answersLogoWhite

0

🚗

Chevy Impala

Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.

4,997 Questions

How do you replace a fuel pump on a Chevrolet Impala?

The 2001 Impala LS's fuel pump and fuel sending unit can be easily accessed through the trunk floor next to the back of the rear fold down seat. I know, because I just replaced mine. There is an oval access plate under the carpet secured by 7 aluminum nuts. Disconnect the fuel filler cap to release fuel line pressure. Then disconnect the negative cable to minumize lthe possibility of sparks while working near gasoline. Remove the plate and you will see the top of the fuel pump/sending unit with 2 wiring harnesses attached and 3 attached fuel hoses. Remove the wiring harnesses by first carefully disengaging the plug clips. Then remove each of the three small fuel hoses by pressing in the clips with a flat head screw driver . I had some difficulty with this and I would strongly advise purchasing an inexpensive fuel line removal tool from an auto parts store to avoid damaging the clips. After removing the wiring harnesses and the fuel hoses from the top of the fuel pump/sending unit, now remove the slotted metal lock ring by using a small chisel and hammer. Hit the ring at an angel to loosen it from the tabs. Once the ring is loosened, all that's left is to lift the the unit out of the tank. But first, wipe away the debris from the top of the unit to avoid contaminating your tank when you pull the unit out and when reinstalling. Also, have a small towel handy along with a bucket because the pump/sending unit will be spilling fuel as you pull it out.After pulling out the old fuel pump/sending unit, installation is the reverse of removal. However, getting the new fuel module back in that small oval opening proved to be the hardest part of what I considered a relatively straight forward repair. Push the disconnected hoses out of the way and patiently work the new pump in. Its spring loaded and once its in the tank, compress it by pushing down on its top until you have the nessesary room to resecure the locking metal ring. The ring will have to be resecure using the hammer and chisel to position the lock tabs back in the ring slots / Read more: How_do_you_replace_the_fuel_pump_on_a_2001_Chevrolet_Impala_3.4L

Why does Chevy Impala idles to high?

depending on the year some impalas have 6 inch glasspacks

How much gas does a 2008 impala take?

The strictly gasoline 2008 Chevy Impala holds 17 gallons of fuel; the E85 model holds 14.2 gallons of fuel. I obtained this information from Motor Trend. Hope this helps!

Why is there water leaking in the passenger side of a 2004 impala?

It wasn't an impala, but I had a car that leaked and would fill the floorboard on the passenger side. It was due to a drain that was plugged with dirt, leaves, etc. that ran down from the windshield and would normally drain out under the car.

What is the engine horse power of a Chevy Impala?

This depends on a couple of factors, including the year of the vehicle and whether the engine is the original. The latest model (the 2012 Chevy Impala) will include GM's 3.6 liter v6 engine; it reportedly packs 302 horsepower.

Which car is faster 1996 impala SS or 2004 Mercury marauder?

everybody has this question when it comes to comparing the 2004 marauder with the 96 impala ss. both cars are full size sedans with big v8s. most would agree that they are evenly match in the performance department. so what exactly set them apart? well in this case the marauder seem to have the upper edge over the aging SS. the marauder is more modern and tune better than the SS. the SS is a sloppy driving machine. it doesn't corner like the marauder does, the weight is not distributed evenly throughout the car which makes a big difference in driving. basically the marauder would beat the SS but not leave it in the dust, because the SS is not slow, but it just drive differently, plus its much more heavier.

the marauder is superior to the impala SS.

the marauder would beat the SS in a race but it would not blow it away because both cars almost identical in engine packages and everything.

finally it all depends who driving the cars, and how they drive it.

What could be the cause of the low beam lights not working when switching from high beam?

The simple answer may be that the low beam side is burnt out. Replace the bulb.

However, if both headlights have stopped working when switching to low beams, there may be a problem with the relay or the switch itself. If the cost of a relay is low for your car, it may be less expensive to simply replace that component than to have it diagnosed in a repair shop. Replacement of the switch requires some disassembly of the steering column or dash in most vehicles. Check a specific service manual.

Is there a hole in firewalls to the engine compartment where you can run a wire from the cabin area to the battery?

Sure just find where other wires pass through and push it through with the tip of your screw driver, be careful not to nick or stretch any of the existing wires.

What is the car in supernatural worth?

Sentimentally: A LOT! To me at least. =P

Realistically: Probably still a pretty shiny penny. It is an American muscle car classic you know. Depending on the condition of the car though, probably something around $15,000 maybe. It really depends on the seller -which I doubt they'll do, lol. =)

How do you know that your Catalyic converter needs to be Clean or re placed?

How do you know when your Catalyic Converter needs to be clean or needs to be replacsed

2000 Impala that when you turn the key sometimes everything goes dead One person tells you it's the Security System another says the Ignition Switch Which one is it and is it a quick fix?

In my humble opinion, it is never easy to fix anything on cars these days. I would assume though that if everything goes dead then it is a good possibility that the ignition switch is at fault. It's a common problem spot for many.

How much does it cost for a new transmission for an 02 Chevy impala?

Approximately $2,300.00 to replace with a rebuilt. (Just replaced mine) My guess new would be around $3,000.00

What would cause the rear-window defogger to quit in a 2006 Chevy Impala?

"Dead" Rear Window Defoggers

Without doing a "hands on troubleshooting" of your rear window defogger circuit, NO ONE can tell you for certain what is the specific cause of the failure.

However, the most probable cause is what is called an "open circuit" condition.

Regardless of what causes it, an open circuit condition is the equivalent of turning a switch to the OFF positon. It opens the circuit, cutting off the flow of electricity.

Altough there are probably some causes I haven't thought of at the moment, here are some of the more common causes:

  • The fuse for the circuit has "blown" out,
  • A connector, or connectors, anywhere in the circuit has become disconnected [unplugged],
  • Corrosion has built up on the metal contacts inside of one or more connectors,
  • A conductor [wire] in the circuit has been broken or cut,
  • The defroster grid glued on the rear window is conductive [like the wires inside of an electric blanket] and are very delicate, and IF only one is broken or damaged, it too will open the circuit.

Find the fault/flaw causing the open circuit, correct it, and the rear window defogger will work again.

What does 2evap code po446 emission control system vent circuit malfunction mean for a 2000 Chevy impala?

it is an evap code

the evap system is designed to allow un burned fuel vapor to be purged into the intake while driving also when fuel tank pressure reach to high for example hot day outside most common cause is the vent control solenoid located in the upper rear quarter you can see it underneath. it could be also a kink in a vapor hose or even the fuel tank pressure senor

How much does it cost to replace a car radiator 2005 Chevrolet impala?

If you go to a shop id say $400-$500 depending on where you go it could be more....me personally i would do it myself and probably only spend about $200 just on parts ...

Is a 327 big block or small block?

327 is a Small block. 265 thru 400 were small blocks but to confuse you more the 396 thru 454 were big blocks.

Unless you really want to be confused, I won't mention the 348 was a big block. :)