0
Chevy Camaro RS
This category covers questions about the RS custom option for the first generation (1966-1969) Chevrolet Camaro. The RS package included hidden headlights, revised taillights, RS badging, and exterior rocker trim.
2,274 Questions
What side is 1 cylinder on 1999 camaro v6?
Cylinder 1 is on the cylinder closet to the front of the car on the driver's side. The order is 1,3,5 on the drivers side and 2,4,6 on the passenger side from front to rear.
Is there a turbo kit for a 2002 Camaro 3.8 V6?
car tuning should have one out soon for the 3.8 camaro, check their website: http://www.cartuning.ca/future/
1996 Camaro - high beams won't switch on?
I have a 98 camaro and it has the same problem. I found that if i took off the top cover for the shifter i can push down on the housing and my high beams will come on.. I found a small plastic piece that came off. Try opening and looking. I heard that alot of camaros have this problem. The switch goes bad.
The 96 Camaro's high beams wires do not run anywhere near the shift lever that is on the floor of the 1996 Camaro. It is built into the turn signal selector which is on the steering column. Your problem is either your relay (under the hood in the little box on the driver's side, you have to remove the top to access it) or your turn signal selector. Does the turn signal selector click when you pull it back? If it does click you probably need a new relay. If it does not click you will need to pull the steering wheel to get to that selector and change it. Also look behind the turn signal selector there is a small wire connector that if it comes loose your high beams and cruise control will not work. Often you can connect these wires and get everything back.
http://camaroforums.com/forum/93-02-general-41/high-beam-issues-58085/
What is the engine firing order for a 95 camaro v6?
3.8 L V6 is 1-6-5-4-3-2 3.1 & 3.4 L V6 is 1-2-3-4-5-6
How do you change the belt tensioner on a 92 Camaro V6?
remove belt then remove two bolts holding it on and remove old put new one on
a 400 small block. You'll have clearance issues if you move up to a big block, and you'll need to do some firewall adjustment as well (among a host of other things) if you choose to go that route. It has been done, and many times over for that matter - but I wouldn't. Stick to small blocks with 82-92 F-bodies if you'de like to keep things bolt-in-and-go.
Or you can save your money and they are getting cheaper but a ls9 427ci slips right in, I have done 2 of them into 2000 ss, with a few mods IE flashed, injectors, high flow fuel system, complete Doug Thorley exhaust, we got 603 hp to wheels and at 80 mph going to Vegas 28 miles to the gallon. All this and passes California smog.
1/4 mile time has only been low 11s it lights up the tires in the first 4 gears' Traction problems but pulls over a g in the corners and will drift with a flick of the throttles. It smokes a new vette from 50 to 150 bad
sure you have a 20000.00 dollar 2000 ss camero, but I guarantee you will never want to sell it, Next is the vette drive train complete with IRS transaxle.
What is the fuel consumption on a 1990 Camaro rs v6?
whats the estimated mpg for a 91 camaro rs 3.1L v6
Rear gear ratio 1991 camaro 350 ci?
There are four ways to find a ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
Would a 350 fit in a 1994 camaro?
a 350 is a Chevy motor, if it doesnt work you will need to cut some parts out to make it fit
haha
Will a t56 6 speed from a 96 camaro fit a 86 Corvette?
Yes, with a small amount of bellhousing/flywheel/clutch adjustment.
Why would engine miss at cruising speed on 97 Chevy camaro 3.8 engine?
plug wire ... there's one that gets too hot and deteriorates
How much fuel pressure should a 1991 camaro v6 have?
FUEL PRESSURE:
Ignition ON Engine OFF40.5 to 47.0 psiWith Regulator Vacuum Applied [1]3.0 - 10.0 psi Less than Ignition ON Engine OFF
What is the engine timing for a 1980 camaro with a 350?
8 degrees btdc,thats pretty much all stock v8 are
Where is the fuel pump located on a 1992 Chevy Camaro RS?
It has an electric fuel pump inside of the fuel tank.
How many horsepower does a 1999 Chevrolet 5.7 small block have?
the 5.7L vortec has about 300hp in a Tahoe/Suburban
1994 Z28 and SS camaro differences?
the z28 should have a 305 and the ss should have a lt1 350
there was no 94 SS. they came out in96. both have LT1 350's. The SS has some performance enhancements like ram air and performance exhaust and better suspension and rear. all things you can do to a Z28 to improve it's performance.
Where can you find a fuse diagram for a 1983 camaro?
In the owners manual or get a chiltons repair manual for your car at the library.
You require a 67 camaro steering column diagram?
pick up a chiltons repair manual from the library for your year car.
if you know the oil pump is good and the oil screen is not plugged then there is just a few more things like hopefully a bad guage or sender or not so simple main bearings with to much wear
How do you replace the turn signal switch on a 1996 Tahoe?
see if the library has a shop manual for free, otherwise invest in one...might be tricky d see if the library has a shop manual for free, otherwise invest in one...might be tricky d
If the timing chain snapped would the Valves be damage on a k11 micra engine?
Yes, but not only valves will be damage. Yes, but not only valves will be damage.
