0
Oldsmobile Cutlass 442
The Oldsmobile Cutlass 442 was a high-performance muscle car manufactured by General Motors from 1964 to 1980. Four generations of this car were produced – all were equipped with front engine and rear-wheel drive.
359 Questions
What is the tire size for a 1993 Oldsmobile cutlass cierra sl?
I have the Cutlass Ciera S, which takes tire sizes 195 75 R14 or 185 75 R14 - which I've heard has been discontinued You could call your local Oldsmobile Dealer and ask them for specific recommendations, some of the Ciera's have R16 sizes instead , (rim size)
What is the spark plug gap for a 1988 Mercedes 420 sel?
The gap for your 420 sel is .32... dont forget to use a good plug!
What does 442 in a Oldsmobile?
4 barrel carb, 4 speed, dual exhaust is wrong
it stands for 400 sbc
4 barrel carb
2 wheel drive (refeing to the posi rear end)
it never stood for the 2 wheel drive it depends on the year as to what it stands for
1964 (Original meaning)
4: Four Barrel Carburetion
4: Four On the Floor
2: Dual Exhausts
1965 (First year of automatic and three speed manual transmission option on 442)
4: 400 Cubic Inch Displacement
4: Four Barrel Carburetion
2: Dual Exhaust
1967 (First year a 2bbl was available) 4: 400 engine 4: Nothing, 2bbl Turnpike Cruiser option available 2: Dual Exhaust--Actually in 1967 the 442 did stand for 400 engine, 4 bbl carb and 2 exhaust. The 2bbl Turnpike Cruiser was an option. The standard 400 engine was a 4 bbl carb so yes, the second 4 did have a meaning.
1968-71 Official name of car was 442
1972 Reverts to option package W29, but with no connection to the numerals 442.
1985 to 1987 (Last of RWD 442s)
4: Four speed automatic
4: Four barrel carburetor
2: Dual exhaust
1990 and 1991 (FWD 442)
4: Four cylinders
4: Four valves
2: Two camshafts
How do you replace the heater coil?
For: Ford Expedition... *** Caution *** Never open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink ant that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old. Heater Core 1. Disconnect the battery ground cable 2. Drain and recycle the engine coolant. 3. Remove the instrumental panel. 4. If equipped with the 5.4L 4V engine, remove the junction block splash shield. 5. If equipped with the 5.4L 4V engine, remove the bolts and disconnect the cable ends from the starter relay. 6. If equipped with the 5.4L 4V engine, remove the junction block bracket. 7. Disconnect the heater core hose couplings. 8. Remove the retaining screw and remove the A/C plenum demister adapter. 9. Disconnect the vacuum line from the A/C plenum demister adapter. 10. Remove the heater core bracket. 11. Remove the 13 plenum chamber top retaining screws. 12. Remove the plenum chamber top. 13. Remove the blend door assembly from the case. 14. Remove the heater core. 15. The installation is the reverse of the removal.
Originally: 4 Speed (Automatic Trans.), 4 Barrel (Carburetor), Dual (Exhaust)...but then everything changes!
Where are the oxygen sensors on a 1999 Oldsmobile Cutlass?
The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
Where can you get replacement body parts for a 1986 olds 442?
E-bay, craigslist or a local swap meet, I'm not sure if yearone.com carries olds parts or not. year one carrys a few but not many
1985 Oldsmobile cutlass supreme will not start?
be more specific what kind of noise if any at all wont turn over ? it will not even crank up
Spark plug gap for 02 Buick Rendezvous?
On the '04 is .060 inches or 1.52 mm. Not sure if it's the same for every year.
Will a 71 cutlass 442 hood fit a 70 cutlass?
Not without changing a lot of other parts, radiator support grills fender moldings and stone shield.
How do you install a convertible top on a 1970 Cutlass?
I would highly recommend hiring someone with experience. Let them supply the top as well. My experience is that they prefer a certain brand.
How much horsepower does the 1972 Oldsmobile 442 350 V8 engine have?
The Oldsmobile 442 means (400 cubic inches-after '65) (four barrel carb) and (dual exhaust) if your car does not have these it is not a true 442. The 350 that year had only 160hp to 180hp but the 442 should have had the 455 and 270hp to 300hp. Are you sure your car is a 442? It may be a cutlass with a 442 paint job.
Will your 1972 Oldsmobile 442 run on ethanol?
Not without some serious mods to the carb, fuel lines, seals, gaskets, etc. E85 will eat through rubber in no time and will really dry stuff out.
What kind of lift kit do you need to put 26 inch rims on a 1987 cutlass 442?
Your talking all new coil springs all the way around and special made ones or you could go with an expensive air suspension all the way around.
What is the gap on a 125cc dirt bikes spark plug?
Most manufactures recomend a gap of 0.5-0.6 mm for racing bikes and for street bikes 0.6-0.7mm.
Anything between this and you should be fine.
What is the bolt pattern on a 1987 Oldsmobile cutlass supreme?
What bolt pattern are you talking about? The wheels? Is it front or rear wheel drive? Rear wheel drive will be 4 3/4 inches measured from the center of one lug stud, skipping one, to the outside edge of the next lug stud. This is measuring across the center, NOT wrapping the tape around the outside of the skipped lug.
