answersLogoWhite

0

🚗

Flats and Tire Pressure

Tire pressure is commonly measured in either pounds per square inch (PSI) or in kilo pascals (kPa). Improper tire pressure may cause vehicles to run flat and may consequently result in a serious accident.

2,058 Questions

What is thre correct tyres pressures?

Correct tire pressure will vary from tire to tire. The recommended rating for tire pressure will usually be printed in small letters on the sidewall of the tire with a number followed by the letters "psi."

How do you remove a flat tire from a 1999 Honda Passport?

The jack is located on the left rear side of the cargo area - behind a small door. The tools to use the jack and the lug wrench are under the rear seats. Jacking points are identified in the users manual. Once they are located, then removal of the tire is like all other cars - except the wheel/tire combination is much heavier.

What is the correct tire pressure for a Peugeot 206?

You need to consult the hand book. That will tell you what pressure should be in front and rear based on the number of occupants.

If you have a car full of passengers the tyre pressures will be different because of the extra weight.

You could also consult the list that is posted next to the air line at the filling station.

What is the recommended tire for 2006 Hyundai accent?

This information is listed somewhere on the vehicle, usually the driver's door post. If you have 14" wheels the OEM size is 185/65-14. If it has 15" wheels then 195/55-15

A tire contains air at a pressure of 2 bar 15 degrees C If the tire's pressure is unchanged what will the air pressure in it be when the tire warms up to 40 degrees C as the car is driven?

Using the ideal gas law (PV=nRT), you can calculate what would happen by just raising the temperature. Note that the T is in degrees Kelvin, so you would have to convert from C. V is the volume, n is the number of molecules and R is the gas constant, so those values would not change in your scenaro. From that, you can use: P2 = P1 * (T2 / T1): P2 = 2 * (313/288) P2 = 2.17 bar Note that this won't be exactly what occurs, but it gives you a close approximation. ("Impurities" in air will cause variations in the pressure rise. Moisture probably has the biggest effect, and it will typically increase the pressure rise. This is one of the reasons why nitrogen is being touted as "better than air" for your car tires.) Also, please note that the air pressure recommendations are for *cold* tires (i.e., at outside air temperature), so don't adjust for what you think the tire temperature may go up to.

How do you replace brake fluid?

Depending on the vehicle, under the hood there is a container that is labeled Brake Fluid. That is where a person measures the amount of brake fluid left, and with a funnel adds the appropriate amount.

How often should you fill your tire with air in the winter?

You should check the air pressure at least once a month.

You should check the air pressure at least once a month.

What tire pressure would give the best ride in a Suzuki Samurai?

Use exactly what is recommended on the label on the drivers door jamb and in the owners manual. Lowering the pressure to get a better ride is not recommended. You will effect the handling adversely on a vehicle that is already easy to turn over. You will also cause the tires to wear on the outside edges of the tires and will be buying tires much sooner. You bought a Samurai and you should have known it does not have a good ride. Sell it or live with the harsh ride.

Air pressure in a tire depends on what?

Air pressure depends on the duty the tire is put under. On a normal passenger car a nominal pressure of 35psi cannot hurt anything. From grocery getter's to Mercedes Benz, believe me, it will work without fault. The door placard may say different, but it's the gospel in P metric 4 ply passenger tires. 6 ply tire should operate in the range from 40 to 50 psi. 8ply 50 to 65 psi. 10ply 65 to 80 psi. The higher of all said ranges being the max cold psi operating pressure. The more you pull or the more weight you haul, the closer you should be to the maximum pressure for optimal cooling of the tires. Otherwise you risk a low pressure blowout. Similar to those that run tires flat, not knowing, and blow them up on the roadside. These tires generate too much heat and cause the tire to fail catastrophically. Hope this helps. This comes from 15 years of seeing failures in the tire business.

I disagree. You should run the exact tire pressure listed in your owner's manual or on the driver's door post. That pressure will give you the very best handling, mileage, and ride. That pressure is what the engineers that designed the car have recommended. I believe they know way more about it than the above poster or me for that matter. Increasing the pressure will adversely effect the ride, & handling of the car. Stick with the recommended pressure and you cannot go wrong. Check the pressure when the tire is cold.

Okay so the moderator didn't care for my answer. He had an excellent point. Here is mine in reply. Tell the families of the people that died in the Ford Explorer/Firestone rollovers that the engineers knew what they were talking about. They put 26psi on the door placards of the Ford Explorers that killed people. Most vehicles today are real close to 30psi. That might have been partially Firestones fault but if the door placard would have stated 35psi and followed, those people would be alive today. This incorrect low pressure created too low of a threshold for error. The manufactures of cars now adays are trying to find an amends between good ride and the over sized tires they are putting on cars now. These tires have no sidewall which is where a good riding car begins. In my personal opinion they are dropping air pressures to compensate for lesser quality suspensions for a better ride. There are too many variables for a default answer of go by the door placard. Hydroplaning, poor fuel mileage, premature tire wear, nonresponsive handling, and improper tire shoulder wear are all results of cars the reflect close to 30psi. Tires ran at 30psi even properly rotated will wear out premature in the shoulders. You will have almost 1/2 tread remaining in the center of the tire upon replacement. I'm not telling anyone to, but I run my car tires at 40psi cold all the time. I experience long and even wearing tire life, better fuel mileage, great water evacuation, responsive handling, and much more. So you consumers choose. Give all the rest of your money to the oil companies. In increased gasoline use and horrible tire wear. The base in tires is carbon black. Carbon black is achieved from crude oil. The engineers know a lot, yes. The dealership is a direct extension of the engineering dept., correct? Then why does no one with a brain buy tires at a dealership. Because there are very few stealerships, yes stealerships, that knows tires. 3 rules on buying tires. Don't buy from stealerships, clothing stores, (Walmart, Sears etc..) and last but not least........Buy from a tire dealer who knows tires. Who has common sense and who can look at your vehicle and give you recommendations that will save you lots of money in the long run. All my efforts are to benefit the consumer and keep money in their pocket.

Ok, I will answer your points one at a time and then the conservation will be over. You may have worked on installing tires but I built them. I know exactly how they are constructed.

1. You say you run 40 lbs on all your tires. That is on the average tire 5 lbs over the maximum allowed pressure the tire will hold. Running more pressure than the max is dangerous.

2. Tires inflated to the pressure recommended by the manufacture will NOT wear out on the shoulder if they are kept at the proper pressure. They wear on the shoulder due to under inflation which you know as well as I you see all the time. People do not check the pressure and keep the tires inflated properly. I keep my tires inflated to the manufactures recommended pressure and have never had a tire wear on the shoulder. It simply will not happen if you keep them inflated properly.

3. The Ford Explorer case was a rarity in the first place. Did the tires blowout due to low air pressure or did they blow out due to overloading of the vehicle and or low tire pressure way below the recommended 26 lbs pressure. To say the putting 26 lbs of pressure in the tires caused the blowout and deaths of people is ridiculous. Were the tires defective in the first place? Or was the problem a combination of under inflated tires way below 26 psi, overloaded vehicles, defective tires, and driver's panicking when the tire went down. I do not know the answer to these questions and neither do you.

4. So in essence you are recommending that all consumers ignore the recommendation of the people who designed the car, the suspension, and chose the size tires to install. Spent countless hours testing these combinations and then came up with the best tire pressure for handling, ride, and mileage. They should not believe these engineers and take your advice. If people want to take your advice then that is their choice.

I still recommend airing your tires up to the recommended pressure listed in your owner's manual and on the driver's door post. That it my advice and the advice of almost any expert you care to read.

You gave your advice and I have given mine, so this question is now closed to any more discussion.

How do you reset the tire pressure sensor light on a 2008 Mazda tribute?

You can reset all systems by unpluging the battery coneections for a few minutes. I would suggest doing this any time you have an engine light or warning light come on as sensors are sensitive. If the light comes back on take it in for service.

Can rain cause your tire to go flat over night?

no, overnight rain will not cause your tires to go flat

How do you remove a flat tire on a 2002 Chevy Cavalier?

Make sure the vehicle is parked where you won't get hit working on it. Set the parking brake. Get out the jack and handle and the lug wrench. Remove the wheel cover (if there is one) with a screwdriver. It should just "pop off" the wheel. Before you jack the car up, put the lug wrench on the lug nuts (or lug bolts, if your car has them) and loosen them all a turn or two. Now put the jack under a "hardpoint" on the frame or chassis of the car. Your owners' manual will show you where they are. Jacking the vehicle up must be done from a place where the frame is strong enough to support the weight, and in a way that the jack won't tip over and "jump out" from under the car. It is important to use the jack correctly or the car my tip off its support and seriously injure you or someone else! Jack the car up til the flat tire clears the ground. Now use the lug wrench to finish removing the lug nuts. Loosening the lug nuts with the affected wheel off the ground may allow the wheel to turn. That's why you loosen those lug nuts before you jack the car up. Remove all the lug nuts and slide the wheel off the hub. You're done. To put a wheel back on, use the reverse process. You may have to jack the car up a bit more so the fully inflated tire will clear the ground and allow the wheel to go back on. And you'll have to snug the lug nuts up pretty well before you lower the vehicle to the ground. You can finish tightening them with the tire in contact with the pavement, but tighten all those lug nuts pretty well before lowering the jack. If the wheel is not all the way on the hub and you take it off the jack, there is a good chance the wheel won't get pulled up against the hub once the weight of the vehicle is on the wheel and tire again. Be safe, get help if you need it, and good luck.

Change a flat tire on a 2008 highlander?

The owners manual will have directions as to where the jack, tire and wrench are stored in the vehicle along with the correct place to put the jack so as not to damage the vehicle.

Car sounds like it has a flat tire?

Check it. If flat, replace. If not, keep driving till it does.

How do you know the correct tire pressure for your tires?

Tire Pressure

it will tell you your pressure in and around the door when you open it or on the inside of the fuel cap & also mansion in your service manual

What is the correct tire pressure for a 2007 Subaru Forester with original tires?

For most cars the correct info is in the owners manual, but also there should be a decal either on the glovebox door or the driverside doorjam. DO NOT READ IT OFF THE TIRE! That is wrong 99% of the time! The pressure indicated on the tire is the pressure required for the tire's MAXIMUM load rating. Most car do not load the tires anywhere near that weight. Also, a "radial" tire (most all are) when it is properly inflated, will bulge the sidewall next to the pavement. This is normal. Many people try to add air to make it go away. Not good, less traction and rougher ride.