0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
How do you change a water pump on a 93 Oldsmobile Cutlass Ciera?
drain radiator of coolant, remove serpentine belt and remove pulley on water pump. If the pulley has 4 little bolts on it then loosen and pull the pulley off. If there are no bolts on the outside of the pulley then its pressed on, you can remove it yourself with a blowtorch but its hard to get off and on correctly. Remove the bolts holding the pump on and pry the pump off the engine, this will be hard most likely due to the gasket holding the pulley to the eingine. There will be coolant that will come out due to coolant you couldn't drain by the radiator...just have a container under car to catch coolant. Once removed scrape all the old gasket material off the engine... there is a gasket remover tool but a razor blade workls just fine. Once removed clean area well and apply gasket to new pump with gasket sealer and place pump back onto engine. Tighten bolts and replace pulley and belt, fill with coolant and top off as needed. be sure to purge the coolant systemof air after any major coolant work. The repair is relatively easy as loong as you have the right sockets for the job...good luck!
What is the fuel pressure for Olds Cutlass 2.8?
On an Olds Cutlass 2.8, the fuel pressure should be between 40 and 47 psi with the engine off. With the engine running, it should be between 30 and 44 psi.
Your 1984 Oldsmobile cutlass 3.8 v6 is stalling at stop lights why?
If you restart the engine and putting it into gear causes it to stall replace the torque converter lockup solenoid as it has gone bad.
If pressing the gas pedal lightly with the right foot while braking with the left foot prevents the stalling (don't do this long term as it can be dangerous and can cause transmission problems and rapid brake wear) you very probably have a bad IAC (actuator) but it might also be a bad IAT sensor or low cooland level or bad ECT sensor or dirty throttle body or sticking EGR valve.
What is the cooling system fluid capacity for an 1987 Oldsmobile cutlass cierra?
The 1987 Oldsmobile Cutlass cooling system has a fluid capacity of 5.5 gallons. The cooling system fluid should consist of 50 percent antifreeze.
What is the maximum torque for a 1982 Cutlass Ciera LS?
134.00 Ft-Lbs (181.7 NM) @ 2400.00 RPM Source: http://www.conceptcarz.com/vehicle/z5471/Oldsmobile_Cutlass_Ciera.aspx
How do take off old ac compressor on a 1993 Oldsmobile cutlass cierra?
Remove freon via EPA mandated instructions Remove drive belt from engine pully Remove AC hoses from rear connections of compressor Remove compressor mounting bolts
Can a 1987 cutlass grill fit on a 1986 cutlass?
81-86 are the same. 87 is the same as the 88 supreme classic. 87 grills will NOT fit an 86 without changing the entire header assembly.
How do you reset the service engine light on 1998 Oldsmobile Aurora?
2 ways, autozone can reset the light,no charge. But they can also tell you what the code # is and what you might need to repair it. Or you can disconnect the battery for approx. 5 Minutes, that should reset the cars computer.
Why would a 1995 Oldsmobile cutlass supreme start then die immediately?
Perform throttle body sevice Perform idle /air control motor service,replacement
check the coolant temp sensor
Where is radiator cooling fan relay on 1998 Olds Cutlass?
The Relay is located in the black box on the drivers side of the car next to the firewall. turn the knob on the top of the box till the bolt releases and the relay is going to be #14 (grey relay top right of the box)
Where is the egr valve on a 1991 Olds Ciera?
Its a 3300 3.3 3.1?? drivers side rear coner of engine (top of). Its an electronic EGR with 3 valves on it. REmove it and check the passageway below it as it carbons up and will give you an EGR failure code/symptom
Where can you get a transmission diagram for a 1972 Oldsmoblie Cutlass?
i need to see how auto trans cross member bar is installede
Where can you obtain wood grain vinyl replacement for a 1993 Oldsmobile Cutlass Station Wagon?
PT Woody sells Di-Noc woodgrain film by the yard.
How do you replace a thermostat on a 1999 Oldsmobile Cutlass?
Replacing a thermostat on a 1999 Oldsmobile Cutlass is very easy to do. First you will find the thermostat by following the upper radiator hose. It is under the exhaust crossover. The thermostat has two 13 mm bolts holding it in place. Take the bolts off to remove the thermostat and replace with a new one.
Where is the brake light switch on a 1999 Chevy Silverado?
what does it mean if my brake light is blinking on and off when its pushed down in my 1999 Chevy silverado
Where is the horn located in a 1998 old cutlass?
The horn for a 1998 old cutlass is under the hood on the passenger side. It is in the very front located on the frame or impact bar of the car. The easiest access to the horn is to remove the headlight assembly on the driver side.
What size serpentine belt is needed for a non-airconditioned 1989 Oldsmobile cutlass ciera?
air conditioner eliminator pulley from autozone.com
Where is the fan relay switch located on a Oldsmobile cutlass supreme 1993 3.1 engine?
Both fans are controlled by relays that are located in a small fuse box on the passenger's front fender. Look inside the engine compartment between the overflow reservoir and the headlight. There are two relays that are square in shape.
Where is thermostat on 1986 cutlass ciera?
Should be in a removable housing at the engine end of the upper radiator hose
Can you put 18 or 20' rims on an 1989 cutlass ciera?
Actually they will i have a 1994 Oldsmobile Cutlass Ciera S and i have two sets of rims on them 18's and 20's.All you have to do is find the right width of the rim and size of the tire.(ps my first set is 18' by 7.5 and tire size 225/40.The second set is 20' by 7.5 225/30)
Why is my 1993 Oldsmobile Cutlass Cierra ABS light on?
Most likely because of a problem with the ABS system, which could be expensive to fix. It could also be caused by low brake fluid.
Where is the MAP sensor on 88 olds cutlass ciera?
under the hood
On the passenger side against the firewall. Its at the far left upper portion. It is black has a connector and a small hose going to it. Two screws hold it into place. The heads are bolt head and very small. about 6-7 mm head maybe 1/4.
Where is the fuel pump relay located on a 1994 Oldsmobile Cutlass Ciera?
I have yet to identify which relay is specifically for the fuel pump,however, the relays are mounted on the passenger side of the radiator .
