0
Ford Expedition
The Ford Expedition is a five-door, full-size SUV manufactured and marketed by Ford Motor Company. Introduced in 1997 as a replacement to the Ford Bronco, Ford Expedition is the largest and the last variant of off-road, truck-based Ford SUV.
4,498 Questions
How do you put a drivers side window back in track on a ford expedition?
To put a driver's side window back on track on a Ford Expedition you will have to reseat the window. Do this by removing the door panel and putting the window back in place. You can use silicone or Gorilla glue to attach the window. Leave the window in the up position for at least one day once you have it back on place.
Do you turn the overdrive on or off when you are on the freeway?
off
--------------------------------------------------------------------------------------------
If you are not towing a trailer you would want the overdrive to be ON so
that your engine RPM is lower **( you will not see the O/D OFF light in your
dash ) **
Firing order for 1987 351 ford 150?
1 - 3 - 7 - 2 - 6 - 5 - 4 - 8
The distributor rotor turns COUNTERCLOCKWISE
The marked # 1 position on the distributor cap faces to the REAR and slightly towards the drivers side
The engine cylinders / spark plug locations are numbered :
firewall
4 - 8
3 - 7
2 - 6
1 - 5
front
Where is the number 8 cylinder on a 2000 ford expedition 5.4L?
firewall
4 - 8
3 - 7
2 - 6
1 - 5
front
In enzymology, the turnover number (also termed kcat) is defined as the maximum number of molecules of substrate that an enzyme can convert to product per catalytic site per unit of time and can be calculated as follows: kcat = Vmax/[E]T (see Michaelis-Menten kinetics).
Why is it hard to turn my steering wheel?
THE POWER STEERING PUMP IS LOW ON FLUID OR HAS GONE BAD ALLTOGETHER. This happened to my 2002 intrigue,and it was caused by failure of the rack and pinion steering, parts were obtained from NAPA PARTS,and replaced by dealer.
How do you remove the back seats from a 2004 cavalier?
Force the lower end of the bench seat back toward the trunk to release to clips at the bottom of seat and lift out--You will find either clips or screws at the lower end of the upper portion of seat--releasse these and lift upper section of seat should release from locking clips allowing removal of upper section
Force the lower end of the bench seat back toward the trunk to release to clips at the bottom of seat and lift out--You will find either clips or screws at the lower end of the upper portion of seat--releasse these and lift upper section of seat should release from locking clips allowing removal of upper section
I had to look at this question for a minute because you didn't say what year model we are working on or what engine size. But I guess we must have a 1996 or newer model, and we must be working on a 4.6 liter engine. If I am right about what we are working on, the bypass hose you have described, goes through a valley under the intake manifold, and exits at the rear of the engine, where it connects to a heater hose at the firewall. It is partly rubber hose and partly metal pipe, but it is made as one assembly. To access and replace, you must remove the intake manifold. After the intake manifold is moved out of the way you will see it clearly. At the back of the engine, on the right cylinder head, there are two bolts that hold it to the back of the head. There is also a bracket that is held to those bolts by two nuts that are screwed to threaded studs that are part of each bolt, so that you have to remaove the nuts, remve the bracket, then remove the studded bolts, and then remove the bypass hose/pipe assembly, all of this after you have removed the intake manifold.
What is cylinder order on 2002 ford Triton 4.6 v-8?
The firing order is ( 1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 )
firewall
4 - 8
3 - 7
2 - 6
1 - 5
front of vehicle
Where is the fusebox located in 2001 Expedition?
According to the 2001 Ford Expedition Owner Guide :
The fuse panel is below and to the left of the steering wheel , by the brake pedal ( it has a cover on it )
Also , the power distribution box ( which is " live " ) is located in the engine compartment , on the drivers side
Where is the scanner port on a 2002 expedition?
It under the driver side steering column vicinity. Right above the gas pedal area.
Firing order for a 1967 ford 6 cylinder?
The Ford straight 6 cylinder engine firing order is ( 1 - 5 - 3 - 6 - 2 - 4 )
The distributor rotor turns CLOCKWISE
How do you open a rear door when it is locked on a ford range?
If you could open the door when it was locked, there would be little point in locking it.
You'll need to unlock it first.
Some vehicles have rear doors that can only be opened from the OUTSIDE (when unlocked; when locked, they can't be opened from either side). This is to keep children from accidentally or mischevously opening the doors. Usually this behavior is controlled by a switch on the side of the door that can only be accessed when the door is open; if the child safety feature is on, the door can only be opened from outside, but if it's off, then the door works "normally."
Where is Ford 2010 expedition fuel shut off?
Behind an access panel in the cargo area , on the drivers side , by the liftgate
What is the firing order for a 1988 Ford E-l50 3.9 cylinder?
If you mean the 4.9 L ( 300 cubic inch ) straight 6 cylinder engine in a 1988 :
1 - 5 - 3 - 6 - 2 - 4
The distributor rotor turns CLOCKWISE
Where is the radio fuse located for ford expedition?
Check owner's manual.
If you don't have one copy and paste link below;
www.fleet.ford.com/maintenance/owners_manuals
How do you check the charging system on a Nissan?
If you have a DVOM, test for voltage at the positive battery cable at the battery, not testing at the battery but at the cable, when the engine is running. Now check for power at the battery post with the engine running, should be the same. Next test the battery when the engine is not running, key off, yes, this time testing for voltage at the battery post and cable, should be the same. If all four test voltages are the same, you have a charging system problem. The test at the battery cable when the engine is running should be aprox 13.5 to 14 volts at the cable. One thing to keep in mind, corrosion at the + battery cable can prevent the battery from charging and that's why the test for the charge system when the engine is running is best at the cable not the battery. If you have different readings when the engine is running at the cable and battery post, (the battery test results are the same when running and when not running, but the battery test at the cable is 13.5 to 14 volts) it is probably a corrosion problem. Clean the corrosion between the + battery cable until the voltages are the same at the cable and battery post. This is not a thorough test for the battery condition as you are only checking volts, not amps.
The cheapest way is to just take it to any Autozone , or similar parts stores ! They have the equipment on hand , AND they check it for FREE ! They will be able to tell you if you have a bad battery or faulty alternator . Most of these places are honest and tell you what if anything you nedd to replace . I thought I had a bad alternator a while back . Took it in and tested it . The battery had a bad cell in it .
So no need to buy the fancy equipment . Hope that helps !
How do you remove rotors on 98 Ford Expedition?
I had to use a grinder and cut two sets off. I used the edge of the grinder and scord a line across the face (entier with) almost all the way through the slammed with heavy hammer till it broke loose.
How are the coil packs numbered on the 1997 ford expedition 5.4?
The coil packs are located in the same order of the firing order.
Firing Orders; (4.6L - 5.4L)
(Firing Order: 1-3-7-2-6-5-4-8)
(Distributorless ignition system)
************* Firewall ************
(Passenger Side) 4 * 8 (Drivers Side)
(Passenger Side) 3 * 7 (Drivers Side)
(Passenger Side) 2 * 6 (Drivers Side)
(Passenger Side) 1 * 5 (Drivers Side)
************* Radiator ************
