Toyota Sequoia

I removed mine by first removing the bezel around the Air Conditioning controls. First thing I did was open the door to the storage compartment below the Air controls. Then that part just pops off. There are no screws holding that on.

After you get that off there is one screw on the right hand side that is holding the top bezel in place. Note: the bezel that is around the radio runs all the way up the dash and will come off as one part. After you remove the one screw, it should pop right off.

Next, there will be four screws holding the radio in the dash. Take out those screws and the radio will come right out.

A bad relay could be the reason why the parking lights on the Toyota Sequoia won't turn off. Swapping the relay out with another one may fix this problem.

Get new front brake rotors, there cheap.

Yes It's easy: on the 2007, 2008, 2009 and the 2003 4 Runner are all in the same place.

It is behind the lower glove box. Just open glove box disconnect the little piston rod on the right side then squeeze in the side supports so the glove box will open way down. The cabin filter it right behind the glove box. You will see a snap on door that covers the filter. Pull it off and slide out the filter.

The EPA range estimate for the 2008 Toyota Sequoia is 369.6 mi. in the city, 448.8 mi. on the highway.

The curb weight of the 2002 Toyota Sequoia is 5070 lbs..

It is more than likely a dead cell in the battery. If this is the case the battery must be replaced. It can also be that a light on the vehicle somewhere is on pulling power from the battery. Can be under hood light, trunk light, glovebox light, courtesy light, or even the brake lights. Can also be that you have a relay that is stuck closed. This can be a Power Seat rely, power window relay, or any other relay vehicle.

Check

You have to unlock all of your doors from INside your vehichle....can't remember off hand how...I had the same problem last night with my newly acquired jetta last night..

it should be a chain bout the only thing that uses belts are over head cams ::::::: It has chainS it has one chain for each side of the engine to control the cam's its got two of those and than its got one from the crank to an alignment gear in the center so its got 3 chains two the same size and one a different size>>>

you will have to replace the suspension on the truck for it to work. but yes it will fit on a Toyota Sequoia!

On a 2001 Toyota Sequoia, the fuel pump is located on top of the fuel tank. The fuel pump is powered by the EFI fuse and EFI relay.

I think it's because you didn't use the remote to turn on the screen.

I assume the cable is broken; go thru the hatch or trunk and remove carpeting etc. on that side; you should be able to gain access to it. I hope this helps you. Mark unlock the doors and push on the left side of the fuel door

open the trunk, figure which bulb you need to replace, left or right, inside the trunk pull the fabric back where the lights are and you will see the access ports Fabric panel may be held in by 2 screws which you need to remove. If you don't have access to the bulb retainers yet you may have to pull off the entire tail light assembly. To do this look for 3 brass colored threaded studs and a 4th rubber covered stud. Remove the nuts from the 3 threaded ones. The rubber covered stud is a metal stud snapped into a metal retaining collar, probably designed to require a special removal tool. It's possible to center a strong nail or Phillips screw driver on the tip of it and rap it with a hammer to pop it through the collar. (If you wish to see what you're hitting first you can cut off some of the rubber near the end.) This will permit you to pull the entire tail light assembly off from the back of the car. Now the light bulb retainers can be rotated and pulled out, and you have access to the bulbs.

Here's a link- scroll to the post by Qslim- it has scanned pictures of the manual directions for programming the fob.

http://www.toyotanation.com/forum/showthread.php?t=212679&highlight=fob+programming

well first of all does your car shift hard? if not unplug ure hot battrie ground and the light should go off

If it is the check engine light is different than the Maint req'd light (for oil changes).

The MAINT REQD light is simply a timer for oil changes.

Here's how you get reset the MAINT REQD light:

1) put the key to the ON position

2) press the mileage reset button on your cluster so it shows total mileage (not trip)

3) put the key to the OFF position

4) press and hold down the mileage reset button, leave it pressed

5) put the key to the ON position

6) wait until the mileage shows 000000 and you can stop pressing the ODO button

I doubt if it has one. Look in the Fram application catalog at a Walmart store. Walmart carries Fram cabin air filters. If you corolla is not listed,it probably doesn't have a cabin air filter.

The curb weight of the 2005 Toyota Sequoia is 5070 lbs..

90ft/lbs

Brake fluid in a Toyota Sequoia could be leaking from several places. Check the wheel cylinders first as they are a common place to leak.

Open the glove compartment, gently squeeze in on both sides of the open compartment, then you can pull the whole glove box out. The air filter is behind there.

Timing chain.

You press down on the right side and it pop's open. If this does not work the fuse for your central locking must be out and needs replacing.

You press down on the right side and it pop's open. If this does not work the fuse for your central locking must be out and needs replacing.