Ford Thunderbird

There is a heat-sink resistor (has fins), approximatily 2" square under the dash just to the right of the steering column. It drops the voltage to 8 volts. People like to cut the wires to this device to disable the running lights. It is rare for this device to fail.

BUY A CHEBBY??? LOL either your clutch is slipping or the transmission is slipping. IF it is an auto, check the fluid.

could be a clogged catalytic converter

clogged fuel filter/pump?

I had the same problem with my 94 Thunderbird LX 4.6L(V8). You are going to need to replace your EGR valve. The EGR valve is blocked therefore the car cannot breath. The EGR valve price is pretty fair, if you go to an auto parts store. The valve ran me about $40. Now if you are going to put it on yourself you need 24 or 26 in. wenrch to get around the pipe it is counnected to.

yes

Here's a site that will explain everything you need to know about airbag lights and resetting the system. http://www.airbagsolutions.com/ This website gives you the procedure for diagnosing and resetting airbag lights. See if your car is listed here. http://www.airbagsolutions.com/vehicles_list.aspx On most vehicles, the airbag light should come on for @6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. The flashing light on your car is telling the answer you need. On some vehicles, the light is flashing a two digit code. Once you know the code, you can most likely repair it yourself. There are fairly easy procedures that most people are capable of repairing. Airbagsolutions.com has the fault code charts to tell you what is wrong and how to fix it!

Some vehicle manufacturers accommodate systems without a scanner (like Toyota, Lexus, Nissan, Infinity, Honda, Acura, Ford, Lincoln, Mazda & Mercury) and some require a scan tool. Check out these websites also for more info on airbag systems and the light. http://blog.airbagsolutions.com/archive/2007/11/18/why-is-my-airbag-light-on.what-should-i-do.aspx http://www.airbagsolutions.com/resources.aspx http://blog.airbagsolutions.com/ Also, you may want to check out this site for information on researching your own vehicle for factory recalls!!! http://www.airbagsolutions.com/nhtsa.aspx

It could be a worn ball joint, worn out frount bearings. No mater what it is, have it inspected by a mechantic. I didn't and had a ball joint break and lost a wheel. As luck would have it I was in my driveway at the time.

Supercharger oil for a 1993 Ford Thunderbird can be found at auto parts stores that sell racing performance parts. Usually, a 50 wt. oil will work for this type of engine.

Inside the right side kick panel. Inside the car look down at the passenger side floor and to the right there is a plastic molded piece bolted to the side and holding the carpet down. Carefully remove the molding and the computer is right there..

If your engine is running , and the battery light comes on , that indicates that your battery is not being charged

In the trunk next to the spare tire

you have to remove the intake manifold it is located in the very back of the engine.fuel injectors and all

This job is a real pain! Start by removing the lower dash trim from the driver and passenger side. All this is much easier if you remove the passenger seat. Remove the stainless trim, the aluminum trim and finally the passenger dashboard access plate, You will need the remove the vent control cable to get this out of yor way. Now remove the heater access panel...you should now be able to see the core. disconnect the heater hoses and the 3 nuts from the engine firewall that hold the heater unit in place from the engine side. aAt the passenger side, gently pull the unit towards you to access the 4 heater core bolts. remove these and the valve cable and the core should come right out.

yes they do, driver and passenger airbags

Click on the link below Click on Owner Guides The owners manual ( which includes the fuse box diagram ) can be viewed on-line

According to my Chilton's Auto Repair manual :

For a 1991 Ford Thunderbird , 3.8 liter V6 engine ( supercharged and non S/C )

With engine oil filter change :

( 5.0 U.S. quarts )

How do you remove calipers from a 1987 thunderbird? Like where do I start?

The 1957 Ford Thunderbird is one of the most prized cars out there. Yes, it was used during the show 77 Sunset Strip.

Remove the red reflector made of plastic from the bottom left of the inside door panel and remove the one screw inside the housing. Now pull the door panel up and out at the same time. Remove the ground strap screw from the door behind the inside door panel near the front of door. Remove the left side window track on the door handle side, only 1 bolt holding it in located at the bottom left of the door. Push it downward and it unclips from the top track . Also remove the inside rubber lower window trim from the window frame. This needs to be done to access the door handle rod and see where the left side window track clips back in at the top.

You will now need to drill out the original door handle rivets with a drill bit. Do not drill out any larger than the size of the replacement bolts to be reinstalled in the new handle. You do not have to remove the key lock, the handle slips right over it.

Now remove the actuating rod from the bottom plactic connector, connected to the door lock by opening the connector . It just snaps open. Now you can remove the rod from the door handle itself. Install the new door handle with new sloted flathead or panhead bolts no bigger than 1/4 in" round 3/4 in" long to clear window track and window Glass. insert the rod back into hoor handle and clip it back into the plastic clip just as it was before you removed it. reinstall the door window track. So you can see what you are doing to connect it if your having a hard time dont forget to remove the rubber strip molding from the top of the door, where the bottom of the window is when it is closed. You can then see where the top of the track clips back in. Peplace door panel with caution. make sure all wires are out of the way, reconnect ground strap and that all the clips line up that hold the door panel on . reinstall the screw at the bottom where the reflector is.

michaelgenzano@msn.com

It is located inside the tank. You access it through the top of the tank. Someeimes you can get to it by removeing the rear seat and removing the large grommet or cover. It is held in by 4 or 6 screws or so. Remove the fuel lines and connetors and unscrew the screws and pull it out. Hope this helps.

I think sakshi tanvar is 39 year's old.

What is the wiring diagram for the car stereo on a 1997

Ford thunder bird

should be a witch hidden under the driver side dash near the fuse box it would be tiny like the size of the tip of your pinky finger

Remove the vent panel located at the base of the windshield. Locate the motor. Replace. Be sure and realign the wipers to specification ... or else, one or both would be offline.

locate the bleeder valve in the manifold. 1 guy turn on ign, then 2nd person bleeds air from the valve.... on the fuel rail.

Reach behind the light assembly and unplug the connector, using a screwdriver to hold the clip out of the way. Turn counter-clockwise to remove the assembly. Push in and counter-clockwise to remove the bulb. Installation is opposite. From my HAYNES manual.

yes they are the same transmission, just change the mount