0
Buick Regal
This category covers questions about the Buick Regal, a full-sized luxury sedan manufactured by General Motors and sold through its Buick Division in the People's Republic of China. The Buick Century was renamed as the Buick Regal when it was sold in Asia as the Toyota Motor Corporation had already claimed rights to the name "Century."
1,721 Questions
Had a recent situation with similar symptoms. Turned out to be a faulty
Mass Air Flow Sensor. P/N of replacement was 19179715. Hope this helps.
Where is the cabin air filter located on a 2004 Buick Regal?
Open and read your owner's manual. The location is listed there. You have to remove the plastic trim around the passenger side wiper. It is under the window.
Where is the thermostat on a 91 Buick regal?
if u follow the hose from the raadiator to the the motor u should find it
The flasher is just for controlling the intermittent electrical current. There is also a fuse in the fuse block under the dash.
It could be in the switch on the column.
How can you open the hood if the hood release cable does not work on a 1986 Buick Regal?
If the cable is not broken yet try 2 things, one or the other may work. Have someone push down on the hood while pulling the release, hold the release and let up on the hood. If that doesn't work, pull the release and get something to pry up the hood just a bit. It may be that the lock is simply dry and not releasing like it should. If you get it open spray it with some WD-40 or similar
If the cable is broken - the simple trick is to access from underneath the front of the car.
I jacked up the car, placed it on a stand on the passenger side, and reached up underneath.
I've videoed it - quick to do once you see it.
How do you compress the rear caliper pistons on a 92 Buick Regal?
Make sure you back off the emergency brake adjustment before attempting to compress the piston.
You need to go to your local auto parts store and purchase a special tool. The tool fits onto a rachet and screws the caliper piston into the caliper.
Go buy a 6" C Clamp. You can use that to compress the caliper piston and it is cheaper than a special tool. You can use it for clamping other things around the shop too.
C-clamp won't work, you HAVE TO turn the piston back in with the tool or you could try to put pressure on the piston and turn it at the same time.
ive tried the C-clamp and do not recommend this method!!although upon my first attempt i was unaware that nearly all modern vehicles w/rear disc brakes NEED turned in, like a screw. so i ruined a clamp and the calliper trying to figure it out :( the special tool purchase is not required in most cases because most auto parts stores offer free tool rentals to promote the sales of auto parts, and the tool they offer is usually better than the one most people are willing purchase due to expense probably in the upwards of $50. there is a cheap tool option 3 to 4 bucks kinda looks like a cube w/ a 3/8 ratchet drive hole on each side for a extention to fit to your ratchet. and it has different sized/shaped pegs at the corners of each side to make it more compatible with other vehicles, efficient but difficult to use and i really don't suggest it either but ive used one and it did get the job done. try to find a store that lets you use their tools. AutoZone hasn't had the best service in my experience but it is a good example of a store that practices free tool renals usually nice tools and usually the right one for the job rather than a 3$ junk that's only resulting in sore knuckles //Smallball
How much does it cost to replace the fuel pump on a 2002 buick regal?
The cost of replacing a fuel pump on 2002 Buick Regal will vary depending on the labor and part costs. The price for the fuel pump starts at $56.00.
How do you bypass the security system in a 1993 buick lasaber?
That GM car uses a system called VATS
Your key should have a chip in it. You need to take an OHMS meter and check the resistance on both sides of the chip in the key. From that, you will need to buy a resistor that matches the resistance on the key
You will Cut the Vats system wires that run up into the steering column. It should be two wires that are wrapped in orange plastic. You will need to solder the resister into the harness side of the wires.
What sizes other than 225 60R16 can be safely used on a 1994 Buick Regal Gran Sport?
The OEM size is 205/70-15. But I assume you want to stay with a 16" tire. If that be the case a 205/65-16 is much closer to the OEM size than the 225 tire.
How do you remove the clutch and bearing from a Buick Regal?
autozone.com Compressor AND clutch FACTORY_AIR REMANUFACTURED 57967 1 YR $40.00 $208.99 FACTORY_AIR NEW 58967 1 YR $30.00 $409.99
CLUTCH ONLY FACTORY_AIR REMANUFACTURED 48665 3 MO $109.99 i believe you will have to have a "puller" to get it off the shaft so you can get to the bearings.
Where do you put the transmission fluid in a 94 buick regal?
Just right into the test stick , check level with engine running, apply gear shift back and fore then parking before checking level
How much oil does a 3.8L V6 take?
most cars produced in the USA take 5 liters, your best bet is to put in 4 and check your dip stick, if low add some more, if alittle high dont worry about it. Your engine will push it out
How do you reset the tire inflation monitor system on a 2001 Buick Regal?
Just did this yesterday on my '00 GSE.
Open the fuse panel, (open front passenger door, open (spring-clipped) side panel of dash.
Turn ignition to on, (ie, not engine on).
In fuse panel theres a red 'reset' button. Press and hold 2-3 seconds until 'low tire' light flashes.
Turn off ignition, turn back on. Voila. No light.
What would cause a 1992 Buick Regal to clunk when put in reverse gear?
Worn trans or diff parts. If it gets worse, have it looked at.
How do charge the air conditioner on a 1995 Buick Regal Custom?
The low pressure port is located right next to the high pressure which is visable on drivers side next to the air filter cleaner housing. It is hard to see because it is blocked by the air filter housing and a cable with foam insulation on it. Remove housing to get better access. R134 refrigerant.
Where is the fuse panel on a 99 Buick Regal LS?
Open the passenger front door. There is a removable cover on the end of the dash. There is also an under hood fuse box.
How do you replace a center cup holder on a 1998 buick regal gs?
You need to pull up the center console cover first. Working from front to back carefully pull up to disengage the six pressure clips. You may need to disconnect the traction control wiring connection if you have one. The cup holder is attached to this panel and you can see how to repair or replace it. On my 1999 Regal the cup holder swing out side piece with the little spring fell off. I was able to retrieve them from under the console. Took me a few minutes to figure out how to put it back and re-engage the little spring. I added tape to secure cup holder top piece to the base to prevent them from separating again. Reattach the traction control wire clip and carefully push down to resecure the console panel. I believe the same Regal console panel fit from 1997 to 1005 model - but please verify that. Good Luck!
How do you change interior lights in 97 Buick regal?
Take old lights out. Put new lights in. Done. You have just changed the interior lights on a 97 Buick Regal!
Where is the starter motor located on the 1991 Integra?
passenger side open the hood look right below the air cleaner intake tube i beleve its down there.
What website can you find out what repairs have been done on a used car your interested in buying?
www.carfax.com belive me it is worth the money...
What kind of transmission does the 2011 Buick Regal have?
The 2011 Buick Regal has a 6-speed shiftable automatic.
