0
Ford Thunderbird
Also known as the T-Bird, the Ford Thunderbird was a personal luxury car produced by Ford Motor Company from 1955-2005. This vehicle was manufactured in 11 generation models, which made it one of the longest-staying product lines of the company.
1,792 Questions
Where is the coolant temperature sensor located on a 1992 Ford Thunderbird?
on the thermostat housing
How do you replace the water pump on a 1993 Ford Thunderbird LX non-supercharged?
Disconnect the battery Drain the cooling system Remove the fan and clutch assembly from the water pump. You will need to get a fan clutch holding tool and a Fan Clutch Nut Wrench. Ford T84T-6312-C - Fan Clutch Holding Tool - Global Tool# 303-239 - OTC tool# 7204E1 Ford T84T-6312-D - Fan Clutch Nut Wrench - Global Tool# 303-240 - OTC Tool# 7204E2 After loosening the fan and clutch assembly from the water pump using the two tools listed above position the fan and clutch asembly in the fan shroud. THEN remove the fan shroud (which has the fan/clutch assembly in it) Loosen the water pump pully bolts Remove the drive belt by rotating the tensioner away from the belt by using pully retaining bolts only. (Do not pry on belt tensioner!) Remove the water pump pulley Disconnect the lower radiator hose, heater hose andwater pump bypass hose at the water pump. Unfasten the bolts that attach the pump to the cylinder front cover. Remove the pump and gasket.
Where is the sensor that turns the automatic headlights on for 1993 Seville?
top of dash r/s speaker grille
Some say they have spotted giant back birds with hooked beaks. They are claimed to be bigger than man and carnivorous. Huffer, a man who lived in Illinois, says he has been carried up by one of these birds known as the "thunderbird."
Where do i find a 1986 Thunderbird graphic dash cluster?
where do i find a graphic dash cluster for a 1986 ford thunderbird
Why would an 87 Ford Thunderbird V6 keep dying when put in gear?
check all vacuum hoses under hood, replace any old or broken ones, you may have a vacuum leak. This may lead to engine not being able to hold idle when in gear.
When was the Ford Thunderbird first made?
The first Thunderbird was produced in 1955. It was a 2 seat roadster and is commonly called the baby bird. It was produced in 2 seat form from 1955-1957. In 1958 it became a 4 seat vehicle that was much larger.
What is the correct spark plug gap for a 1997 ford thunderbird with 4.6l engine?
.054 inch ( according to motorcraft . com )
What keeps draining my ford 90 thunderbird battery?
Anything can do it. If you leave your radio on when your waiting on someone, or many people have problems with their door hinges on the 90's thunderbirds so this prevents the doors from closing all the way. Mine used to do it all the time. I had to change the hinges and the clips on the inside of the door panels.
Replacing speedometer cable on a 1964 Thunderbird?
Drive as fast as you can and ignore the flashing lights behind you!
How do you remove the egr valve on a1995 Ford Thunderbird?
I have a 94 T Bird with the 4.6 V-8 which I am attempting to replace the EGR valve. The EGR valve is extremely difficult to get to, its located to the right rear corner of the intake just inboard and to the rear of the right valve cover, I am still in the middle of trying to remove my EGR. So far from what I done is to try to agin access to the EGR, I removed a coolant hose that connects to the back of the engine to gain access, there's a couple of rubber hoses and lines that are blocking access, the unit is very unaccesible, there's a metal exhaust line that is screwed into to the back of the EGR valve with what appears to be a 22 or 23 mm nut, from there the EGR valve is mounted to the back of the engine with two small bolts and there's also a gasket which seals the EGR unit to the engine ,like I said I'm still struggling to gain access to my unit, the biggest problem is the tight area between the firewall and the engine where the EGR is mounted. On top of that there's a bunch of obstructions, hoses engine pieces ect, the key is to remove as much stuff around the EGR as possible to gain access. Good luck, I'm about ready to give up on mine and take it to a repair shop, hopefully you fair better than me.
Mike
-- joker_102877 --
Disconnect the negative battery terminal. Disconnect the wiring connectors to the air cleaner, Mass Air Flow sensor, EGR vacuum solenoid, and DPFE sensor. Remove the air intake assembly (up to the throttle body). There are two vacuum lines from the EGR vacuum solenoid, find where they reach the EGR valve and the intake manifold, disconnect them at these points. There is a rubber hose coming from the firewall to the top of the engine, disconnect this and push it aside. Remove the nut directly below this hose (this nut holds the bracket that the DPFE and EGR vacuum solenoid are mounted to). Follow the mounting bracket around and remove the smaller nut holding it on. Have some tape ready to mark two hoses. Make a note of which hose is the "Hi" and "Ref" on the DPFE sensor and remove them. Remove the DPFE/EGR vacuum solenoid assembly. Congratulations, now you have access to the EGR valve!!
Slide the heat protective sheath back on the EGR tube (you need to see the tube, to make sure you are not turning the tube itself!!) The EGR tube and EGR valve will likely be rusted very badly. Spray some PB Blaster at the EGR valve/EGR tube connection, and between the nut on the EGR tube and the tube itself (the nut is supposed to be able to move independently of the tube). Attempt to loosen the nut. If you manage to break it free, ensure you are not turning the tube itself and crimping it. If you can't turn it, use a blow torch and concentrate the flame on the fitting on the EGR valve side (heating metal expands, and could loosen it enough to break it free). Once the EGR tube is disconnected, remove the EGR valve mounting bolts (2). Installation is the reverse of removal.
-- joker_102877 --
Where is the 50 amp circuit breaker located in my 1962 thunderbird convertible?
There are two places that Ford placed the 50 amp breaker on the Thunderbird convertible. First and most common is under the front radiator support just left of center,between the horns. Second is next to the Starter Solenoid on the outside radiator support.
Where is the fuel filter on a 1992 Ford Thunderbird?
on the drivers side middle of car about half way point
What is the recommended spark plug for a 1984 Thunderbird 302 V8?
The recommended spark plug, for a 1984. Thunderbird 302, V8 engine, is a champion spark plug. The spark plugs can be purchased at most auto-parts stores.
Where is the PVC valve located on a 1996 thunderbird with a 4.6l engine.?
It is located under the duct that feeds clean air from the air filter box to the throttle body. This is on the passenger side.
Where is the obd1 port on a 1995 Thunderbird?
There should be an " EEC TEST " connection in your engine compartment , near the battery / power distribution box
How do you remove the headlight switch on a 1978 Ford Thunderbird?
Reach under the dash and you will feel a button that you push in on the switch itself. Then you can just pull it out from behind.
How much oil does a 1997 Ford Thunderbird take?
The 4.6 liter Thunderbird engine requires 5 quarts of engine oil per oil change.
The oil filter can be removed from the top side of the engine by removing the dipstick, sliding the radiator relief hose up with the clip still on from the fuse cover, then sliding the fuse cover up by about a half inch.
The reach down from the top unscrew the oil filter and turn it gasket side up. Place thumb or index finger into the threaded hole and slowly slide the filter up between the engine manifold and the fender well. Turn the filter and tip it slightly when it catches on the oil dip stick tube.
Reverse the above procedure when installing the new filter.
How do you manually lower the top on a 1965 thunderbird convertible?
The top is hydraulic and there is no override...unfortunately the answer is "you can't." however, in the shop manual a full schematic of the top ssytem is shown, so if you need to troubleshoot a bad relay or motor the shop manual has the info you need.
What does a 5-1 flash code mean for a ford thunderbird airbag system?
Code 51 means:Coolant temperature sensor circuit open
It could be your C-V joints, If so you should get it fixed before the problem escalates This is incorrect. All Thunderbirds are rear wheel drive therefore will not have CV joints on the front. It sounds like you need ball joint/bushings replaced.
How do you roll up passenger window in 1997 Camaro with a faulty power lock switch?
The lock switch has nothing to do with the window. If you have power windows and the window switch is bad, you can operate the window by jumping the wires on the switch plug. On my 91 Camaro RS, the window regulator (motor) stopped working. I bought a new regulator at Napa and replaced it. Replacing the window regulator requires drilling out the factory rivets. IMPORTANT! Before you start,you should drill a hole through the door and gear then install a temporary nut & bolt to lock the window in the up postion. This will prevent the window from falling while your fingers are near the gear.
What is the oil capacity for 1988 thunderbird 3.8 liter?
I just personally changed my oil the other day. It took five liters. That's for the base model, anyway.
Where is the crankshaft sensor on a 1995 Ford Thunderbird?
the crankshaft sensor for 1995 ford thunderbird is located behind the powerstreeing reservior. you have to unscrew the power streeing reservior and gently move it to the side with out causing damage to the hoses. below the vavle cover you should see it. it should take about 20 to 30 mins. to replace. take your time! i hope that these information is helpful.
