the air filter in line to the the intake (the rubber hose between the filter and intake i have a98 s10 that i am working on that has a bad iat sensor you can tell it bad when you test it with a scan tool the one i had to replace was reading that the iat was at -40 below and it made my truck smell like gas
How do you reset the combination on a key less door lock pad on the door of a 2002 mountaineer?
The first thing you need to have is the vehicles MASTER keypad combination. Once you have this number it is simple to ADD an additional combination of your choise.
The MASTER combination always remains the same; you can only add an additional combination. How do you get the master combination? Good question. My old 87 t-bird had a sticker with the combination stuck on the inside of the trunk lid. Recently I tried to find this sticker on a 02 Crown Vic with no results. Good Luck!
Written by Oscar:
According to what he said you can find the combination sticker inside the trunk lid or the trunk bars, else than that my 1995 Lincoln town car had it sticked in the door panel, just take it off and you should see a black box with a sticker on it, the 5 digit number printed there is gonna be the master code. Hope it's helpful for everyone with this problem. And I would like to know how to change the combination. Thanks
How can you open the hood of a 1997 Mercury Mountaineer if the cable doesn't release the latch?
On my 97 mountaineer you cannot open the hood with the release inside the truck. Standing in front of the truck on the drivers side behind the grill the cable is located to pop the latch. Carefully pull out the bottom right side of the grill and you have to have a skinny arm reach in and pull downward on the cable itself this will pop the hood...
Why did the check engine light come on and stay on in your 2000 Mercury Mountaineer?
The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to a parts store or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.
What kind of rear brakes for a 1997 mercury mountaineer AWD?
Disc brakes ( with small brake shoes in the back of the rotors for your
parking / emergency brake )