0
Geo Metro
The Geo Metro was a small economy car produced between 1989 and 2001. The first generation model was available as 3-door and 5-door hatchback, as well as 4-door notchback sedan. It came in three trim levels: XFi, Base and LSi.
1,033 Questions
How do you fix a 1999 Metro LSI heater and AC fan that only works on high?
The blower fans on these cars run very quietly on all but the maximum setting- ensure that the fan is really not working first by holding your hand in front of the vent with the fan on low and checking that is it not moving any air. Replace the resistor pack.
How toTurn off check engine light forever?
unless you fix the problem, the light won't go out forever. however, you can pull the bulb that goes to the check engine light (then it can't come on).
How do you change the crank seal on a 1997 Metro 4-cylinder?
First you have to loosen the front wheel on the passenger side of the car. Then you jack it up, put it on jack stand and remove the wheel. Next, you have to remove the plastic shield from the wheel well. After you do this, you have to remove the crank pulley, and timing cover from the car. Next you remove the timing belt and they you'll have access to the crank seal. Not really too bad of a job. Just be careful removing the seal making sure you don't nick the crank. You can take a small drill bit and drill a hole at 3:00 and 9:00 position and screw in a couple of sheet metal screws. Then, take a pair of vise grips and in an alternating pattern, pull on each side until it comes out. If you decide to use a small screw driver to pry it out instead, cover the tip with duct tape to make sure you don't scratch that crank. After you get it out, put a light coat of oil on the outside of the new seal and use a large deep well socket the same size of the seal to GENTLY tap it back in. This job took me about two hours to do. Since it appears you've never done it before and you don't want to rush it, plan on five or six.
What are the timing marks and how are they lined up on a 1994 Geo Metro 3 cylinder?
on the balencer there is a timing mark and om the motor theres a tab
there is also a mark on the cam gear, when lined up, both marks on the crank gear and cam gear point up.
Where is the fuse for a 1989 Geo Metro headlights?
The manual says they are in the fuse block, on the left side of the dash, on the top upper left of the fuse block. mombetty8@yahoo.com
How do you replace a water pump on a 1992 Geo Tracker?
You really need a manual for the car to do this repair - there are alot of parts that must be removed in order to replace the pump which is fairly easy once you get there. You must aslo torque all bolts and nuts to specified values.
Why is my air conditioner on a 95 geo metro leaking in the passenger floor?
there is a condensate drain tube in the bottom of the heater core cover/housing that is plugged or maybe the hose is off and doesn't drain outside the car.
Squealing noise in wheel when turning?
A Geo Metro is a front wheel drive vehicle. When a squealing noise occurs when the wheel is turning, it can be an indication of damage to the CV joints.
Ouch, tough one. You might be able to have a machine shop drill and tap a hole that would let you screw a pipe in to hook up a tube. It would depend on what is directly behind that hole in the engine. Consult a machine shop or mechanic.
Where is the engine computer located on a 1995 Geo Metro?
The '93 is under the dash, hidden above the fuse box, by the driver's left foot.
What kind of trans fluid do you use in a 1994 Geo Metro?
1996 metro calls for dextron 2, should tell you on your transmission dip stick
How much transmission fluid is needed for a 1997 geo metro lsi 4 cylinder?
if you drain it it'll only take about 4 qts
Where is the engine coolant drain plug on a 98 expedition?
The engine coolant drain plug, on a 1998 Ford expedition, is located on the bottom of the radiator. The drain plug will come out by turning to the left.
How long do Geo Metro timing belts last?
Phone parts store ask for warranty length, depends on brand and mileage use.
it should be changed every 60,000 miles
How do you replace the Clutch bearing in a 92 Geo Metro?
Unfortunately, you have to remove the transmission.
Where is the starter located on 1991 Geo metro?
On the fire wall side of the motor,bolted to the bell housing of the transmission. If you take it off, be sure to disconnect the battery and take the wires off the solenoid. There are two bolts to unhook it from the bell housing. Mr Geo Metro leehduncan@verizon.net
Will a transmission from a 1991 Geo Metro fit into a 1998 Geo Metro?
No, a 91 metro transmission will not fit in a 98. A 91 will fit any metro between 1988 - 1996 though. After 1996 a lot of Metro's became 4 Cylinder which made them different from the previous generation metros. It may fit if the engine sizes are correct (1.0 litre 3 cylinder to the same but do not mix and match).
How do you replace power steering fluid 95 Geo Metro?
To replace power steering fluid on a 95 Geo Metro, open the hood. There is a large yellow knob labeled with powering steering fluid only. Drain the old power steering fluid and place new fluid.
Pictures of the engine on a 1991 Geo Metro?
Consult your public library for the Chilton series of auto repair books, your year and model. They may also have an online database by Chilton giving instructions on certain tasks.
the ignition switch has the lock cylinder on it. It's @200 bucks form Advance auto. Should be pretty straightforward to change out. Some switches have rivets that get drilled out or chipped off(very soft metal) in order to change the switch and the new one will have new bolts included. Or it simply unbolts or unscrews out after removing the steering wheel bezel assy.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
What is the fastest 1.0 liter powered car?
I don't know what would be the top speed but I made 84m/h with 993cc 3cyl Geo Metro. GPS verified. Hope this helps.
Why would the daytime running lights on a 1995 Geo Metro cause the regular lights not to work?
The only way I know of that this could happen is if the lights have a bad ground.
Answeri am having the same problem and seams like my daytime running lights "controll module" is bad. its located under steering colume and has a 11 wire plug to it. . AnswerThere is a relay(#2) and a diode module in the relay box under the hood you can check. This is independent of the DRL circuit, so you could have DRL but no regular lights. If your DRL module is bad, you should still have high beams. That circuit doesn't go through the module. This is what happened to my 95, and what I did to fix it. Had intermittent lights and eventually no lights at all. Look at your fuse block. One of the two farthest corners has a connector with six wires. These wires come from the switch on the steering column. See if one of the wires looks burnt and/or if you can wiggle them and make the lights work. If you have that, then this wire is burning out of the connector and you need to try to fix this before you lose the DRL too. The terminal in my fuse block was damaged beyond repair, but the cicuit also led to an unused terminal in a three terminal connector beside the row of spare fuses. I put the appropriate sized spade terminal on the end of the burned-out wire and it was just long enough to reach over there and plug right in. I'm assuming it burned out from being loose and excessive resistance, maybe from being next to the clutch pedal. I've had no problem since the repair. Need more help try http://autos.groups.yahoo.com/group/MetroSwift/- Super Bonus* When your Metro stops firing, check the ground on the igniter (middle terminal).
