you need a OBD-2 scan tool to clear codes
How do i program keyless remote for 08 Chevy impala?
Insert ignition key, turn to "on" position and back to "off" position three times ending in the "on" position while holding the door lock button on your driver or passanger door, after the honks, let go of the lock button and hold the "lock" and "unlock" button of your remote until the vehicle honks again, now position your ignition key to the off position and unlock your door and open it. That should do the trick.
What are the biggest rims you can put on a 2007 Mazda RX-8?
i have 20'' on mine, but unless you have new shocks, your going to need to place lifters. because I cant sit anyone in the back. because the tire rubs... so go with 19'' if you use 20'' you won be able to have any pasengers like me.
How do you reset tire pressure light for 2005 Chevy Impala?
Just disconnect the negative cable from your battery for a good ten to fifteen minutes so that the main does itself a reset.
What is the EPA city and highway mileage estimate for the 2007 Chevrolet Impala?
The EPA mileage estimate for the 2007 Chevrolet Impala is 18 mpg in the city, 28 mpg on the highway.
How do you check power steering fluid on a 2002 impala?
It is important to check and maintain the vehicles fluids. A person checks power steering fluid by looking for the yellow lid labeled Power Steering Fluid Only, this is where the fluid can be checked.
How many inches lift kit will you need to put 24 inch rims on your 2007 Chevy Impala?
The best would be an airlift suspension system and still some cutting, new brake pads an such would be highly advised... I have 22's on my 07 and i was talking about putting 24's on it at the shop, but the guy said it will be a horrible decision for both handling, for the car its self, and time (I was in a hurry when i got mine done) I don't know the price range you are looking at, or the area you live in, but I would suggest you just stick with 22x8 an skinny low profile tires... 24's can be done, just be prepared for higher than normal costs, and a pain in to drive. it looks raw from the side on 24's an when its moving but 24's stick way out from the side of the car. like an inch or 2.. and that doesn't look good to me... But, depending on the brand on rime/tire... low would be 3,000 high up to 6,000... I'm glad I stuck with 22's... if you were to lift the car you may have to buy/install new struts which is not cheap... if you have the money you could make it happen, just go to your local shop... I went to 3 different ones and all were pretty much the same answers
How much horsepower does a 1964 Chevy 327 engine make?
From 225 to 375 depending on the configuration. The cylinder heads used on high performance engines (and some others of the era) were the 3782461X head with 1.94/1.50-inch valves. These heads had the commonly found double-hump shape on the end of the head. Milder engines had the inverted V head. It should be noted that beginning in '64 and through '68, cylinder heads with the double-hump shape also used 2.02-inch intake valves (aka fuelie heads). Castings with 2.02-inch intake valves were also used on the 365hp (Holley carburetion) and 375hp (Rochester fuel-injection) Corvette 327 engines.
How do you replace the tail light assembly on a 2004 Chevrolet impala?
As per the instructions on page 5-55 of your "Owner's Manual"...
The thermostat is located in the housing at the engine end of the top radiator hose.
How do you re-program the door lock remote on a 2009 Impala?
Go to wikihow Go to search type in program door lock remote
Chevy Impala 2001 service traction light on?
Hi i have an 2001 Chevy impala and my service traction Light is on. plus my safety brake is locked
What size rim is good for a Chevy 2003 impala is 18 to big and what size tires?
20" IS GOOD. ANYTHIGNG BIGGER AND U'D HAVR TO REMOVE THE PROTECTIVE COVERING INSIDE THE WHEEL WELL
Where is the engine coolant temperature sensor on a 2004 impala?
It is on the intake manifold near the thermostat.
How do I remove the rear seat on a 2006 impala?
There are two "T" handles on the bottom front endge of the seat. Pull them they release the lever that hooks the seat in place. Then just lift up and out.
On mine one side was much easier than the other. The "T" is part of a plastic mechanism. ( This is for the full bench version NOT the split rear seat)
Where is the turn signal flasher on a 1995 GMC Jimmy?
I just answered a question about fixing the flasher, so I'll pearoast it here. It will answer your question, too. By "changing the flasher", I am assuming you mean the emergency flasher switch, or the turn signal switch. In either case, it is an integrated unit, along with cruise control (if you have it) on the steering column. Fixing it, in this case, means replacing it. Your best bet is to buy a replacement from a junkyard. When I did mine, I had to buy an entire steering column and take the unit from that; the yard wouldn't sell me the signal unit alone. Even then, it only cost me $80 - a bargain. The process isn't hard, but I couldn't explain it well enough to do it justice. It boils down to basically this: 1) Disconnect the battery and remove the airbag fuse. 2) Remove the airbag from the steering wheel. (Be careful!) 3) Remove the steering wheel and drop it from it's mounting bolts. 4) Remove the plastic housing. 5) Disconnect the signal unit and mount the new one. 6) Put it back the way you found it. I PROBABLY MISSED A STEP OR THREE! Get a good manual (I use Haynes) and read it thoroughly before starting a project like this. Good luck to you! Mr. Dog IF YOUR JUST LOOKING TO REPLACE THE FLASHER !!!!!!! the flashers are under the lower dash panels...remove the lower panels then the one under the steering wheel (torx screws). that will give it to you..they(signal and hazard) are approximately just to the left of the ash tray. EWJ
How do you read a check engine code on 2006 Chevy Impala?
You will need a code reader. Your local auto parts store can sell you a simple one for $60 to $80. It will come with directions and a book of code definitions.
How do you fix a blower fan that only works on high I have a 2002 Chevy Impala?
You need to replace the resistor board locate on the inside passanger side where the blower motor is located . It is attached to the blower motor with 4 screws as I recall and can be readily replace if you are somewhat handy around cars. The part Iam sure must be purchased at the dealer for around 35 dollars.
How do you program the remote key on a 2003 Chevy Impala?
Follow the directions in owners manual. Just going by memory, Turn the ignition to run or acc,and make sure the stereo is turned of.Press and hold the Display button for a bit,around 5-15seconds. Then it will beep and say Settings on the stereo display. Then use the Seek or Forward/Reverse buttons to scroll to Fob Prog.(I think) Press Display. Then you have to hold down some of the buttons on the remote till it beeps. If you have more than one fob, you have to program it at the same time so it will work. Here's a site with the complete instructions... http://www.programyourremote.com/ Good luck.