On a 1991 gmc s-15 jimmy what would keep front differential from engaging?
Check the vacum control unit located under the battery. Hook a vacum gage to the unit and see if it will engage if not relace unit. If it does engage trace vacum lines back to source.
My 1989 Chevy caprice classis wont move when i put it in gear why is it doing this?
check gearbox oil level first could be low on fluid dextron 2
My brakes are making a grinding noise what does that mean?
Check or have them checked immediatley. They are going to fail REAL soon.
How do you replace the axles on a 1969 GTO?
the backing plate on the rearend has to come off and there are C -clips that you have to pull out of each axle where they mesh with the gears inside the rearend and then you can pull the axles out.
What is sympthoms of a bad cv axle?
At first, just a leak in the boot indicates that problems are headed your way. If ANY grit gets inside, like when it's wet, that starts the CV joint to wear. As the problem progresses you'll notice clicking and popping sounds when you're moving, especially as you turn the wheel. It will definitely get worse when you turn the wheel, and you may not even notice it when going straight. Once it starts making noise, you don't have a lot of time before it either locks up or the vehicle will act like it's in neutral.
What is the stock ring and pinion gear ratio for Chevy silverado 2500hd?
There are four ways to find a ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
It should be a lite clear color. If it's white or gray then it has water getting through the axel seals.
What is the stock gear ratio on a 95 Z71?
There are three ways to find a gear ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
How do you find the axle ratio from the VIN number?
Your local dealer will have to use the VIN to get the sales codes for the vehicle. They should be able to tell the ratio from that.
What transmissions will fit 2000 S10 2WD 4.3?
the 4.3l came with the ever popular 4L60E in 2wd vehicles, this is a computer controlled transmission and is usually slave to the ECU.
Why do cars have differentials?
Cars have a differentials in order to allow the wheels to turn at different speeds when you turn. A differential is basically a set of gears which delivers power from the transmission to the axle(s), and thus spins the wheels.
How do you remove the rear axle from a 1995 Yamaha Timber wolf?
remove the axle nut on the side with the brake hub...and pull threw the other side....very simple
After removing the pinion nut, a 2 jaw puller should do the trick.
How do you change the clutch on a 2001 Dodge Ram 1500?
Raise the front end of the 2001 ram 1500. Remove the drive shaft and transmission. Unbolt the clutch, and check the pressure plate for wear. Using an alignment tool, install the new clutch. Reverse the procedures to finish the installation.
Where can one find baby activity gear?
Many stores sell baby gear, in America choices include Target and Walmart. Online there are many e-tailers with a large selection, notably Amazon. There is also a blog by the name Baby Activity Gear that is worth reading, if interested in baby activity gear.
What could cause a rear wheel to lock up in forward but not reverse?
The emergency brake cable is probably seized and the emergency brake is not releasing.
What is the Oil Capacity of 2002 Ford F-250 Rear Differential?
The 2002 Ford F2 50 rear differential has and oil capacity of 5.5 quarts. You can check the oil level through the oil fill hole.
All Trans Ams through 81 come with a posi rear. It was part of the T/A package. It may be high gears, but it'll be a posi.
What is differential gear ratio?
Number of rotation of the input shaft to turns of the ring gear. For example, a 3.55 gear ratio would mean the input shaft rotated 3.55 turns for each turn of the ring gear and axle shafts.
Why are your brakes making a grinding noise?
Your pads or discs are worn. The brakes will fail soon if not replaced.