0
Nissan Stanza
The Nissan Stanza was launched by Nissan in 1973, and was then separated into twin models – the A10 Nissan Auster and Nissan Violet – in 1977. All the three cars were manufactured in Hiratsuka and Oppama in Japan.
394 Questions
How much did gas cost in 1970?
If I remember correctly, around 30 cents a gallon in Indiana and surrounding states.
How much did gas cost in 1925?
According to some sources, but not all, Gasoline averaged around .15 cents per gallon in 1927. Adjusted for inflation that equates to around $1.75 in 2006.
What are the different kinds of stanza?
1.Couplet a two line stanza 2.Triplet (Tercet) a three line stanza 3.Quitrain a four line stanza 4.Quintet a five line stanza 5.Setstet (Sextet) a six line stanza 6.Septet a seven line stanza 7.Octave an eight line stanza
Where can I find some nice body kits for a 1992 Nissan Stanza?
i just typed in 92 Nissan stanza in Google and about three down their is one that says body kits. they only sell one its 600.00 dollars but its pretty nice
I would check eBay......parts and accessories category
Refrain
What is a regularly repeated line or phrase at the end of a stanza?
end rhyme --A regularly repeated line or phrase at the end of a stanza is a "refrain."
Where can you download or purchase a manual for a 1988 Nissan Stanza wagon?
Search for the model you want here. http://www.courtesyparts.com/nissan-manual/
Are 1989 Nissan Stanza front end parts interchangeable with 1991 front end parts?
I have an 89 and my friend has a 91. They checked and the parts are not interchangeable between the two. You can always call an auto parts store and ask this question, they should be able to tell you if they know their stuff!
Why does my 1991 Corvette idle rough?
A rough idle on the 91 vette could be from a variety of reasons. Bad, worn out, or loose spark plugs. Worn out or damaged spark plug wires could be the cause. It could also be the optispark (Distributor for these cars). I have also seen fuel injectors create a rough running condition on these cars as well. Start simple, and don't go to deep in the beginning look at the surface issues and look deeper as you rule out the most obvious culprits. There are many things on these cars that will cause a rough idle but it is better to rule out the cheap and easy to fix causes first. Check the plugs, do a compression test, test the wires, coil, and injectors and what not before you start throwing parts at it. The compression test is a good thing only because these cars run really hot, and some don't engage the cooling fans until 240+ degrees, so it is possible to see a crack in the head, head gasket leak, ect on these especially if the cooling system has not had a good maintenance record.
AnswerYou won't find an Optispark distributor on a 1991 Corvette. The 91 vette has the L98 engine, which uses a more traditional distributor. 1992 was the first year of the Generation 2 LT1 engine that uses the Optispark. It is true that many issues can cause rough idle. Rough idle can often be caused by a vacuum leak. Check for leaks, including a ruptured bladder in the EGR valve, which will act as a vacuum leak. So, that is something else to consider.
Inhibitor relay location 1990 Nissan Stanza?
the inhibitor relay is between the a/c relay and the cornering relay
Does a 1992 Nissan Stanza have a timing belt or timing chain?
I believe that it is a chain, I believe that it is a chain,
Where are the timing belt marks on a 1987 Nissan Stanza timing belt marks?
at top dead center, camshaft mark at 12 o'clock and crank at 5 o'clock. belt should also have marks if it a Nissan belt.
Where is the neutral safety switch on the 1990 Nissan Stanza.?
Attached to body behing brake pedal (if automatic) clutch pedal (if standard)
Where is the speed sensor located on a 1991 Nissan Stanza?
It is located in the rear of the transmission almost in the center. It is held in place by a single 10mm bolt. It is easiest to remove from under the vehicle. I suggest the use of vehicle ramps, you will have enough room to easily remove the sensor. It only took me about 15 minutes to replace and I am far from a mechanic!
How do you remove and install a starter on a 1987 Nissan Stanza?
Oh yeah dude, easy. Remove the frame rails on the bottom of the car right under the starter (below the throttle body) then take off passenger side wheel, remove that from the transaxel (some working space) then remove the engine mount that is in your way. Just rip out the starter, take it to a parts shop, get a new starter and your core back =) and stick the new one in! Hope that heps!
